Hale, A. L. | Engineering Papers

NASA NTRS1989

Concurrent processing simulation of the space station

The development of a new capability for the time-domain simulation of multibody dynamic systems and its application to the study of a large angle rotational maneuvers of the Space Station is described. The effort was divided into three sequential tasks, which required significant advancements of the state-of-the art to accomplish. These were: (1) the development of an explicit mathematical model via symbol manipulation of a flexible, multibody dynamic system; (2) the development of a methodology for balancing the computational load of an explicit mathematical model for concurrent processing; and (3) the implementation and successful simulation of the above on a prototype Custom Architectured Parallel Processing System (CAPPS) containing eight processors. The throughput rate achieved by the CAPPS operating at only 70 percent efficiency, was 3.9 times greater than that obtained sequentially by the IBM 3090 supercomputer simulating the same problem. More significantly, analysis of the results leads to the conclusion that the relative cost effectiveness of concurrent vs. sequential digital computation will grow substantially as the computational load is increased. This is a welcomed development in an era when very complex and cumbersome mathematical models of large space vehicles must be used as substitutes for full scale testing which has become impractical.

Gluck, R.↗

NASA NTRS1985

Characteristic Elastic Systems of Time-Limited Optimal Maneuvers

Optimizing an elastic system and its active control is discussed. Maneuvers from an initial state to a final state in a finite time interval are considered. An active generalized control force that accomplishes the desired maneuver of a prespecified system is optimal if it minimizes a given quadratic cost function. By also varying a set of design parameters, the elastic system can be determined so as to further minimize the cost function. Here, the elastic system that minimizes the actual control cost is compared with the system that minimizes the ratio of actual cost to the cost of optimally maneuvering a rigid system of the same inertial properties. It is shown that an elastic system corresponding to an extremum of the ratio is actually a characteristic of the time-limited maneuver. Because both the spatial domain and the time interval are fixed, a characteristic elastic system is tuned to the specified temporal boundary conditions. The implication for rest-to-rest, spinup, and spin reversal maneuvers of spacecraft is that the optimal control for a characteristic elastic spacecraft is identical to the optimal control for the same spacecraft as if it were rigid.

Hale, A. L.↗

NASA NTRS1978

Derivation of the equations of motion for complex structures by symbolic manipulation

This paper outlines a computer program especially tailored to the task of deriving explicit equations of motion for structures with point-connected substructures. The special purpose program is written in FORTRAN and is designed for performing the specific algebraic operations encountered in the derivation of explicit equations of motion. The derivation is by the Lagrangian approach. Using an orderly kinematical procedure and a discretization and/or truncation scheme, it is possible to write the kinetic and potential energy of each substructure in a compact vector-matrix form. Then, if each element of the matrices and vectors encountered in the kinetic and potential energy is a known algebraic expression, the computer program performs the necessary operations to evaluate the kinetic and potential energy of the system explicitly. Lagrange's equations for small motions about equilibrium can be deduced directly from the explicit form of the system kinetic and potential energy.

Hale, A. L.↗

NASA NTRS1978

Structural Dynamics, Stability, and Control of Helicopters

The dynamic synthesis of gyroscopic structures consisting of point-connected substructures is investigated. The objective is to develop a mathematical model capable of an adequate simulation of the modal characteristics of a helicopter using a minimum number of degrees of freedom. The basic approach is to regard the helicopter structure as an assemblage of flexible substructures. The variational equations for the perturbed motion about certain equilibrium solutions are derived. The discretized variational equations can be conveniently exhibited in matrix form, and a great deal of information about the system modal characteristics can be extracted from the coefficient matrices. The derivation of the variational equations requires a monumental amount of algebraic operations. To automate this task a symbolic manipulation program on a digital computer is developed.

Meirovitch, L.↗

NASA NTRS1978

Synthesis and dynamic characteristics of large structures with rotating substructures

The variational equations of motion of large structures with rotating substructures are derived by the substructure synthesis approach, whereby a discretization procedure akin to the Rayleigh-Ritz method is used to represent the elastic motion of every substructure by a suitable set of admissible functions. Using an inclusion principle for gyroscopic systems, the effects on the predicted system dynamic characteristics of truncating the number of admissible functions used for each substructure can be assessed. Criteria for rational selection of admissible functions are presented.

Meirovitch, L.↗

NASA NTRS1977

A special purpose symbolic manipulation program for the derivation of the equations of motion for large flexible structures

This paper outlines a computer program especially tailored to the task of deriving explicit equations of motion for structures with point-connected substructures. The special purpose program is written in FORTRAN and is designed for performing the specific algebraic operations encountered in the derivation of explicit equations of motion. The derivation is by the Lagrangian approach. Using an orderly kinematical procedure and a discretization and/or truncation scheme, it is possible to write the kinetic and potential energy of each substructure in a compact vector-matrix form. Then, if each element of the matrices and vectors encountered in the kinetic and potential energy is a known algebraic expression, the computer program performs the necessary operations to evaluate the kinetic and potential energy of the system explicitly. Lagrange's equations for small motions about equilibrium can be deduced directly from the explicit form of the system kinetic and potential energy.

Hale, A. L.↗

NASA NTRS1977

A Rayleigh-Ritz approach to the synthesis of large gyroscopic structures

The equations of motion for large structures with rotating flexible components are derived by regarding the structure as an assemblage of substructures. Based on a stationarity principle for rotating structures, it is shown that each continuous or discrete substructure can be simulated by a suitable set of admissible functions or admissible vectors. This substructure synthesis approach provides a rational basis for truncating the number of degrees of freedom both of each substructure and of the assembled structure.

Meirovitch, L.↗

NASA NTRS1976

Structural dynamics, stability, and control of helicopters

The dynamic synthesis of a helicopter is reported. The method of approach is a variation of the component mode synthesis in the sense that it regards the aircraft as an assemblage of interconnected substructures. The equations of motion are derived in general form by means of the Lagrangian formulation in conjunction with an orderly kinematical procedure that takes into account the superposition of motion of various substructures, thus circumventing constraint problems.

Meirovitch, L.↗

NASA NTRS1976

A Rayleigh-Ritz approach to the synthesis of large structures with rotating flexible components

The equations of motion for large structures with rotating flexible components are derived by regarding the structure as an assemblage of substructures. Based on a stationarity principle for rotating structures, it is shown that each continuous or discrete substructure can be simulated by a suitable set of admissible functions or admissible vectors. This substructure synthesis approach provides a rational basis for truncating the number of degrees of freedom both of each substructure and of the assembled structure.

Meirovitch, L.↗

NASA NTRS1975

Dynamic analysis of the long-term zonal earth energy budget experiment (LZEEBE) spacecraft

The motions of the flexible LZEEBE spacecraft after injection into a circular orbit were analyzed. The spacecraft consists of three spherical balloons connected to a central hub by three long flexible booms which lie in a plane such that the angle between any pair of booms is 120 degrees. The major torques acting on the spacecraft are gravity-gradient torques and torques due to solar radiation pressure acting on the balloons which have different reflective properties. A development of the equations of motion is presented. Computer simulations indicate that the spacecraft will have random motion, provided the injection into orbit does not create conditions favorable to gravity-gradient capture.

Meirovitch, L.↗