Engineering Papers⌕ Search

Engineering topics

Hafenstine, Glenn R.

Publications and source records attributed to Hafenstine, Glenn R..

7 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2023

Experimental and Computational Studies of the Production of 1,3-Butadiene from 2,3-Butanediol Using SiO2-Supported H3PO4 Derivatives

Silica-supported phosphoric acid and metal phosphate catalyzed 1,3-butadiene (BDE) production from 2,3-butanediol (2,3-BDO) was studied using experimental and computational techniques. The catalyst was initially tested in a continuous flow reactor using commercially available 2,3-BDO, leading to maximum BDE yields of 63C%. Quantum chemical mechanistic studies revealed 1,2-epoxybutane is a kinetically viable and thermodynamically stable intermediate, supported by experimental demonstration that this epoxide can be converted to BDE under standard reaction conditions. Newly proposed E2 and SN2' elementary steps were studied to rationalize the formation of BDE and all detected side-products. Additionally, using quantum mechanics/molecular mechanics (QM/MM) calculations, we modeled silica-supported phosphate catalysts to study the effect of the alkali metal center. Natural population analysis showed that phosphate oxygen atoms are more negatively charged in CsH2PO4/SiO2 than in H3PO4/SiO2. In combination with temperature-programmed desorption experiments using CO2, the results of this study suggest that the improved selectivity achieved when adding the metal center is related to an increase in the basicity of the catalyst.

butadiene↗
DOE OSTI2022

Kinetics and Reactor Modeling of VFA Ketonization for Sustainable Aviation Fuel Production

Ketonization of volatile fatty acids (VFAs) produced via arrested methanogenesis of wet waste represents the only unit operation of wet waste upgrading to sustainable (net-zero or negative life cycle CO2 emissions) aviation fuel not currently in industrial practice. Ketone product yields of close to 100% have been obtained during gas-phase reactions of VFAs over oxide catalysts at the laboratory scale, but design of an industrial ketonization reactor requires understanding of the impacts of reactant and product partial pressures, deactivation, and heat and mass transport phenomena on observed ketonization rates. Our work leverages rigorous kinetic analysis of ketonization processes to inform reactor scale-up efforts through packed-bed reactor modeling. We first present results of a kinetic study of ketonization of a model VFA, hexanoic acid, over an industrial ZrO2 catalyst performed in a packed-bed microreactor in conditions free of significant heat or mass transfer gradients. Major findings of the analysis include: (i) hexanoic acid saturates all catalyst active sites at relatively low partial pressure (~10 kPa) and (ii) ketonization products 6-undecanone, water, and CO2 inhibit reaction rates. Kinetic data are used to fit a rate expression quantifying the functional dependence of ketonization rate on partial pressures of VFA reactants and ketone, water, and CO2 products. A packed-bed reactor model describing vapor-phase hexanoic acid ketonization over ZrO2 extrudate catalysts is developed based on the kinetic model. The effects of (i) bed- and pellet-scale mass- and heat-transfer limitations and (ii) axial pressure drop guide our development of recommendations for optimal sizing, temperature, and influent flow composition of an industrial-scale ketonization reactor. The quantitative understanding of VFA ketonization developed in this study represents an advance toward derisking the VFA ketonization step of wet waste upgrading to sustainable aviation fuel.

biojet↗
DOE OSTI2021

Toward net-zero sustainable aviation fuel with wet waste–derived volatile fatty acids

Significance To meet the growing demand for sustainable aviation fuels (SAF), conversion pathways are needed that leverage wet waste carbon and meet jet fuel property specifications. Here, we demonstrate SAF production from food waste–derived volatile fatty acids (VFA) by targeting normal paraffins for a near-term path to market and branched isoparaffins to increase the renewable content long term. Combining these distinct paraffin structures was shown to synergistically improve VFA-SAF flash point and viscosity to increase the renewable blend limit to 70%. Life cycle analysis shows the dramatic impact on the carbon footprint if food waste is diverted from landfills to produce VFA-SAF, highlighting the potential to meet jet fuel safety, operability, and environmental goals.

09 BIOMASS FUELS↗
DOE OSTI2020

Conversion, Stability, and Selectivity Improvements Through Catalyst Development for the Reductive Etherification Reaction

Economical pathways from lignocellulosic non-food biomass feedstocks to biofuels with appropriate fuel properties are necessary for displacing fossil-fuel derived diesel use in medium-/heavy duty vehicles. Oxygenated compounds have recently shown promise due to low sooting tendencies and autoignition properties and molecules with sufficiently high carbon numbers can meet the requisite standards for water solubility and flash point. Coupling waste biomass derived small molecules into bioblendstock targets through the reductive etherification reaction shows potential for increasing molecular weight without losing the advantages of oxygenates. However, the transition to industrial viability for this process is limited by strong catalyst deactivation in typical flow reactor systems. Strong acid resins such as Amberlyst-15 (A-15) show excellent activity in batch reactions but are limited to low temperatures and are poisoned by the side-product, water. In this talk, I will describe our recent work in catalyst synthesis and testing to select superior options with improved aqueous and thermal stability in reductive etherification flow reactions. Water-tolerant solid acid catalysts have potential to improve the conversion and selectivity to the ether target at temperatures above the degradation point of A-15. Analysis techniques such as physisorption, chemisorption, x-ray diffraction and transmission electron microscopy are being used to characterize the active sites. These techniques are also being used to evaluate degradation of the catalyst after extensive flow reactions in addition to comparative efficiency testing with standardized cyclohexene hydrogenation reactions. Finally, I will discuss a demonstration of the full pathway from bio-derived butyric acid to the performance-advantaged ether product and the additional obstacles from side-products and purification limitations in the preliminary upgrading reactions.

29 ENERGY PLANNING, POLICY, AND ECONOMY↗