Engineering Papers⌕ Search

Engineering topics

Hassan, H. A.

Publications and source records attributed to Hassan, H. A..

At least 55 records · Page 3

A new two-temperature dissociation model for reacting flows

A new two-temperature dissociation model for flows undergoing compression is derived from kinetic theory. The model minimizes uncertainties associated with the two-temperature model of Park. The effects of the model on AOTV type flowfields are examined and compared with the Park model. Calculations are carried out for flows with and without ionization. When considering flows with ionization, a four temperature model is employed. For Fire II conditions, the assumption of equilibrium between the vibrational and electron-electronic temperatures is somewhat poor. A similar statement holds for the translational and rotational temperatures. These trends are consistent with results obtained using the direct simulation Monte Carlo method.

Olynick, David R.↗

An assumed joint-Beta PDF approach for supersonic turbulent combustion

In a recent experiment, Cheng et al. (1991) used ultraviolet spontaneous vibrational Raman scattering and laser-induced predissociative fluorescence techniques for simultaneous measurements of temperature and concentrations of O2, H2, H2O, OH, and N2 (and their rms) in supersonic turbulent reacting shear layers. Because present computational techniques are not suited for prediction of all of the above measurements, a new approach has been developed and is being used to predict all relevant flow properties and their rms (where appropriate). The approach explores the use of a joint-Beta PDF for concentrations. It was found that the general expression of this PDF was impractical because of decoding problems resulting from determining the various parameters of the PDF. Thus, a special case of this general expression was considered. Calculations using this simplified version of the joint-Beta PDF were not consistent with the available data from the experiment.

Baurle, R. A.↗

Radiation transport around axisymmetric blunt body vehicles using a modified differential approximation

A moment method for computing 3D radiative transport in axisymmetric thermochemical nonequilibrium flows is developed. The method uses the P-1 approximation to reduce the governing system of integro-differential equations to a coupled set of partial differential equations. The numerical solution of these equations for realistic variations of the radiation properties is discussed. Representative results from the method are shown and compared to tangent slab calculations. The agreement between the transport methods is found to be about 10 percent in the stagnation region, with the difference increasing along the flank of the vehicle.

Hartung, Lin C.↗

An assumed pdf approach for the calculation of supersonic mixing layers

In an effort to predict the effect that turbulent mixing has on the extent of combustion, a one-equation turbulence model is added to an existing Navier-Stokes solver with finite-rate chemistry. To average the chemical-source terms appearing in the species-continuity equations, an assumed pdf approach is also used. This code was used to analyze the mixing and combustion caused by the mixing layer formed by supersonic coaxial H2-air streams. The chemistry model employed allows for the formation of H2O2 and HO2. Comparisons are made with recent measurements using laser Raman diagnostics. Comparisons include temperature and its rms, and concentrations of H2, O2, N2, H2O, and OH. In general, good agreement with experiment was noted.

Baurle, R. A.↗

Monte Carlo simulation of reentry flows with ionization

The Direct Simulation Monte Carlo method is applied to a rarefied, weakly ionized, hypersonic flow over a blunt axisymmetric body. An ionization model based on the concept of ambipolar diffusion is used and a model for the sheath is presented. The effects of the new modeling techniques are investigated for flow over the Project Fire II configuration at 11.37 km/s at an altitude of 84.6 km. The calculated results are presented and compared with both experimental data and solutions where ionization effects were not included. In general, the calculated results overpredict the experimental values by about 15-20 percent.

Taylor, Jeff C.↗

Monte Carlo simulation of entry in the Martian atmosphere

The Direct Simulation Monte Carlo method of Bird is used to investigate the characteristics of low density hypersonic flowfields for typical aerobrakes during Martian atmospheric entry. The method allows for both thermal and chemical nonequilibrium. Results are presented for a sixty-degree spherically blunt cone for various nose radii and altitudes.

Hash, David B.↗

A new approach for the calculation of transitional flows

In spite of many attempts at modeling natural transition, it has not been possible to predict the streamwise intensities. A procedure is developed which incorporates some results of linear stability theory into one-equation and stress model formulations. The stresses resulting from fluctuations in the transitional region have turbulent, laminar (nonturbulent) and large eddy components. Comparison with Schubauer and Klebanoff's experiments have shown that the nonturbulent and large eddy components have a large influence on the streamwise intensities and little influence on the shear stress. Finally, predictions of the one-equation model were as good as those obtained by the stress model.

Young, T. W.↗

A k-omega-multivariate beta PDF for supersonic combustion

In an attempt to study the interaction between combustion and turbulence in supersonic flows, an assumed PDF has been employed. This makes it possible to calculate the time average of the chemical source terms that appear in the species conservation equations. In order to determine the averages indicated in an equation, two transport equations, one for the temperature (enthalpy) variance and one for Q, are required. Model equations are formulated for such quantities. The turbulent time scale controls the evolution. An algebraic model similar to that used by Eklund et al was used in an attempt to predict the recent measurements of Cheng et al. Predictions were satisfactory before ignition but were less satisfactory after ignition. One of the reasons for this behavior is the inadequacy of the algebraic turbulence model employed. Because of this, the objective of this work is to develop a k-omega model to remedy the situation.

Alexopoulos, G. A.↗

Radiation Transport Around Axisymmetric Blunt Body Vehicles Using a Modified Differential Approximation

A moment method for computing 3-D radiative transport is applied to axisymmetric flows in thermochemical nonequilibrium. Such flows are representative of proposed aerobrake missions. The method uses the P-1 approximation to reduce the governing system of integro-di erential equations to a coupled set of partial di erential equations. A numerical solution method for these equations given actual variations of the radiation properties in thermochemical nonequilibrium blunt body flows is developed. Initial results from the method are shown and compared to tangent slab calculations. The agreement between the transport methods is found to be about 10 percent in the stagnation region, with the difference increasing along the flank of the vehicle.

Hartung, Lin C.↗

Monte Carlo simulation of nonequilibrium shock fronts

A direct simulation of a shock-tube experiment carried by AVCO (pressure of 1 Torr and velocity of 6.4 km/sec), repeated by Sharma and Gillespie (1990), and used by Park (1988) to develop his two-temperature model, is presented. Results show that the electronic ground state of N2 is not in rotational nor vibrational equilibrium with that of N2(+). Moreover, a two-temperature model is inadequate to describe nonequilibrium flows behind shocks. The role of impurities is examined. It is shown that the effects of a small fraction of H2O are insignificant. Good agreement with the measurements of Sharma and Gillespie is indicated.

Olynick, David P.↗

Radiation modeling with direct simulation Monte Carlo

Improvements in the modeling of radiation in low density shock waves with direct simulation Monte Carlo (DSMC) are the subject of this study. A new scheme to determine the relaxation collision numbers for excitation of electronic states is proposed. This scheme attempts to move the DSMC programs toward a more detailed modeling of the physics and more reliance on available experimental data. The new method is compared with the current modeling technique and both techniques are compared with available data. The differences in the results are evaluated. The test case is based on an AVCO-Everett shock tube experiment, a 10-km/s standing shock wave in air at 0.1 Torr. The new method agrees with the available data as well as the results from the earlier scheme and is more easily extrapolated to different flow conditions.

Carlson, Ann B.↗

Use of finite volume schemes for transition simulation

The use of finite-volume methods in the study of spatially and temporally evolving transitional flows over a flat plate is investigated. Schemes are developed with both central and upwind differencing. The compressible Navier-Stokes equations are solved with a Runge-Kutta time stepping scheme. Disturbances are determined using linear theory and superimposed at the inflow boundary. Time accurate integration is then used to allow temporal and spatial disturbance evolution. Characteristic-based boundary conditions are employed. The requirements of using finite-volume algorithms are studied in detail. Special emphasis is placed on difference schemes, grid resolution, and disturbance amplitudes. Moreover, comparisons are made with linear theory for small amplitude disturbances. Both subsonic and supersonic flows are considered, and it is shown that the locations of branch 1 and branch 2 of the neutral stability curve are well predicted, given sufficient resolution.

Fenno, Charles C., Jr.↗

Direct Simulation Monte Carlo with ionization and radiation

The Direct Simulation Monte Carlo (DSMC) method is applied to a 10 km/s flow at 0.1 torr. The assumptions used to model plasmas and electronic excitation with DSMC are investigated and new models for these processes are proposed. The results from the new modeling techniques are compared with results obtained using the previous models and the significant differences are discussed.

Carlson, Ann B.↗

Modeling of turbulent supersonic H2-air combustion with an improved joint beta PDF

Attempts at modeling recent experiments of Cheng et al. indicated that discrepancies between theory and experiment can be a result of the form of assumed probability density function (PDF) and/or the turbulence model employed. Improvements in both the form of the assumed PDF and the turbulence model are presented. The results are again used to compare with measurements. Initial comparisons are encouraging.

Baurle, R. A.↗

Radiation Modeling with Direct Simulation Monte Carlo

Improvements in the modeling of radiation in low density shock waves with direct simulation Monte Carlo (DSMC) are the subject of this study. A new scheme to determine the relaxation collision numbers for excitation of electronic states is proposed. This scheme attempts to move the DSMC programs toward a more detailed modeling of the physics and more reliance on available rate data. The new method is compared with the current modeling technique and both techniques are compared with available experimental data. The differences in the results are evaluated. The test case is based on experimental measurements from the AVCO-Everett Research Laboratory electric arc-driven shock tube of a normal shock wave in air at 10 km/s and .1 Torr. The new method agrees with the available data as well as the results from the earlier scheme and is more easily extrapolated to di erent ow conditions.

Carlson, Ann B.↗