Engineering PapersSearch

Engineering topics

Green, R. N.

Publications and source records attributed to Green, R. N..

At least 37 records · Page 2

Simulation study of geometric shape factor approach to estimating earth emitted flux densities from wide field-of-view radiation measurements

A study was performed on the use of geometric shape factors to estimate earth-emitted flux densities from radiation measurements with wide field-of-view flat-plate radiometers on satellites. Sets of simulated irradiance measurements were computed for unrestricted and restricted field-of-view detectors. In these simulations, the earth radiation field was modeled using data from Nimbus 2 and 3. Geometric shape factors were derived and applied to these data to estimate flux densities on global and zonal scales. For measurements at a satellite altitude of 600 km, estimates of zonal flux density were in error 1.0 to 1.2%, and global flux density errors were less than 0.2%. Estimates with unrestricted field-of-view detectors were about the same for Lambertian and non-Lambertian radiation models, but were affected by satellite altitude. The opposite was found for the restricted field-of-view detectors.

Weaver, W. L.

Simulation study of a geometric shape factor technique for estimating earth-emitted radiant flux densities from wide-field-of-view radiation measurements

Geometric shape factors were computed and applied to satellite simulated irradiance measurements to estimate Earth emitted flux densities for global and zonal scales and for areas smaller than the detector field of view (FOV). Wide field of view flat plate detectors were emphasized, but spherical detectors were also studied. The radiation field was modeled after data from the Nimbus 2 and 3 satellites. At a satellite altitude of 600 km, zonal estimates were in error 1.0 to 1.2 percent and global estimates were in error less than 0.2 percent. Estimates with unrestricted field of view (UFOV) detectors were about the same for Lambertian and limb darkening radiation models. The opposite was found for restricted field of view detectors. The UFOV detectors are found to be poor estimators of flux density from the total FOV and are shown to be much better as estimators of flux density from a circle centered at the FOV with an area significantly smaller than that for the total FOV.

Weaver, W. L.

Parameter estimation applied to Nimbus 6 wide-angle longwave radiation measurements

A parameter estimation technique was used to analyze the August 1975 Nimbus 6 Earth radiation budget data to demonstrate the concept of deconvolution. The longwave radiation field at the top of the atmosphere is defined from satellite data by a fifth degree and fifth order spherical harmonic representation. The variations of the major features of the radiation field are defined by analyzing the data separately for each two-day duty cycle. A table of coefficient values for each spherical harmonic representation is given along with global mean, gradients, degree variances, and contour plots. In addition, the entire data set is analyzed to define the monthly average radiation field.

Green, R. N.

Analysis of simulated measurements of earth emitted radiation using geometric shape factors, and some results from analysis of ESSA 7 and Nimbus 6 data

In the reported study, simulated measurements of earth radiation with wide field-of-view (WFOV) radiometers are reduced to earth fluxes through geometric shape factors. Estimates of emitted flux for global and zonal scales and for regions smaller than the detector field-of-view are compared to fluxes derived directly from a model. Geometric shape factors are used to estimate global, zonal, and regional averages of earth-emitted flux from measurements with WFOV detectors on the ESSA 7 satellite and the Nimbus 6 satellite. Zonal and global averages of emitted flux for each of the 3-month periods of ESSA 7 data are shown in a graph. Another graph shows zonal and global averages of emitted flux for August 1975 obtained with the aid of Nimbus 6. The data are compared to values reported by Green and Smith (1977) who used a spherical harmonic solution.

Weaver, W. L.

Simulation studies of wide and medium field of view earth radiation data analysis

A parameter estimation technique is presented to estimate the radiative flux distribution over the earth from radiometer measurements at satellite altitude. The technique analyzes measurements from a wide field of view (WFOV), horizon to horizon, nadir pointing sensor with a mathematical technique to derive the radiative flux estimates at the top of the atmosphere for resolution elements smaller than the sensor field of view. A computer simulation of the data analysis technique is presented for both earth-emitted and reflected radiation. Zonal resolutions are considered as well as the global integration of plane flux. An estimate of the equator-to-pole gradient is obtained from the zonal estimates. Sensitivity studies of the derived flux distribution to directional model errors are also presented. In addition to the WFOV results, medium field of view results are presented.

Green, R. N.

Deconvolution estimation theory applied to Nimbus 6 ERB data

It is pointed out that the ERB (Earth Radiation Budget) Experiment aboard the Nimbus 6 spacecraft has provided nearly 3 years of data thus far from its wide field of view (WFOV) radiometers. Each data point is an integral of the irradiance from all points within the field of view of the WFOV sensor, which is an approximately 60 deg diameter circular region on the earth. House (1972) proposed that the data, being a convolution of the flux field at the top of the atmosphere, could be convoluted so as to enhance the resolution. The problem was solved by Smith and Green (1975-76) for the case of earth emitted radiation. A parameter estimation approach to the deconvolution problem was formulated. A description is presented of the deconvolution estimation concept and the results obtained by its application to the Nimbus 6 ERB WFOV data for earth emitted radiation for August 1975.

Green, R. N.

Potential applications of digital, visible, and infrared data from geostationary environmental satellites

An hourly, digital data base from the Visible/Infrared Spin-Scan Radiometer (VISSR) instrument on the GOES-1 and SMS-2 geostationary satellites is described. Several examples of developmental applications of these quantitative digital data are presented. These include a review of recent attempts to develop products that are of use to meteorologists who provide services to aviation, agriculture, forestry, hydrology, oceanography, and climatology. The sample products include high resolution thermal gradients of land and ocean surfaces, thermal change analyses, fruit frost/freeze application, cloud-top altitude analysis, analysis of hurricane characteristics, and analyses of solar insolation.

Miller, D. B.

A simulation study of earth radiation budget data interpretation

The paper describes a simulation of a filtering analysis which yields radiation distributions, measured by a wide-field-of-view radiometer on board an earth satellite, on a scale smaller than the field of view of the instrument. Mathematical models are developed to represent an orbiting wide-field-of-view radiometer to provide simulated measurement data. The simulated measurements are analyzed by a data inversion technique to obtain estimates of the radiation heat fluxes at the top of the atmosphere. By comparing the estimated field to a real radiation field, the effects of directional model errors and sampling strategies are revealed.

Smith, G. L.

Mission analysis for satellite measurements of stratospheric constituents by solar occultation

Orbital characteristics and launch vehicle requirements for a solar occultation experiment measuring atmospheric constituents, such as aerosols or ozone, during the Nimbus-G and Applications Explorer Missions are analyzed. The experiment to be flown is basically a sun photometer which measures the spectral attenuation of solar radiation by the earth's atmosphere during spacecraft sunrise and sunset, yielding two aerosol and/or ozone stratospheric profiles per orbit. The tangent latitudes and longitudes as well as frequency of these measurements are analyzed for various spacecraft orbits to define maximum geographical coverage capability. Results indicate that a 50 deg inclined orbit for Applications Explorer provides latitude coverage from approximately 70 deg north to 70 deg south every 2-1/2 weeks. A high-moon, sun-synchronous orbit with an inclination of 99 deg for Nimbus-G will provide for coverage of occultation measurements at high latitudes near the polar regions (i.e., 64 to 80 deg north and south). The solar pointing requirements of the experiment in terms of yaw and pitch angles are also defined.

Harrison, E. F.

Statistical interpretation of pollution data from satellites

The NIMBUS-G environmental monitoring satellite has an instrument (a gas correlation spectrometer) onboard for measuring the mass of a given pollutant within a gas volume. The present paper treats the problem: How can this type measurement be used to estimate the distribution of pollutant levels in a metropolitan area. Estimation methods are used to develop this distribution. The pollution concentration caused by a point source is modeled as a Gaussian plume. The uncertainty in the measurements is used to determine the accuracy of estimating the source strength, the wind velocity, diffusion coefficients and source location.

Smith, G. L.

Time-fixed rendezvous by impulse factoring with an intermediate timing constraint

A method is presented for factoring a two-impulse orbital transfer into a three- or four-impulse transfer which solves the rendezvous problem and satisfies an intermediate timing constraint. Both the time of rendezvous and the intermediate time of a alinement are formulated as any element of a finite sequence of times. These times are integer multiples of a constant plus an additive constant. The rendezvous condition is an equality constraint, whereas the intermediate alinement is an inequality constraint. The two timing constraints are satisfied by factoring the impulses into collinear parts that vectorially sum to the original impulse and by varying the resultant period differences and the number of revolutions in each orbit. Five different types of solutions arise by considering factoring either or both of the two impulses into two or three parts with a limit for four total impulses. The impulse-factoring technique may be applied to any two-impulse transfer which has distinct orbital periods.

Green, R. N.

Modification of an impulse-factoring orbital transfer technique to account for orbit determination and maneuver execution errors

A method has previously been developed to satisfy terminal rendezvous and intermediate timing constraints for planetary missions involving orbital operations. The method uses impulse factoring in which a two-impulse transfer is divided into three or four impulses which add one or two intermediate orbits. The periods of the intermediate orbits and the number of revolutions in each orbit are varied to satisfy timing constraints. Techniques are developed to retarget the orbital transfer in the presence of orbit-determination and maneuver-execution errors. Sample results indicate that the nominal transfer can be retargeted with little change in either the magnitude (Delta V) or location of the individual impulses. Additonally, the total Delta V required for the retargeted transfer is little different from that required for the nominal transfer. A digital computer program developed to implement the techniques is described.

Kibler, J. F.

Interpretation of air pollution data as measured by an airborne remote sensor

The investigation described is a continuation of the work reported by Smith et al. (1974) in which a single source was studied. In the current study, multiple sources of known location are considered. The study is concerned with the strength of each source and the resulting pollution concentration field. The characteristics of the remotely sensed data are discussed along with the parameter estimation procedure, the estimation of pollution parameters, and a numerical example.

Smith, G. L.

Orbit analysis for coastal zone oceanography observations.

A study has been performed to define the orbital characteristics of a satellite dedicated to monitoring the coastal zones of the United States. The primary area of coverage is the east coast with secondary coverage of the west coast. Since no one orbital inclination fits both coasts, the inclination was determined by the east coast to be 63 deg. This inclination was found to give better coverage of the east coast than either its retrograde counterpart or a sun synchronous orbit. The two coasts require quite different orbits to maximize the coverage. The use of a small propulsive maneuver could be used to compromise the coverage between the two coastlines and change from one type orbit to the other.

Harrison, E. F.

A Monte Carlo error analysis program for near-Mars, finite-burn, orbital transfer maneuvers

A computer program was developed which performs an error analysis of a minimum-fuel, finite-thrust, transfer maneuver between two Keplerian orbits in the vicinity of Mars. The method of analysis is the Monte Carlo approach where each off-nominal initial orbit is targeted to the desired final orbit. The errors in the initial orbit are described by two covariance matrices of state deviations and tracking errors. The function of the program is to relate these errors to the resulting errors in the final orbit. The equations of motion for the transfer trajectory are those of a spacecraft maneuvering with constant thrust and mass-flow rate in the neighborhood of a single body. The thrust vector is allowed to rotate in a plane with a constant pitch rate. The transfer trajectory is characterized by six control parameters and the final orbit is defined, or partially defined, by the desired target parameters. The program is applicable to the deboost maneuver (hyperbola to ellipse), orbital trim maneuver (ellipse to ellipse), fly-by maneuver (hyperbola to hyperbola), escape maneuvers (ellipse to hyperbola), and deorbit maneuver.

Green, R. N.

Orbital trim by velocity factoring with applications to the Viking mission.

An orbital trim technique has been developed to satisfy terminal rendezvous and intermediate timing constraints for planetary missions involving orbital operations. The technique utilizes a time-open two-impulse transfer from a specified initial orbit to a final orbit which satisfies all geometrical constraints. Each of the two impulses may then be factored, or split, into two or more vectorially equivalent impulses. The periods of the resulting intermediate orbits may be varied along with the number of revolutions in each orbit to satisfy the intermediate and final timing constraints. Factors in the range 0 to 1 result in rendezvous at the same cost as that of the two-impulse transfer. The technique is applied to the Viking mission to Mars although a similar procedure could be utilized for rendezvous operations about any planet.

Kibler, J. F.