Engineering PapersSearch

Engineering topics

Grunwald, A. J.

Publications and source records attributed to Grunwald, A. J..

Suppression of biodynamic interference in head-tracked teleoperation

The utility of helmet-tracked sights to provide pointing commands for teleoperation of cameras, lasers, or antennas in aircraft is degraded by the presence of uncommanded, involuntary heat motion, referred to as biodynamic interference. This interference limits the achievable precision required in pointing tasks. The noise contributions due to biodynamic interference consists of an additive component which is correlated with aircraft vibration and an uncorrelated, nonadditive component, referred to as remnant. An experimental simulation study is described which investigated the improvements achievable in pointing and tracking precision using dynamic display shifting in the helmet-mounted display. The experiment was conducted in a six degree of freedom motion base simulator with an emulated helmet-mounted display. Highly experienced pilot subjects performed precision head-pointing tasks while manually flying a visual flight-path tracking task. Four schemes using adaptive and low-pass filtering of the head motion were evaluated to determine their effects on task performance and pilot workload in the presence of whole-body vibration characteristic of helicopter flight. The results indicate that, for tracking tasks involving continuously moving targets, improvements of up to 70 percent can be achieved in percent on-target dwelling time and of up to 35 percent in rms tracking error, with the adaptive plus low-pass filter configuration. The results with the same filter configuration for the task of capturing randomly-positioned, stationary targets show an increase of up to 340 percent in the number of targets captured and an improvement of up to 24 percent in the average capture time. The adaptive plus low-pass filter combination was considered to exhibit the best overall display dynamics by each of the subjects.

Lifshitz, S.

Suppression of biodynamic interference in head-tracked teleoperation

Results are reported from an experimental simulation study examining improvements achievable in pointing and tracking precision using dynamic display shifting in helmet-mounted displays. The experiment was conducted in a 6-deg-of-freedom motion base simulator with an emulated helmet-mounted sight. It is shown that, for tracking tasks involving continuously moving targets, improvements of up to 70 percent can be achieved in percent on-target dwelling time and of up to 35 percent in rms tracking error, with the adaptive plus low-pass filter configuration. The results with the same filter configuration for the task of capturing randomly positioned, stationary targets show an increase of up to 340 percent in the number of targets captured and an improvement of up to 24 percent in the average capture time. The adaptive plus low-pass filter combination is considered to exhibit the best overall display dynamics by each of the subjects.

Lifshitz, S.

Predictor laws for pictorial flight displays

Two predictor laws are formulated and analyzed: (1) a circular path law based on constant accelerations perpendicular to the path and (2) a predictor law based on state transition matrix computations. It is shown that for both methods the predictor provides the essential lead zeros for the path-following task. However, in contrast to the circular path law, the state transition matrix law furnishes the system with additional zeros that entirely cancel out the higher-frequency poles of the vehicle dynamics. On the other hand, the circular path law yields a zero steady-state error in following a curved trajectory with a constant radius. A combined predictor law is suggested that utilizes the advantages of both methods. A simple analysis shows that the optimal prediction time mainly depends on the level of precision required in the path-following task, and guidelines for determining the optimal prediction time are given.

Grunwald, A. J.

Suppression of Biodynamic Interference by Adaptive Filtering

Preliminary experimental results obtained in moving base simulator tests are presented. Both for pursuit and compensatory tracking tasks, a strong deterioration in tracking performance due to biodynamic interference is found. The use of adaptive filtering is shown to substantially alleviate these effects, resulting in a markedly improved tracking performance and reduction in task difficulty. The effect of simulator motion and of adaptive filtering on human operator describing functions is investigated. Adaptive filtering is found to substantially increase pilot gain and cross-over frequency, implying a more tight tracking behavior. The adaptive filter is found to be effective in particular for high-gain proportional dynamics, low display forcing function power and for pursuit tracking task configurations.

Velger, M.

Tunnel display for four-dimensional fixed-wing aircraft approaches

The present evaluation of a computer-generated perspective tunnel display for four-dimensional fixed wing aircraft landing approaches gives attention to the development and performance assessment of superimposed predictor symbology. Simulator tests indicate that a complex perspective vehicle symbol yields a decrease in bank angle activity, by comparison to a flat predictor cross, while yielding larger lateral and vertical deviations in most cases. The perspective vehicle symbol motions are successful in forward velocity control without affecting path-following performance. The perspective vehicle symbol's advantage over the flat predictor cross is nevertheless marginal. While the tunnel display used yields satisfactory response in the lateral control axis, the vertical axis lacks sensitivity to vertical path angle variations.

Grunwald, A. J.

Using integrals of the state transition matrix for efficient transient-response computations

An iterative technique for the computation of lower-order state systems with poles at the origin (such as aircraft lateral dynamics) or with time-polynomial inputs is developed and demonstrated. The integrated input or output signals are computed using the integrals of the state transition matrix, thus reducing the system order and computation time. In an application to the lateral response of a DC-8 aircraft (Grunwald, 1981), this method required only 7824 multiplication or addition operations (at fourth order) to achieve the accuracy obtained in 15,012 operations by a conventional sixth-order computation.

Grunwald, A. J.

Experimental evaluation of a perspective tunnel display for three-dimensional helicopter approaches

A computer-generated perspective tunnel display for a steep and strongly curved three-dimensional helicopter approach is studied. The necessary control variables for following a curved trajectory are analyzed, the effectiveness of superimposed predictor symbology is investigated, and a suitable predictor law is formulated. The theoretical considerations are validated by an extensive fixed-base simulator program. The tunnel display with a superimposed predictor symbol is shown to outperform conventional-type displays in its abilities to follow a curved trajectory in the presence of gust disturbances, to enter the trajectory from an unknown position outside this trajectory, as well as to monitor automatic approaches. The feasibility of the tunnel display for operation in actual flight has been demonstrated in an exploratory flight test.

Grunwald, A. J.

Predictor symbology in computer-generated pictorial displays

The display under investigation, is a tunnel display for the four-dimensional commercial aircraft approach-to-landing under instrument flight rules. It is investigated whether more complex predictive information such as a three-dimensional perspective vehicle symbol, predicting the future vehicle position as well as future vehicle attitude angles, contributes to a better system response, and suitable predictor laws for the predictor motions, are formulated. Methods for utilizing the predictor symbol in controlling the forward velocity of the aircraft in four-dimensional approaches, are investigated. The simulator tests show, that the complex perspective vehicle symbol yields improved damping in the lateral response as compared to a flat two-dimensional predictor cross, but yields generally larger vertical deviations. Methods of using the predictor symbol in controlling the forward velocity of the vehicle are shown to be effective. The tunnel display with superimposed perspective vehicle symbol yields very satisfactory results and pilot acceptance in the lateral control but is found to be unsatisfactory in the vertical control, as a result of too large vertical path-angle deviations.

Grunwald, A. J.

Predictor symbology in computer-generated perspective displays

An advanced display format for the four dimensional commercial aircraft approach-to-landing is evaluated. The desired curved and descending approach path is presented by displaying the perspective image of a tunnel. Attention is focussed on the predictor symbology, superimposed on the tunnel image. A perspective three dimensional predictor symbol, providing future position, as well as future attitude information, is compared with a flat two dimensional version, which only provides the future position. In addition to this, the predictor displays the actual airspeed as well as the desired airspeed, prescribed by the four dimensional path. Results show that the three dimensional predictor symbol outperforms the two dimensional predictor in following the trajectory in a moderate-to-heavy turbulent environment, which is manifested in accurate manual true airspeed control was obtained without affecting the main task performance significantly.

Grunwald, A. J.

Evaluation of a computer-generated perspective tunnel display for flight path following

The display was evaluated by monitoring pilot performance in a fixed base simulator with the vehicle dynamics of a CH-47 tandem rotor helicopter. Superposition of the predicted future vehicle position on the tunnel image was also investigated to determine whether, and to what extent, it contributes to better system performance (the best predicted future vehicle position was sought). Three types of simulator experiments were conducted: following a desired trajectory in the presence of disturbances; entering the trajectory from a random position, outside the trajectory; detecting and correcting failures in automatic flight. The tunnel display with superimposed predictor/director symbols was shown to be a very successful combination, which outperformed the other two displays in all three experiments. A prediction time of 4 to 7 sec. was found to optimize trajectory tracking for the given vehicle dynamics and flight condition. Pilot acceptance of the tunnel plus predictor/director display was found to be favorable and the time the pilot needed for familiarization with the display was found to be relatively short.

Grunwald, A. J.

Real-time film recording from stroke-written CRT's

Real-time simulation studies often require motion-picture recording of events directly from stroke written cathode-ray tubes (CRT's). Difficulty presented is prevention of "flicker," which results from lack of synchronization between display sequence on CRT and shutter motion of camera. Programmable method has been devised for phasing display sequence to shutter motion, ensuring flicker-free recordings.

Hunt, R.

Effectiveness of basic display augmentation in vehicular control by visual field cues

The paper investigates the effectiveness of different basic display augmentation concepts - fixed reticle, velocity vector, and predicted future vehicle path - for RPVs controlled by a vehicle-mounted TV camera. The task is lateral manual control of a low flying RPV along a straight reference line in the presence of random side gusts. The man-machine system and the visual interface are modeled as a linear time-invariant system. Minimization of a quadratic performance criterion is assumed to underlie the control strategy of a well-trained human operator. The solution for the optimal feedback matrix enables the explicit computation of the variances of lateral deviation and directional error of the vehicle and of the control force that are used as performance measures.

Grunwald, A. J.