Engineering topics
Publications and source records attributed to Gibson, John.
Proposed fixture for mounting large ball bearings during tests facilitates application of variable, known radial loads, and prevent gross movement of bearing radial or axial directions. Load applied through Belleville spring washers to collar restrained by carrier ring. Load applied smoothly because collar and outer race of bearing flex in carrier ring. Inner race mounted on shaft rotated during application load.
A process to pattern slots approximately 1.25 microns in width into 25-micron-thick W films that have been deposited onto flat or concave surfaces is discussed. A 25-micron-thick W film with a high degree of (100) orientation is chemically vapor deposited (CVD) onto a flat or concave Mo mandrel. A 5-micron-thick Al film is deposited onto the CVD W, followed by 2 microns of photoresist. On concave cathodes, XeCl2 laser ablation or X-ray lithography is used to pattern the photoresist, whereas on flat cathodes deep UV lithography can be used. The patterned photoresist serves as the mask in a Cl ion-beam-assisted etching (IBAE) process to pattern the Al. An alternative process is to deposit Al2O3 films onto the W and pattern the Al2O3 using laser ablation. The W film is then patterned to 3-6-micron slot widths using IBAE + ClF3 with the patterned Al or Al2O3 as the mask. Finally, a sputter deposition step is required to close up the slots to approximately 1 micron. The process described is capable of patterning concave dispenser cathodes to a controlled and precise porosity.