Engineering PapersSearch

Engineering topics

Grantham, W. L.

Publications and source records attributed to Grantham, W. L..

At least 19 records

Active and passive microwave measurements in Hurricane Allen

The NASA Langley Research Center analysis of the airborne microwave remote sensing measurements of Hurricane Allen obtained on August 5 and 8, 1980 is summarized. The instruments were the C-band stepped frequency microwave radiometer and the Ku-band airborne microwave scatterometer. They were carried aboard a NOAA aircraft making storm penetrations at an altitude of 3000 m and are sensitive to rain rate, surface wind speed, and surface wind vector. The wind speed is calculated from the increase in antenna brightness temperature above the estimated calm sea value. The rain rate is obtained from the difference between antenna temperature increases measured at two frequencies, and wind vector is determined from the sea surface normalized radar cross section measured at several azimuths. Comparison wind data were provided from the inertial navigation systems aboard both the C-130 aircraft at 3000 m and a second NOAA aircraft (a P-3) operating between 500 and 1500 m. Comparison rain rate data were obtained with a rain radar aboard the P-3. Evaluation of the surface winds obtained with the two microwave instruments was limited to comparisons with each other and with the flight level winds. Two important conclusions are drawn from these comparisons: (1) the radiometer is accurate when predicting flight level wind speeds and rain; and (2) the scatterometer produces well behaved and consistent wind vectors for the rain free periods.

Delnore, V. E.

Electro-science Requirements for Shuttle-attached Antenna Flight Experiments

The activities of an in-house electro-science task group organized to conduct studies of shuttle-attached flight experiments using the 15-meter hoop-column antennas as a research tool for developing both improved sensor technology and LSA technology are described. Some experiments could provide significant amounts of scientific data such as radio star mapping and definition of ocean current eddies over limited geographic regions. The experiments originate from the microwave remote sensing community and other areas which require the inherently higher resolution and boresite gain of large space antennas. Technology experiments are also being studied which would use the 15-meter antenna experiments as a stepping stone to 50 to 100 meter class reflector technology in the future. An antenna technology experiment using the 15-meter antenna in a shuttle-attached mission is discussed. Electromagnetic modeling is correct for each major subsystem and also to verify the interrelations of the subsystems.

Grantham, W. L.

Beaufort/Bering 1979 microwave remote sensing data catalog report, 14-24 March 1979

The airborne microwave remote sending measurements obtained by the Langley Research Center in support of the 1979 Sea-Ice Radar Experiment (SIRE) in the Beaufort and Bering Seas are discussed. The remote sensing objective of SIRE was to define correlations between both active and passive microwave signatures and ice phenomena assocated with practical applications in the Arctic. The instruments used by Langley during SIRE include the stepped frequency microwave radiometer (SFMR), the airborne microwave scatterometer (AMSCAT), the precision radiation thermometer (PRT-5), and metric aerial photography. Remote sensing data are inventoried and cataloged in a user-friendly format. The data catalog is presented as time-history plots when and where data were obtained as well as the sensor configuration.

Hirstein, W. S.

Greenland 1979 microwave remote sensing data catalog report, 14-15 October 1979

Microwave remote sensing measurements were cataloged for active and passive instruments in support of the 1979 Greenland Remote Sensing Experiment. Instruments used in this field experiment include the stepped frequency microwave radiometer (4 to 8 GHz) and the airborne microwave scatterometer (14.6 GHz). The microwave signature data are inventoried and cataloged in a user friendly format and are available on 9 track computer compatible tapes upon request.

Hennigar, H. F.

SASS measurements of the Ku-band radar signature of the ocean

SeaSat-A Satellite Scatterometer (SASS) measurements of normalized radar cross section (NRCS) have been merged with high quality surface-wind fields based on in situ, to create a large data base of NRCS-wind signature data. These data are compared to the existing NRCS-wind model used by the SASS to infer winds. Falso-color maps of SASS NRCS and ocean winds from multiple orbits show important synoptic trends.

Schroeder, L. C.

Performance evaluation of a spaceborne scatterometer

Study results are presented showing performance capability of a spaceborne scatterometer to operationally measure ocean surface wind speed and direction. In addition, a research mode is described which will allow development of improved radar signatures for ocean, sea ice, and land targets. The study results show that a scatterometer can meet the operational requirements of + or - 2 m/s wind speed accuracy (or + or - 10%, whichever is greater) and + or - 20 deg wind direction accuracy over most of the expected ocean surface conditions. The six beam scatterometer design evaluated is shown to be skillful (greater than 90% correct) in specifying the correct wind vector solution (with a 180 deg ambiguity) from the multiple solutions derived; further improvement must rely on meteorological and pattern recognition techniques now under study.

Grantham, W. L.

Seasat-A satellite scatterometer instrument evaluation

The Seasat-A satellite scatterometer (SASS) was designed to measure ocean surface wind speed and direction in twenty-four independent cells over a 1000-km swath. It operated in the interrupted CW mode at a frequency of 14.6 GHz with four fan beam antennas and used Doppler filtering in the receiver for resolving the cells on the surface. The instrument began operating in space on July 6, 1978, and gathered normalized radar cross section data for approximately 2290 h. The purpose of this paper is to describe the in-orbit evaluation of the SASS hardware and its compatibility with the spacecraft. It has been determined that the scatterometer operated flawlessly throughout the mission, met all design requirements, and established a good data base for geophysical processing.

Johnson, J. W.

The SASS scattering coefficient algorithm

This paper describes the algorithms used to convert engineering unit data obtained from the Seasat-A satellite scatterometer (SASS) to radar scattering coefficients and associated supporting parameters. A description is given of the instrument receiver and related processing used by the scatterometer to measure signal power backscattered from the earth's surface. The applicable radar equation used for determining scattering coefficient is derived. Sample results of SASS data processed through current algorithm development facility (ADF) scattering coefficient algorithms are presented which include scattering coefficient values for both water and land surfaces. Scattering coefficient signatures for these two surface types are seen to have distinctly different characteristics. Scattering coefficient measurements of the Amazon rain forest indicate the usefulness of this type of data as a stable calibration reference target.

Bracalente, E. M.

The SeaSat-A satellite scatterometer

This paper describes the methods used to develop performance requirements and design characteristics for the microwave scatterometer (SASS) ocean-surface wind sensor on the NASA SeaSat-A satellite. Wind vector measurement requirements from the SeaSat user community (wind speed and direction accuracy, resolution cell size, grid spacing, and swath width) define instrument characteristics. The resulting scatterometer is designed for 14.6 GHz using four fan beam antennas to measure wind speed and direction over a 1000-km swath width with a resolution cell size 50 x 50 km. Results show scatterometer accuracy satisfies user requirements for wind speed from 4 m/s to greater than 24 m/s for the nominal SeaSat-A orbit of 790 km altitude, 108 deg inclination, and 0.001 eccentricity.

Grantham, W. L.

Absolute calibration of the RADSCAT scatterometer using precision spheres

Tests using precision sphere targets suspended from balloons were conducted to calibrate the received-power/transmitted-power tatio of the RADSCAT scatterometer. Comparisons were made of these measured results with theoretical return from spheres. The RADSCAT scatterometer measurements at 13.9 GHz should be corrected by -2.4 dB, and those at 9.3 GHz, by -4.3 dB. The techniques described should be generally applicable to calibration of scatterometers where measurement precision is of prime importance. Inferred from the magnitude of these RADSCAT corrections was the present state of technology in building precision scatterometers.

Grantham, W. L.

The Seasat-A satellite scatterometer

This report describes the methods used to develop performance requirements and design characteristics of a microwave scatterometer wind sensor planned for Seasat-A. User requirements such as wind speed accuracy, resolution cell size, grid spacing, and swath width of the measurements formed the basis for defining instrument characteristics. Results are presented that show scatterometer accuracy as a function of orbit position satisfies User requirements for nominal orbit conditions.

Grantham, W. L.

Dual frequency scatterometer measurement of ocean wave height

A technique for remotely measuring wave height averaged over an area of the sea surface was developed and verified with a series of aircraft flight experiments. The measurement concept involves the cross correlation of the amplitude fluctuations of two monochromatic reflected signals with variable frequency separation. The signal reflected by the randomly distributed specular points on the surface is observed in the backscatter direction at nadir incidence angle. The measured correlation coefficient is equal to the square of the magnitude of the characteristic function of the specular point height from which RMS wave height can be determined. The flight scatterometer operates at 13.9 GHz and 13.9 - delta f GHz with a maximum delta f of 40 MHz. Measurements were conducted for low and moderate sea states at altitudes of 2, 5, and 10 thousand feet. The experimental results agree with the predicted decorrelation with frequency separation and with off-nadir incidence angle.

Johnson, J. W.

An operational satellite scatterometer for wind vector measurements over the ocean

Performance requirements and design characteristics of a microwave scatterometer wind sensor for measuring surface winds over the oceans on a global basis are described. Scatterometer specifications are developed from user requirements of wind vector measurement range and accuracy, swath width, resolution cell size and measurement grid spacing. A detailed analysis is performed for a baseline fan-beam scatterometer design, and its performance capabilities for meeting the SeaSat-A user requirements. Various modes of operation are discussed which will allow the resolution of questions concerning the effects of sea state on the scatterometer wind sensing ability and to verify design boundaries of the instrument.

Grantham, W. L.

Microwave scattering from the ocean surface

This paper is a review of current aircraft and satellite microwave remote sensing programs concerned with the measurement of ocean wave and surface wind conditions. These particular measurements have been identified by the user community as offering significant economic and technological benefits. Active microwave remote sensing techniques for these applications have been described theoretically and verified experimentally. The results of recent aircraft and satellite experimental programs are presented herein along with plans for the SeaSat-A Satellite Scatterometer.

Jones, W. L.

A dual frequency radar for ocean roughness sampling

A microwave technique for determining the roughness (rms wave height) of a randomly varying air-water interface has been developed theoretically, verified with laboratory wavetank studies and is currently being implemented for ocean surface measurements in a series of applications flight experiments. These aircraft observations will be near the Chesapeake Light Tower and will include a range of altitudes and sea conditions. The measurement concept involves cross-correlating the envelope fluctuations on two received carriers that are monochromatic when transmitted in a normal direction to the interface and are observed in a backscatter direction after reflection by the large number of randomly distributed specular points on the surface. The measured correlation coefficient (normalized covariance) as a function of carrier frequency separation will depend on the surface roughness, specifically the probability density function of the specular point height. Details of the flight system are discussed, and preliminary flight results are presented.

Weissman, D. E.

Antenna admittance determination of electron density.

A circular-aperture flush-mounted antenna for which a theoretical description of the antenna-plasma interaction has been developed was used to obtain a comparison between theoretical and experimental antenna admittance in the presence of ionized boundary layers of low-collision frequency. The antenna was located in a flat-plate model which was in turn located in the expanding-flow environment of a reflected-shock tunnel. The electron-temperature and electron-density distributions in the plate boundary layer at the antenna location were independently measured using voltage-swept thin-wire Langmuir probes for one of the test conditions. The antenna admittance was measured using a four-probe microwave reflectometer and these measured values were found to be in good agreement with those predicted from the theory. Measurements were also performed with another type of circular-aperture antenna which did not satisfy all of the constraints of the theoretical model, although good agreement was obtained between the calculations and the experimental results.

Dunn, M. G.