Engineering topics
Publications and source records attributed to Gilhousen, K. S..
Spread-spectrum code division multiple access (CDMA) and single channel per carrier frequency division multiple access (FDMA) systems are compared for spectrum efficiency. CDMA is shown to have greater maximum throughput than FDMA for the MobileStar(sm) system which uses digital voice activated carriers and directive circularly polarized satellite antennas.
Operation of sequential decoding of data at high rates using Fano algorithm is discussed. Actions followed by decoder in systematically searching branches are described. Technique of diagonal steps is explained and illustrated.
The state of efficiency improvement available with high speed decoders presently in operation or under development is summarized. The required ratio of bit-energy-to-noise-density is given in each case for bit error probabilities.
Description of a 40-megabit-per-second hard decision sequential decoder which employs the fastest commercially available digital integrated circuits - MECL III. With this decoder an internal computational rate of 70,000,000 computations per second has been achieved. The computational efficiency of the decoding algorithm has been improved by incorporating two modifications to the Fano algorithm - namely, 'double quick threshold loosening' and 'diagonal steps.' On the basis of preliminary results, an output error rate of 0.00001 can be achieved with E sub b/N sub zero less than 5.4 dB at data rates up to 40 megabits per second. The very high internal operating speed of the decoder represents a factor of five increase in speed over any previous sequential decoder.
Description of a 40-Mbps hard-decision sequential decoder for high-data-rate coding systems for earth-orbiting space missions with power-limited links. A prototype decoder has been designed and fabricated using the fastest commercially available digital integrated circuits, MECL III. Thus far, an internal computational rate of 70 million computations per second has been achieved. Computational efficiency of the decoding algorithm was greatly improved by incorporating two modifications to the Fano algorithm - 'double quick threshold loosening' and 'diagonal steps.' Preliminary results indicate that an output error rate of 0.00001 can be achieved with E sub b/N sub zero less than 5.4 dB at data rates up to 40 Mbps. At lower data rates, even less signal energy is required. This decoder is believed to be at least five times faster than any previous sequential decoder.