Engineering Papers⌕ Search

Engineering topics

Graves, J.

Publications and source records attributed to Graves, J..

9 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1992

Development of a low-cost free-flying telerobotic space flight vehicle

Ranger, a low-cost moderate-risk high-return telerobotics flight experiment, is discussed. Range incorporates two manipulators, a grappling arm, and a camera-positioning manipulator all mounted on a free-flying base with limited orbital maneuvering capability. Ranger will provide data on neutral buoyancy simulations, advanced telerobotics control and design, remote maneuvering, human factors involved in ground-based control of space telerobotics, and advanced small spacecraft technology.

Akin, D.↗
NASA NTRS1983

High voltage battery cell scanner development

Battery cell voltage scanners have been previously used in low voltage spacecraft applications. In connection with future missions involving an employment of high-power high voltage power subsystems and/or autonomous power subsystem management for unattended operation, it will be necessary to utilize battery cell voltage scanners to provide battery cell voltage information for early detection of impending battery cell degradation/failures. In preparation for such missions, a novel battery cell voltage scanner design has been developed. The novel design makes use of low voltage circuit modules which can be applied to high voltage batteries in a building block fashion. A description is presented of the design concept and test results of the high voltage battery cell scanner, and its operation with an autonomously managed power subsystem is discussed.

Lepisto, J. W.↗
NASA NTRS1983

Automated distribution system management for multichannel space power systems

A NASA sponsored study of space power distribution system technology is in progress to develop an autonomously managed power system (AMPS) for large space power platforms. The multichannel, multikilowatt, utility-type power subsystem proposed presents new survivability requirements and increased subsystem complexity. The computer controls under development for the power management system must optimize the power subsystem performance and minimize the life cycle cost of the platform. A distribution system management philosophy has been formulated which incorporates these constraints. Its implementation using a TI9900 microprocessor and FORTH as the programming language is presented. The approach offers a novel solution to the perplexing problem of determining the optimal combination of loads which should be connected to each power channel for a versatile electrical distribution concept.

Fleck, G. W.↗
NASA NTRS1982

A perspective of power management for large space platforms

NASA and military applications for high power spacecraft are presently being planned. A perspective of autonomous power management for low earth orbit large space platforms is presented. A multichannel 250 kWe utility-type power subsystem is used as a baseline system. The need for automation is reviewed, based on power subsystem complexity, survivability requirements, and cost benefits. On-board versus ground management is discussed with respect to these needs. In addition, the utilization of autonomous power management to enable technology readiness of large complex power subsystems is described. Recommendations are made for further technology thrusts.

Decker, D. K.↗
NASA NTRS1982

Development of management technology for large power systems

Autonomous power management has been proposed as a method to perform optimization of power subsystem performance in connection with the management of multikilowatt space platforms. A concept for a 250-kW utility-type power subsystem was developed. A Cassegrain concentrator solar array primary source is conditioned by a solar array switching unit which supplies seventeen 220 +20 Vdc power channels. A power management subsystem provides the monitoring and control of the overall electrical power subsystem. The discussed system concept for autonomous management of high power space platforms utilizes on-board microprocessors in a decentralized data management architecture. A data bus protocol and a data bus contention resolution scheme were selected in conjunction with the dencentralized management architecture.

Decker, D. K.↗
NASA NTRS1981

Power management of multi-hundred kilowatt spacecraft power systems

A NASA-sponsored study of space power distribution system technology is in progress to develop an Autonomously Managed Power System (AMPS) for large space power platforms. The conceptual design of a 250 kW photovoltaic power system, including the power management subsystem (PMS), is presented. A PMS concept is derived based on the need to accommodate the increased complexity of a utility-type power system, and to minimize Shuttle resupply and ground station operational costs. The main PMS functions are discussed along with the control strategies of the autonomously managed power system.

Decker, D. K.↗
NASA NTRS1980

Power management

The multihundred kW power system management and a distribution program aims to develop critical components, circuits, and subsystems required to manage the generation, storage, and distribution of energy in large, orbital space systems. To accomplish this objective, a reference system including subsystems for the generation and storage of energy and management of electrical and thermal energy was designed and is being used to assess at the system level the impact of changing various subsystem parameters. A power management subsystem will then be designed. The subsystem is autonomous and based on ground utility systems concepts to the maximum extent possible. An agency power system breadboard is under development for characterizing and verifying the various component and subsystem technology developments.

Graves, J.↗
NASA NTRS1980

Advanced development of a programmable power processor

The need for the development of a multipurpose flexible programmable power processor (PPP) has increased significantly in recent years to reduce ever rising development costs. One of the program requirements the PPP specification will cover is the 25 kW power module power conversion needs. The 25 kW power module could support the Space Shuttle program during the 1980s and 1990s and could be the stepping stone to future large space programs. Trades that led to selection of a microprocessor controlled power processor are briefly discussed. Emphasis is given to the power processing equipment that uses a microprocessor to provide versatility that allows multiple use and to provide for future growth by reprogramming output voltage to a higher level (to 120 V from 30 V). Component selection and design considerations are also discussed.

Lukens, F. E.↗