Engineering topics
Publications and source records attributed to Grard, R. J. L..
The experiment is designed to measure the electric field and density fluctuations with sampling rates up to 40,000 samples/sec. The description includes Langmuir sweeps that can be made to determine the electron density and temperature, the study of nonlinear processes that result in acceleration of plasma, and the analysis of large scale phenomena where all four spacecraft are needed.
The cluster spacecraft are instrumented with ion emitters for charge neutralization. The emitters produce indium ions at 6 keV. The ion current is adjusted in a feedback loop with instruments measuring the spacecraft potential. The system is based on the evaporation of indium in the apex field of a needle. The design of the active spacecraft potential control instruments, and the ion emitters is presented.
Analyses are presented of Giotto's Dust Impact Detection System experiment measurements of dust grains incident on the Giotto dust shield along its trajectory through the coma of comet P/Halley on March 13 and 14, 1986. Ground-based CCD imagery of the inner coma dust continuum at the time of the encounter are used to derive the area of grains intercepted by Giotto. Data obtained at large masses show clear evidence of a decrease in the mass distribution index at these masses within the coma; it is shown that such a value of the mass index can furnish sufficient mass for consistency with an observed deceleration.
The Giotto Dust Impact Detection System (DIDSY) consists of six independent subsystems to register the impact of all particulates of significant mass incident on the probe during the post-perihelion encounter with Comet Halley. Mounted on Giotto's front dust shield, the detectors will determine the mass spectrum of the dust, with a limiting sensitivity of 10 to the minus 17th power f, increasing to the largest grain masses encountered along Giotto's trajectory throught the cometary environment with an ultimate spatial resolution of 70 km. An additional detector is located on the rear shield to monitor dust particles that penetrate the from dust shield. An ambient plasma monitor measures the impact plasma generated by dust and gass impacts on the spacecraft.
A description is provided of observations made by GEOS 1, ISEE 1, and ISEE 2 of a hydromagnetic wave with a period approximately 90 s observed near 0200 LT between L = 9 and L = 6, close to the measured inner boundary of the plasma sheet. The wave magnetic oscillations perpendicular to and along the ambient field had similar amplitudes. Using primarily the transverse magnetic components, it is shown that the wave is a second harmonic resonance of the local geomagnetic field lines. ISEE 1 and 2 observed the opposite sense of polarization for about 30 min, although the spacecraft were separated by only 9 min in their orbit; this remarkable feature cannot be explained by either a stationary spatial boundary or a simple temporal boundary but could result from a rapid movement of the resonant region. It is argued that the most likely energy source is bounce resonance with medium energy (approximately 5 keV) ions. Calculations of the wave Poynting vector at ISEE 1 support this conclusion.
It is suggested that the low energy electrons reported by Intriligator and Wolfe (1974) in the outer magnetosphere of Jupiter may actually be photoelectrons and/or secondary electrons from the Pioneer spacecraft surfaces. The electron spectrum is similar to the observed photoelectron spectrum on earth-orbiting satellites where differentially charged surfaces have deflected the electrons into particle detectors.
An electron source such as a simple cathode is a cheap and light device which can serve several technological and scientific purposes in space: (1) electrostatic charging of a spacecraft can be limited by releasing electrons accumulated on the conductive elements of their surface; (2) the erosion of conductive coatings and the ability of conductive paints to withstand the space environment can be evaluated by monitoring the flow of charged particles impinging on their surface; (3) measuring the current collected by the spacecraft surface as a function of its potential with respect to an emitter is a very sensitive diagnostic technique which can yield a number of plasma parameters, such as density and temperature; (4) it is possible to convert the thermal motion of space plasmas into electrical energy by collecting energetic electrons and returning them to the medium as cold particles; (5) a wave in a plasma is characterized by a conduction current density which gives rise to fluctuations of the current flowing to the surface.
Impedance probe measurements of ionosphere for determining electron density and temperature