Engineering topics

Griffin, Jerry H.

Publications and source records attributed to Griffin, Jerry H..

4 records

NASA NTRS2005

Fundamental Mistuning Model for Probabilistic Analysis Studied Experimentally

The Fundamental Mistuning Model (FMM) is a reduced-order model for efficiently calculating the forced response of a mistuned bladed disk. FMM ID is a companion program that determines the mistuning in a particular rotor. Together, these methods provide a way to acquire mistuning data in a population of bladed disks and then simulate the forced response of the fleet. This process was tested experimentally at the NASA Glenn Research Center, and the simulated results were compared with laboratory measurements of a "fleet" of test rotors. The method was shown to work quite well. It was found that the accuracy of the results depends on two factors: (1) the quality of the statistical model used to characterize mistuning and (2) how sensitive the system is to errors in the statistical modeling.

Griffin, Jerry H.↗

NASA NTRS1994

Modeling the effect of shroud contact and friction dampers on the mistuned response of turbopumps

The contract has been revised. Under the revised scope of work a reduced order model has been developed that can be used to predict the steady-state response of mistuned bladed disks. The approach has been implemented in a computer code, LMCC. It is concluded that: the reduced order model displays structural fidelity comparable to that of a finite element model of an entire bladed disk system with significantly improved computational efficiency; and, when the disk is stiff, both the finite element model and LMCC predict significantly more amplitude variation than was predicted by earlier models. This second result may have important practical ramifications, especially in the case of integrally bladed disks.

Griffin, Jerry H.↗

NASA NTRS1988

Evaluation of a turbine blade damper using an integral approach

An integrated experimental/analytical approach to friction damper design optimization in cases where gas turbine blade-response data are unavailable under actual engine operating conditions is presently applied to the case of a damper designed to relieve a blade-cracking problem on a liquid fuel rocket engine's turbopump. Attention is given to the experimental methods and analytical models used, as well as to the predicted damper performance. The inclusion of macroslip, microslip, and variable normal load effects was found to be necessary.

Kielb, Robert E.↗

NASA NTRS1987

SSME blade damper technology

Before 1975 turbine blade damper designs were based on experience and very simple mathematical models. Failure of the dampers to perform as expected showed the need to gain a better understanding of the physical mechanism of friction dampers. Over the last 10 years research on friction dampers for aeronautical propulsion systems has resulted in methods to optimize damper designs. The first-stage turbine blades on the Space Shuttle Main Engine (SSME) high-pressure oxygen pump have experienced cracking problems due to excessive vibration. A solution is to incorporate a well-designed friction dampers to attenuate blade vibration. The subject study, a cooperative effort between NASA Lewis and Carnegie-Mellon University, represents an application of recently developed friction damper technology to the SSME high-pressure oxygen turbopump. The major emphasis was the contractor's design known as the two-piece damper. Damping occurs at the frictional interface between the top half of the damper and the underside of the platforms of the adjacent blades. The lower half of the damper is an air seal to retard airflow in the volume between blade necks.

Kielb, Robert E.↗