Engineering Papers⌕ Search

Engineering topics

Gehin, Jess C.

Publications and source records attributed to Gehin, Jess C..

21 records · Page 2

Categorization of Used Nuclear Fuel Inventory in Support of a Comprehensive National Nuclear Fuel Cycle Strategy - 13575

A technical assessment of the current inventory [∼70,150 metric tons of heavy metal (MTHM) as of 2011] of U.S.-discharged used nuclear fuel (UNF) has been performed to support decisions regarding fuel cycle strategies and research, development and demonstration (RD and D) needs. The assessment considered discharged UNF from commercial nuclear electricity generation and defense and research programs and determined that the current UNF inventory can be divided into the following three categories: 1. Disposal - excess material that is not needed for other purposes; 2. Research - material needed for RD and D purposes to support waste management (e.g., UNF storage, transportation, and disposal) and development of alternative fuel cycles (e.g., separations and advanced fuels/reactors); and 3. Recycle/Recovery - material with inherent and/or strategic value. A set of key assumptions and attributes relative to the various disposition options were used to categorize the current UNF inventory. Based on consideration of RD and D needs, time frames and material needs for deployment of alternative fuel cycles, characteristics of the current UNF inventory, and possible uses to support national security interests, it was determined that the vast majority of the current UNF inventory should be placed in the Disposal category, without the need to make fuel retrievable from disposal for reuse or research purposes. Access to the material in the Research and Recycle/Recovery categories should be retained to support RD and D needs and national security interests. This assessment does not assume any decision about future fuel cycle options or preclude any potential options, including those with potential recycling of commercial UNF. (authors)

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

Proposed Test Stand Selection Criteria

The Consortium for Advanced Simulation of Light Water Reactors (CASL) is developing modeling and simulation capabilities to provide predictive performance of reactors with a specific focus on several challenge problems to support power uprates, life extension, and use of higher burnup fuels. A critical element of the success of the CASL M&S hub will be the ability to transfer the technology (both methods and software) developed by CASL to external stakeholders (including the industry, regulatory and research communities) and for these stakeholders to apply these methods and tools to address critical issues related to the long-term efficient and safe operation of commercial NPPs. An important element to enable the achievement of this objective is the development and deployment of industry Test Stands, which are intended to serve as a primary mechanism for initial deployment of CASL developed technology to these stakeholders.

22 GENERAL STUDIES OF NUCLEAR REACTORS↗

Development and Validation of Scale Nuclear Analysis Methods for High Temperature Gas-Cooled Reactors

In support of the U.S. Nuclear Regulatory Commission, ORNL is updating the nuclear analysis methods and data in the SCALE code system to support modeling of HTGRs. Development activities include methods used for reactor physics, criticality safety, and radiation shielding. This paper focuses on the nuclear methods in support of reactor physics, which primarily include lattice physics for cross-section processing of both prismatic and pebble-bed designs, Monte Carlo depletion methods and efficiency improvements for double heterogeneous fuels, and validation against relevant experiments. These methods enhancements are being validated using available experimental data from the HTTR and HTR-10 startup and initial criticality experiments. Results obtained with three-dimensional Monte Carlo models of the HTTR initial core critical configurations with SCALE6/KENO show excellent agreement between the continuous energy and multigroup methods and the results are consistent with results obtained by others. A three-dimensional multigroup Monte Carlo model for the initial critical core of the HTR-10 has been developed with SCALE6/KENO based on the benchmark specifications included in the IRPhE Handbook. The core eigenvalue obtained with this model is in very good agreement with the corresponding value obtained with a consistent continuous energy MCNP5 core model.

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗