Engineering Papers⌕ Search

Engineering topics

Green, James

Publications and source records attributed to Green, James.

23 records · Page 2

Fabrication, evaluation, and performance of machined metal grazing incidence telescopes

The fabrication, evaluation, and performance of machined grazing incidence metal optics for applications ranging from telescopes with imaging of minutes of arc to those with imaging in the less-than-10-arcsec range are reviewed. Issues considered in the fabrication process include the choice of machining substrate, the choice of machine tool, the choice of method for removing tool marks, and the choice of a reflective surface. Means of evaluating the mirror performance include the FWHM and determination of noncircularity and surface roughness. Characteristics of previous and current grazing incidence metal mirrors are presented, with emphasis on the Einstein and Rosat optics.

Bowyer, Stuart↗

A comparison between measured surface microtopography and observed scattering in the extreme ultraviolet

The paper presents comparative measurements of surface roughness on prepared samples. These measurements have been made with both Talystep profilometers and WYKO interferometers. In addition, the scattering distribution from these samples was measured at extreme ultraviolet wavelengths. The utility of the WYKO interferometer and Talystep device for specifying extreme ultraviolet mirror surface quality is discussed.

Green, James↗

Surface evaluation of the grazing incidence mirrors for the Extreme Ultraviolet Explorer

The EUV scattering from the Wolter-Schwarzschild type I short wavelength scanner mirror aboard the Extreme Ultraviolet Explorer is measured, and the results are used to evaluate the surface microroughness of the mirror. It is found that the most likely values for the mirror surface are sigma = 20 A, and rho = 40 microns. These results are consistent with previous estimates, but with a higher degree of certainty. The full-scale simulation presented here allows over 99 percent of the light distribution to be reasonably modeled.

Green, James↗

Networking ground-based images of Comet Halley during the Giotto encounter

During the period immediately before and after the European, Russian, and Japanese spacecraft encounters with Comet Halley in early March 1986, sequences of ground-based electronic images of the comet, obtained at Table Mountain Observatory (TMO), CA, were transmitted via the Space Physics Analysis Network (SPAN) to the European Space Operations Centre (ESOC), and to University College London (UCL). During the 48-h period when the European Space Agency spacecraft Giotto was within the extended coma of Comet Halley, the ground-based images revealed that the comet displayed several spectacular near-nuclear and large-scale features. The TMO images provided a format for the interpretation of the unique in situ results obtained during the closest of the five spacecraft encounters with Comet Halley.

Rees, David↗

An analysis of two classes of grazing incidence mirrors for use with Rowland circle spectrometers

Results are presented of a comparative analysis of Hettrick Bowyer Type II (HBII) and Wolter-Schwarzschild Type II (WSII) optics for use with Rowland circle spectrometers. The HBII can substitute, with few exceptions, for a WSII in any Rowland circle with little change in spectrometer performance or design. However, the HBII telescope offers several clear advantages over the WSII in these configurations. Because the HBII employs a virtual focus, it requires a much shorter instrument length than a WSII. For example, a 3-m Rowland circle spectrometer, fed by an optimized, f/10, 1-m diameter WSII, has a total instrument length of 6 m. If a HBII is used to feed the identical spectrometer, the entire instrument length can be as little as 3 m. In addition, the improved imaging gained with the larger graze angles of the HBII design results in better resolution in slitless operation modes.

Green, James↗