Engineering Papers⌕ Search

Engineering topics

Frew, J.

Publications and source records attributed to Frew, J..

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1984

Registering Thematic Mapper imagery to digital elevation models

The problems encountered when attempting to register Landsat Thematic Mapper (TM) data to U.S. geological survey digital elevation models (DEMs) are examined. It is shown that TM and DEM data are not available in the same map projection, necessitating geometric transformation of one of the data type, that the TM data are not accurately located in their nominal projection, and that TM data have higher resolution than most DEM data, but oversampling the DEM data to TM resolution introduces systematic noise. Further work needed in this area is discussed.

Frew, J.↗
NASA NTRS1983

Automated basin delineation from digital terrain data

While digital terrain grids are now in wide use, accurate delineation of drainage basins from these data is difficult to efficiently automate. A recursive order N solution to this problem is presented. The algorithm is fast because no point in the basin is checked more than once, and no points outside the basin are considered. Two applications for terrain analysis and one for remote sensing are given to illustrate the method, on a basin with high relief in the Sierra Nevada. This technique for automated basin delineation will enhance the utility of digital terrain analysis for hydrologic modeling and remote sensing.

Marks, D.↗
NASA NTRS1981

Atmospheric corrections to satellite radiometric data over rugged terrain

Radiometric measurements from satellites in the solar portion of the electromagnetic spectrum can be converted to measurements of surface exitance. Over rugged terrain, the satellite image must be precisely registered to a terrain data set. For small areas a first-order polynomial interpolation scheme is generally satisfactory for the geometric rectification. If there are saturated pixels, a nearest-neighbor procedure is used for the interpolated satellite radiance numbers; otherwise a cubic-convolution algorithm is used. Path radiance and path transmittance are calculated with a simple spectral model, which requires an estimate of the water vapor and aerosol content of the atmosphere.

Dozier, J.↗
NASA NTRS1978

Remote sensing applications to hydrologic modeling in the southern Sierra Nevada and portions of the San Joaquin Valley, volume 1

The author has identified the following significant results. Characteristics of LANDSAT MSS imagery present problems in using satellite radiation measurements to estimate the shortwave albedo of an alpine snow cover. Every 15 minute USGS quadrangle contains over 100,000 pixels which poses a computation problem if each pixel is to be evaluated individually. The sampling interval may be sufficiently great to mask some effects of terrain and vegetation on reflectance. Three frames of LANDSAT imagery are needed for complete coverage of the study area, yet less than one third of the area coverage from each frame covers an area of interest. Because of distortions inherent in the imagery, information regarding spacecraft altitude, attitude, and position must be statistically derived with respect to ground control points in the image whose geodetic locations are known. An inspection of shade points indicates that up to one third of the most heavily snow covered areas may saturate in bands 4 through 6. LANDSAT's 9 day repeat cycle is not optimum for snow cover reflectance modeling because the most pronounced changes in albedo occur most nearly following a new snowfall. Such a snowfall, occurring between overpasses, is inadequately represented by extrapolation from the previous overpasses.

Dozier, J.↗
NASA NTRS1977

Remote sensing applications to hydrologic modeling

An energy balance snowmelt model for rugged terrain was devised and coupled to a flow model. A literature review of remote sensing applications to hydrologic modeling was included along with a software development outline.

Dozier, J.↗