Engineering Papers⌕ Search

Engineering topics

Goldstein, R. J.

Publications and source records attributed to Goldstein, R. J..

13 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Flow and temperature fields following injection of a jet normal to a cross stream

The interaction of a jet entering into a freestream normal to the main flow direction has been studied with particular attention directed to visualization of the large-scale flow interactions and to measurement of the film-cooling performance. Large eddies are apparent downstream of the entering jet even at moderate blowing rate (defined as the ratio of the mass velocity of the jet to the mass velocity of the freestream). At higher blowing rate, there is only intermittent contact between the mass from the jet and the downstream wall. The film cooling downstream from a single normal jet yields a lower centerline effectiveness compared to an inclined jet through a greater lateral spreading. The greater spreading provides a more uniform effectiveness across the span of the downstream wall, in particular at large blowing rate.

Goldstein, R. J.↗
NASA NTRS1974

Heat transfer and film cooling following injection through inclined circular tubes

Film cooling effectiveness and heat transfer are measured downstream of injection through discrete holes into a turbulent mainstream boundary layer. Air is injected through both a single hole and a row of holes spaced at three-diameter intervals and inclined at an angle of 35 deg to the main flow. There is little difference between the heat transfer coefficient with blowing and without blowing at low blowing rates (mass flux ratios). In fact, at low blowing rates, injection is found to decrease somewhat the heat transfer coefficient from that measured without blowing. As the mass flux ratio increases past unity, the heat transfer coefficient increases, especially with injection through a row of holes. The peak heat transfer is usually found at the edge of the spreading jets (i.e., between two holes). At a blowing rate near two, the lateral average of the heat transfer is as much as 27 percent higher than the heat transfer with no blowing. The increase in heat transfer is attributed to the interaction between the jets and the free stream, causing high levels of turbulence.

Eriksen, V. L.↗
NASA NTRS1971

A model for analysis of the temperature field downstream of a heated jet injected into an isothermal crossflow at an angle of 90 deg

The temperature distribution downstream of a heated jet entering an isothermal crossflow at an angle of 90 deg is predicted using two conduction models with energy sources above the point of injection, in one case a point source and in the second a line source. The models use effective turbulent diffusivities that are determined empirically from previous measurements. Temperatures predicted by the models are compared to experimental results.

Eriksen, V. L.↗