Computational aspects of sensitivity calculations in linear transient structural analysis
The calculation of sensitivities of displacements, velocities, accelerations, and stresses in linear, structural, and transient response problems is studied. Several existing sensitivity calculation methods and two new methods are compared for three example problems. Approximation vectors such as vibration mode shapes are used to reduce the dimensionality of the finite model. To be computationally practical in large-order problems, the overall finite difference methods must use the approximation vectors from the original design in the analyses of the perturbed models. This was found to result in poor convergence of stress sensitivities in several cases. Two semianalytical techniques are developed to overcome this poor convergence. Both new methods result in very good convergence of the stress sensitivities; the computational cost is much less than would result if the vibration modes were recalculated and then used in an overall finite difference method.