Engineering topics

Gerlach, John C.

Publications and source records attributed to Gerlach, John C..

9 records

NASA NTRS2002

Mesospheric Temperature Structure during the GUARA Campaign and Comparison with the DROPPS and MaCWAVE Campaigns

A significant number of passive inflatable falling spheres launched from Alcantara, Brazil (2S) during the MALTED campaign in August 1994 showed unusual temperature layering at 70 and 85 km, Reprocessing of the original radar position data reveal more consistent temperature inversions over time than was observed during the DROPPS campaign conducted from northern Scandinavia during July 1999. Comparison between falling sphere measurements and the HALOE instrument on UARS provides a now perspective about the atmospheric structure at two widely separated locations. The availability of NASA and Brazilian C-band radars established high confidence in the data quality during MALTED. A new campaign, MaCWAVE scheduled this summer from Andoys, Rocket Range, Norway (67N) will provide characteristics of gravity wave activity that will be compared with the MALTED temperature and wind profiles.

Schmidlin, F. J.↗

NASA NTRS2001

Bathymetric Effects on a Tropical Cyclone Wave Field at Landfall

On 26 August 1998, the NASA Scanning Radar Altimeter (SRA) flew aboard one of the WP-3D hurricane research aircraft to document the sea surface directional wave spectrum in the region between Charleston, SC and Cape Hatteras, NC, as Bonnie, a large Category 3 hurricane, was making landfall near Wilmington, NC. Two days earlier, the SRA had documented the wave field spatial variation in open water when Hurricane Bonnie was 400 km east of Abaco Island, Bahamas. Bonnie was similar in size during the two flights, but the maximum speed in the NOAA Hurricane Research Division surface wind analysis was 15% lower prior to landfall (39 m/s) than it had been in the open ocean (46 m/s). This was compensated for by its faster movement prior to landfall (9.5 m/s) than when it was encountered in the open ocean (5 m/s). The slower movement matched the group velocity of waves of 65 m length, so waves at the peak of the spectrum outdistanced the storm as soon as they were generated. The higher translation speed prior to landfall matched the group velocity of waves of 230 m length, significantly increasing the effective fetch and duration of waves near the peak of the spectrum which propagated in the direction of the storm track. The open ocean wave height variation indicated that Hurricane Bonnie would have produced waves of 11 m significant wave height on the shore northeast of Wilmington had it not been for the continental shelf. The bathymetry distributed the steepening and breaking process across the shelf so that the wavelength and wave height were reduced gradually as the shore was approached. The wave height 5 km from shore was about 4 m.

Wright, C. W.↗

NASA NTRS2001

Validating the use of Satellite SAR for Measuring Small-Scale Surface Wind Variations

We present aircraft measurements of near-surface atmospheric boundary layer roll signatures and radar-derived sea surface roughness. The open-ocean data were collected at an altitude of 20 m using NOAA's Long-EZ aircraft. In addition, the flight was coincident with a RADARSAT SAR overpass where presumed boundary layer roll impacts are prevalent in the SAR backscatter image. The Long-EZ air and sea data are completely coincident in space and time and this unique feature allows us to validate the supposed link between SAR backscatter signatures and organized large eddy surface impacts. We find remarkable correlation between measured modulations in the along-wind component of wind speed and radar backscatter for the atmospheric eddy scale of 1 to 1.5 km. Close agreement between normalized modulation amplitudes suggests the radar-inferred surface slope variance is changing linearly with wind speed. Implications for SAR usage in coastal regions and for boundary layer study will be discussed.

Vandemark, Douglas↗

NASA NTRS2001

Chloroplast Ultrastructure of the Alga Phaeocystis antarctica Karsten: A New Structural Model Using Electron Tomography

Understanding the light-harvesting properties of algae and higher plants are a fundamental topic in photosynthesis research. Using thick sections obtained from fixed and embedded cultures of colonial P antarctica, we calculate tomographic reconstructions of individual chloroplasts under light-limiting and saturating conditions for net photosynthesis. Our goal is to gain an understanding of the continuity of thylakoid membranes and understand the spatial relationship between the pyrenoid, the starch containing organelle, and thylakoid membranes. We found that Phaeocystis showed considerable morphological and physiological flexibility in response to environmental light levels. We found that the thylakoids generally run parallel to the chloroplast membrane with many junctures and bifurcations, many of which are in contact with the chloroplast membrane itself. The considerable flexibility in the. thylakoid membranes allows for the accommodation of the pyrenoid structure. The arrangement of the thylakoids within these structures resemble those found in new structures of mitochondria cristae. We present a new structural model for algal chloroplasts which greatly revises current concepts of thylakoid membrane structure in relation to photoacclimation.

Moisan, Tiffany A.↗

NASA NTRS2001

HALOE Temperature Data Comparison with Rocket-Borne Falling Sphere Temperatures

Recent comparison of upper stratospheric and mesospheric temperatures measured with the HALOE instrument on UARS and the rocket-borne passive inflatable falling sphere launched from Wallops Island reveals a temperature bias of up to 10 K between about 66 and 72 km. Falling sphere measurements analyzed between 1991 and 1995 were used in the comparison, however, these measurements were processed with an earlier version of the reduction software that included temperature bias in the region of 70 km. The bias arose from a discontinuity in the falling sphere drag table. This discontinuity occurs when the sphere's fall velocity changes from the supersonic to the subsonic flow regime and has been called the MACH 1 problem. Improvement to the software employed and the availability of a new atmospheric model is now used to initiate reduction of the radar tracking data. It is possible new reduction of the existing data will reduce the bias currently observed. We plan to show changes, if any, in the size of the bias between HALOE and the falling sphere temperatures after reprocessing of the sphere measurements.

Schmidlin, F. J.↗

NASA NTRS2001

ECC Ozonesonde Reliability, Observations, and Comparisons with Satellite Ozone Instruments

Electrochemical Concentration Cell (ECC) ozone instruments depend on the quality of care exercised in their pre-flight preparation. The ozone-measuring project conducted at Goddard Space Flight Center's Wallops Flight Facility uses a number of mechanisms designed to inspect the ECC for anomalies that may interfere with the reception of valid ozone profiles. Complete electronic testing of the instrument, individually and when coupled to its radiosonde has led to exceptional monitoring of ozone for detecting long-term atmospheric changes. A number of factors are considered when preparing an ECC instrument for flight. These basically are specific calibrations of pump efficiency, volumetric flow rate, temperature of the air entering the pump, and background current. The concentration of the potassium iodide solution is also important. Wallops is the only site using a UV photometer (Dasibi) to compare ECC ozone output at various concentrations of ozone that allows adjustment to be made to offsets that may appear in the balloon-borne instrument prior to release. All of the above procedures allow identification of potential problems before release of the ECC instrument. Procedures followed at Wallops also are employed in Brazil, and Ascension Island where NASA has cooperative agreements in place to obtain ozonesondes data. All ECC instruments are prepared 3-4 weeks prior to the day of observation. We will briefly describe the instrumental tests employed. These tests have included simultaneous dual observations to compare the effect of different solution concentrations, comparison of sensors of different manufacturers, and comparisons with surface- and space-based instrumentation such as the Dobson Spectrophotometer and satellites. Vertical profiles of ozone from Arctic, mid-latitudes, and Antarctica will be discussed. Although not unusual, the data reveals ozone structure that correlate well with typical atmospheric temperatures and possibly relative humidity. Finally, vertical ozone distribution, compared with remotely measured ozone from lidar and satellite, will be discussed. Specific comparisons between ECC and HALOE measurements, integrated ECC total ozone overburden with the EP-TOMS and the Dobson, as well as comparisons with lidar are discussed. Results show agreement and some disagreement between the in situ measurements of the ECC and the remote instruments. We postulate reasons for the differences, or biases, which in spite of the excellent ECC quality control during pre-flight preparation and data analysis processes, may be due to uncertainties in both measuring systems.

Schmidlin, F. J.↗

NASA NTRS2001

A Characterization of Vertical Ozonesonde Measurements at the Equatorial Locations of SHADOZ

Beginning in 1997 ozonesonde observations have been obtained from Equatorial locations participating in SHADOZ (Southern Hemisphere Additional Ozone) Project. Vertical ozone profiles are available from the western Pacific eastward to Kenya. Presently 10 stations provide vertical ECC ozonesonde measurements at least weekly. Statistical analysis shows the variation that occurs in the level of maximum ozone, the difference between integrated total ozone overburden from ECC and EP-TOMS observations, and with Dobson Spectrophotometers, when data are available.

Schmidlin, F. J.↗

NASA NTRS2001

Observations of Sea Surface Mean Square Slope During the Southern Ocean Waves Experiment

For the Southern Ocean Waves Experiment (SOWEX), conducted in June 1992 out of Hobart, Tasmania, the NASA Scanning Radar Altimeter (SRA) was shipped to Australia and installed on a CSIRO Fokker F-27 research aircraft instrumented to make comprehensive surface layer measurements of air-sea interaction fluxes. The SRA sweeps a radar beam of P (two-way) half-power width across the aircraft ground track over a swath equal to 0.8 of the aircraft height, simultaneously measuring the backscattered power at its 36 GHz (8.3 mm) operating frequency and the range to the sea surface at 64 cross-track positions. In realtime, the slant ranges are multiplied by the cosine of the off-nadir incidence angles (including the effect of aircraft roll attitude) to determine the vertical distances from the aircraft to the sea surface. These distances are subtracted from the aircraft height to produce a sea-surface elevation map, which is displayed on a monitor in the aircraft to enable real-time assessments of data quality and wave properties. The sea surface mean square slope (mss), which is predominantly caused by the short waves, was determined from the backscattered power falloff with incidence angle measured by the SRA in the plane normal to the aircraft heading. On each flight, data were acquired at 240 m altitude while the aircraft was in a 7 degree roll attitude, interrogating off-nadir incidence angles from -15 degrees through nadir to +29 degrees. The aircraft turned azimuthally through 810 degrees in this attitude, mapping the azimuthal dependence of the backscattered power falloff with incidence angle. Two sets of turning data were acquired on each day, before and after the aircraft measured wind stress at low altitude (12 meters to 65 meters). Wave topography and backscattered power for mss were also acquired during those level flight segments whenever the aircraft altitude was above the SRA minimum range of 35 m. Data were collected over a wide range of wind and sea conditions, from quiescent to gale force winds with 9 meter wave height.

Walsh, E. J.↗

NASA NTRS2001

Data Comparison: Satellite and Falling Sphere Temperatures

Small meteorological rocketsondes providing temperature data have beam used for comparison with, and validation of measurements from satellite-borne instruments. A significant number of rocket-borne falling spheres were launched in conjunction with the Upper Atmosphere Research Satellite (UARS) for validation of the Halogen Occultation Experiment (HALOE), High Resolution Doppler Interferometer (HRDI), and the Microwave Limb Sounder (MLS) instruments. Upper stratosphere and mesosphere temperatures measured with these instruments on UARS are compared with inflatable spheres launched from Wallops Island (1992-1999), Brazil (1994), Hawaii (1992), Norway (1992), and Sweden (1993 and 1996). Time and space differences varied between the satellite measurement and the rocketsonde launch, for example HALOE overpasses occurred within 5 days and in some cases there were spatial differences of up to 30 degrees longitude. Validation measurements of the HRDI instrument occurred at Wallops Island when it passed within 20 minutes and 330 kilometers of the launch site. Because of discontinuity in the falling sphere drag coefficients when fall speed neared MACH 1 falling sphere temperatures near 70 kilometers attitude are biased toward lower temperatures. Availability of improved software and a new atmospheric model have helped to reduce this bias. The validated remote instrument measurements permit a new perspective of atmospheric structure to be formed, not always possible with the limited number of falling sphere measurements. Features of the remote measurement temperature profiles and their possible use to extend the climatological data base at the rocketsonde sites will be discussed.

Schmidlin, Francis J.↗