Engineering topics

Goldstein, R.

Publications and source records attributed to Goldstein, R..

At least 73 records · Page 4

NASA NTRS1987

The variation of protons, alpha particles, and the magnetic field across the bow shock of Comet Halley

Data from the Ion Mass Spectrometer and the magnetometer on the Giotto spacecraft are used to examine the structure of the inbound crossing of the Comet Halley bow shock on March 13, 1986. It is found that the velocity decrease, the field strength increase, and the heating of picked up cometary protons occurred over a broad region corresponding to several heavy-ion gyroradii. The solar-wind protons and alphas, on the other hand, were compressed and heated at a narrow structure on the leading edge of the broad shock region.

Neugebauer, M.↗

NASA NTRS1987

The ion mass spectrometer on Giotto

The design of the Giotto ion mass spectrometer (IMS) system, its calibration, and the initial flight performance are discussed. The IMS system consists of two sensors: one optimized for the outer coma, the other for the inner coma, with each sensor obtaining complementary information in the region for which it was not optimized. Both sensors feature mass-imaging characteristics, permitting simultaneous measurements of several ion species by means of multi-detector arrays, with resultant mass per charge resolution of not less than 20. In addition to mass per charge, the energy per charge and the elevation and azimuth of the incident ions were measured during the Giotto flight.

Balsiger, H.↗

NASA NTRS1987

Studies of multi-baseline spaceborne interferometric synthetic aperture radars

A set of Seasat SAR data that were obtained in nearly repeat ground track orbits is utilized to simulate the performance of spaceborne interferometric synthetic aperture radar (ISAR) systems. A qualitative assessment of the topography measurement capability is presented. A phase measurement error model is described and compared with the data obtained at various baseline separations and signal-to-noise ratios. Finally, the implications of these results on the future spaceborne ISAR design are discussed.

Li, F.↗

NASA NTRS1986

Hot ions observed by the Giotto ion mass spectrometer inside the Comet Halley contact surface

Just inside the contact surface (approx. 4700 km) the High Energy Range Spectrometer (HERS) sensor of the Giotto ion mass spectrometer detected a sudden, intense burst of ions that lasted until the HERS sensor ceased transmitting data at a distance 3000 km from comet Halley. During this interval ions with M/Q=1, 2, 12, 14, 16, 19, 24 and 28 were observed. The heavier ions appear in two populations (in the S/C frame): a very low energy, almost omnidirectional distribution, and a more energetic (approx. < ram speed) population coming from the ram direction. The low energy ions may belong to the natural Halley environment or be generated at the spacecraft by dust and gas bombardment. The ions may also be related to spacecraft charging processes on Giotto.

Goldstein, R.↗

NASA NTRS1986

Ion temperature and flow profiles in Comet Halley's close environment

The Giotto high intensity spectrometer identified the contact surface 4800 km from the comet nucleus. This boundary is clearly seen by a drastic drop in the temperatures of different ion species from 2000 K outside to values as low as 300 K inside. Inside the contact surface outflow speed = > 1 km/sec, in contrast to a value around 0 right outside. These numbers might be affected by a potential charge-up of the spacecraft. Outside the contact surface, the ion temperature rises gradually with increasing distance. Between 9000 and 10,000 km distance the ion density increases by a factor of 4. At 27,000 km distance there is again a rather abrupt jump to significantly higher temperatures, higher outflow speeds, and lower densities.

Schwenn, R.↗

NASA NTRS1986

Giotto-IMS observations of ion flow velocities and temperatures outside the contact surface of Comet Halley

Fluid parameters for He(++) ions obtained from the Giotto ion mass spectrometer are presented. Proton densities and velocities and thermal speeds of protons, alpha particles, and heavy ions in the hour before closest approach are discussed. A region of enhanced He(++) ion densities, and velocity, and decreased temperature is observed from 20:26 to 21:45. Sharp decreases in the proton density are observed at 23:30 and at 23:41. There is a relative flow velocity between alpha particles and oxygen ions of 30 km/sec during a period from 22:55 to 23:30; the difference in flow velocity is less than the experimental uncertainities. The flow properties of protons observed during this period are also discussed.

Goldstein, B. E.↗

NASA NTRS1986

Ion composition and dynamics at comet Halley

The Giotto space probe's ion mass spectrometer has obtained data on the composition and velocity distributions of cometary ions at distances of between 7.5 million and 1300 km from the comet Halley nucleus. Solar wind He(2+) was found throughout the coma, as close as 5000 km, with the He(+) produced by charge exchange being within about 200,000 km. A pile-up of heavy cometary ions was found at about 10,000 km from the nucleus. Inside the contact surface, which was found at about 4600 km, ion temperatures as low as about 340 K and outflow velocities of about 1 km/sec were found.

Balsiger, H.↗

NASA NTRS1986

Polarizing Filter for Integrated Optics

Polarizing filter for titanium-doped lithium niobate light waveguide suppresses transverse magnetic (TM) mode of light propagation while allowing transverse electric (TE) mode to continue on its way. Filter - lithium niobate crystal - is expected to find many applications in integrated optical circuits.

Ramer, O. G.↗

NASA NTRS1985

Bistatic Synthetic-Aperture Radar

Report describes synthetic-aperture radar that uses spaceborne transmitter and ground (or airborne) receiver to obtain imaging data in real time. System has applications in vessel navigation in open seas and polar ice regions, monitoring of wave and ice patterns near shores and oil platforms, and continuous monitoring of region with repeat time of few hours or less.

Elachi, C.↗

NASA NTRS1985

Optical-Fiber-Welding Machine

Technique yields joints with average transmissivity of 91.6 percent. Electric arc passed over butted fiber ends to melt them together. Maximum optical transmissivity of joint achieved with optimum choice of discharge current, translation speed, and axial compression of fibers. Practical welding machine enables delicate and tedious joining operation performed routinely.

Goss, W. C.↗

NASA NTRS1984

Ion mass spectrometer

An ion mass spectrometer is described which detects and indicates the characteristics of ions received over a wide angle, and which indicates the mass to charge ratio, the energy, and the direction of each detected ion. The spectrometer includes a magnetic analyzer having a sector magnet that passes ions received over a wide angle, and an electrostatic analyzer positioned to receive ions passing through the magnetic analyzer. The electrostatic analyzer includes a two dimensional ion sensor at one wall of the analyzer chamber, that senses not only the lengthwise position of the detected ion to indicate its mass to charge ratio, but also detects the ion position along the width of the chamber to indicate the direction in which the ion was traveling.

Neugebauer, M.↗

NASA NTRS1983

Integrated optics for fiber gyro's

Expected advantages of incorporating integrated optical waveguide components into fiber gyroscopes are summarized. The structural-simplicity benefits which can be achieved through the use of solid-state lasers, and integrated and fiber optics are examined; angular rate noise and random walk drift for the current technology in the 0.84-micron wavelength region are reported as 0.00001 deg/sec and 0.0002 deg/hr to the 1/2, respectively. The state-of-the-art in the pertinent materials research is reviewed; lithium niobate, suggested to be used as a waveguide substrate material, is noted to have a complex chemistry that is not yet fully understood. However, most of the optical and electrooptical components of a fiber gyro are conceptually understood and have been demonstrated.

Goss, W.↗

NASA NTRS1982

Energetic ion mass spectrometer

A new type of spectrometer for space application has been developed to measure separately mass/charge and the three-dimensional velocity distribution of incident ions. The instrument has relatively high resolution and allows rapid measurement of the four-dimensional set of mass/charge, speed, elevation angle, and azimuth angle. The instrument includes a sector magnet, an electrostatic deflector, microchannel plate detectors with position sensitive readout, and a set of grids with variable applied voltage.

Neugebauer, M.↗

NASA NTRS1982

Advanced techniques for plasma composition and dynamics measurements

The current state of knowledge regarding the space plasma is briefly considered. It is found that certain problems arise in connection with conventional measurements. In many cases, three-dimensional measurements are needed and a good time resolution. The present investigation has the objective to review developments related to energetic ion mass spectrometers which are capable of resolving some of the ambiguities. The employment of electrostatic analyzers (ESA) combined with velocity filters is considered, taking into account an instrument which combines a quadrispherical electrostatic analyzer with electromagnetic filters. Such an instrument is being developed for the Galileo Mission to Jupiter. In connection with an evaluation of developments concerning linear and two-dimensional mass spectrometers, attention is given to instruments which are capable of measuring several masses simultaneously. Instruments utilizing the time of flight technique of measuring mass are also examined.

Goldstein, R.↗

NASA NTRS1981

Optical gyroscope system

Light beams pass in opposite directions through a single mode fiber optic wave guide that extends in a circle or coil in an optical gyroscope system which measures the rotation rate of the coil by measuring the relative phase shifts of the beams by interferometric techniques. Beam splitting and phase shifting of the light are facilitated by utilizing brief pulses of light and by using light-controlling devices which are operated for a brief time only when the light pulse passes in one direction through the device but not at a different time when the pulse is passing in the opposite direction through the device. High accuracy in rotation measurement is achieved at both very slow and very fast rotation rates, by alternately operating the system so that at zero rotation the interfering waves are alternately 90 out of phase and in phase. Linear polarization of the light beams is maintained by coiling the full length of the optic fiber in a single plane.

Goss, W. C.↗

NASA NTRS1981

Spaceborne bistatic synthetic aperture imaging radar

The properties of two configurations for a spaceborne bistatic SAR are examined and compared with the properties of a monostatic SAR. The two bistatic configurations considered are a system consisting of an orbiting spaceborne transmitter and a ground receiver and a system consisting of a transmitter on a geostationary satellite and a receiver or receivers on an airborne platform. The properties discussed or analyzed include imaging coordinate system, azimuth and range resolution, azimuth and range ambiguities, and swath width.

Elachi, C.↗

NASA NTRS1980

Fiber-optic rotation sensor technology

A concept for an all-waveguide fiber-optic rotation sensor is discussed, and the results of preliminary tests of key elements are described. A single channel waveguide coupler design provides the functions of an optical switch, a 3-dB beam splitter, a phase retarder, and a signal modulator, all of which may be formed on the same chip and interconnected by channel single-mode waveguides. Preliminary test results for the waveguide coupler and for a rotation sensor without the coupler are presented. Signal processing, polarization control, and interconnection of the waveguide components are discussed.

Goss, W. C.↗

NASA NTRS1979

Splicing single-mode optical fibers

Approach used to weld multimode fibers has been adapted for more exacting splicing of single-mode fibers. Precision cleaver with tungsten carbide knife edge cuts single-mode optical fibers for welding. Welding apparatus includes micromanipulator, microscopes, and vacuum chucks.

Goldstein, R.↗