Engineering Papers⌕ Search

Engineering topics

Goodrich, W. D.

Publications and source records attributed to Goodrich, W. D..

27 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1974

Effects of selected trajectory parameters on weight trends in the shuttle thermal protection system

An empirical heating model, thermal protection system unit weight correlation, and trajectory analysis were used to develop a computation procedure for studying the sensitivity of thermal protection system weights to variations in pertinent trajectory parameters. The analytical techniques used in developing this computer program are described. Application of the analysis to a Space Shuttle Orbiter configuration was performed to demonstrate gross thermal protection system weight trends with selected entry trajectory parameters.

Curry, D. M.↗
NASA NTRS1972

On the numerical solution of two-dimensional, laminar compressible flows with imbedded shock waves.

The complete, time-dependent Navier-Stokes equations are expressed in conservation form and solved by employing an explicit finite difference numerical technique which incorporates artificial viscosity terms of the form first suggested by Rusanov for numerical stability in the vicinity of shock waves. Surface boundary conditions are developed in a consistent and unique manner through the use of a physically oriented extrapolation procedure. From numerical experimentation an extended range for the explicit stability parameter is established. Also employed is an additional convergence parameter which relates incremental spatial steps. Convergence of the transient solution to a steady state flow was obtained after 400 to 500 time steps.

Goodrich, W. D.↗
NASA NTRS1972

The aerothermodynamic environment of the Apollo command module during superorbital entry

Aerothermodynamic measurements were obtained on two Apollo spacecraft during atmospheric entry at near-lunar-return velocities. Histories of measured pressure and of convective and radiative heating rates are compared with theoretical predictions and with wind-tunnel results. The comparisons show that pressures measured in the wind tunnel correspond to those measured in the flight environment of the entry face. Unexplained low pressures were obtained on the conical section. Measured radiative heating rates agree with predictions calculated for both visible and infrared radiation. Good agreement was found between convective heating rates measured in flight and predictions obtained by using cold wall theory adjusted for mass injection from the ablator.

Lee, D. B.↗
NASA NTRS1972

Flow field measurements for space-shuttle-related cylindrical configurations in hypersonic streams.

Use of surface pressures, heat-transfer rates, and flow-visualization photographs to define the flowfields for simulated infinite cylinders. Four cylindrical cross sections were studied in the experimental program, which was conducted at free-stream Mach numbers of 5 to 15, free-stream unit Reynolds numbers from 2 to 20 million per foot, and angles of attack from 30 to 90 deg. Although swept-cylinder theory provides a reasonable correlation of the measured laminar heat-transfer rates in the plane of symmetry, improved correlation with the measurements is obtained if the three-dimensional nature of the flow is taken into account. In cases where the boundary layer on the windward forebody was turbulent, the large velocity gradients near the chines produced relaminarization of the boundary layer prior to separation. The average heat-transfer-rate in the separated region, which is weakly dependent on the free-stream conditions, was found to be a linear function of the angle of attack. For a given flow condition the effect of the leeward geometry on heat transfer can be correlated by a single geometric parameter which is dependent on the location of separation.

Bertin, J. J.↗
NASA NTRS1972

A viscous starter solution for shuttle flow field computations

A time dependent numerical procedure that calculates the viscous flow in the shock layer around the shuttle nose has been developed. It has been applied to the free stream conditions that may be encountered in the shuttle flight trajectory and found to be efficient and in satisfactory agreement with other steady and unsteady techniques. Two features associated with the present formulation are responsible for its successful applications. The first is that the flow field computation is made within the shock layer; the second is that the mapping of the computational region places proportionately more mesh points in the vicinity of the wall than in the remaining computational region. The numerical results may be used for low altitude flight to determine the edge conditions for a thin boundary layer, to provide initial boundary layer profiles for downstream boundary layer calculations, and to start supersonic computations. For high altitude flight, it may be used to determine the complete flow field in the nose region and also provide a starter solution for subsequent supersonic flow computations.

Li, C. P.↗
NASA NTRS1972

Aerothermodynamic measurements for space shuttle configuration in hypersonic wind tunnels

The effect of shuttle configuration geometry, angle of attack, and free stream flow conditions on the heat-transfer distribution as influenced by three-dimensional effects, the wing-fuselage shock-interaction, and resultant wing-impingement phenomena are examined. In addition, the data provided information regarding the flow field in the vicinity of the nose and boundary layer transition in the plane of symmetry of the fuselage. The data included measurements of the surface pressure, the heat transfer rate distributions, (using models instrumented with thermocouples and models painted with thermographic phosphor) and schlieren and shadowgraph photographs. Posttest photographs of the painted models supplemented the heat transfer data.

Bertin, J. J.↗