Engineering Papers⌕ Search

Engineering topics

Franklin, J. A.

Publications and source records attributed to Franklin, J. A..

At least 19 records

The fate of atmospheric phosgene and the stratospheric chlorine loadings of its parent compounds: CCl4, C2Cl4, C2HCL3, CH3CCl3, and CHCl3

A study of the tropospheric and stratospheric cycles of phosgene is carried out to determine its fate and ultimate role in controlling the ozone depletion potentials of its parent compounds. Tropospheric phosgene is produced from the OH-initiated oxidation of C2Cl4, CH3CCl3, CHCl3, and C2HCl3. Simulations using a two-dimensional model indicate that these processes produce about 90 pptv/yr of tropospheric phosgene with an average concentration of about 18 pptv, in reasonable agreement with observations. We estimate a residence time of about 70 days for tropospheric phosgene, with the vast majority being removed by hydrolysis in cloudwater. Only about 0.4% of the phosgene produced in the troposphere avoids wet removal and is transported to the stratosphere, where its chlorine can be released to participate in the catalytic destruction of ozone. Stratospheric phosgene is produced from the photochemical degradation of CCl4, C2Cl4, CHCl3, and CH3CCl3 and is removed by photolysis and downward transport to the troposphere. Model calculations, in good agreement with observations, indicate that these processes produce a peak stratospheric concentration of about 25-30 pptv at an altitude of about 25 km. In contrast to tropospheric phosgene, stratospheric phosgene is found to have a lifetime against photochemical removal of the order of years. As a result, a significant portion of the phosgene that is produced in the stratosphere is ultimately returned to the troposphere, where it is rapidly removed by clouds. This phenomenon effectively decreases the amount of reactive chlorine injected into the stratosphere and available for ozone depletion from phosgene's parent compounds. A similar phenomenon due to the downward transport of stratospheric COFCl produced from CFC-11 is estimated to cause a 7% decrease in the amount of reactive chlorine injected into the stratosphere from this compound. Our results are potentially sensitive to a variety of parameters, most notably the rate of reaction of phosgene with sulfate aerosols. However, on the basis of the observed vertical distribution of COCl2, we estimate that the reaction of COCl2 with sulfate aerosol most likely has a gamma less than 5 x 10(exp -5) and, as a result, has a negligible impact on the stratospheric chlorine loadings of the phosgene parent compounds.

Kindler, T. P.↗

Piloted simulation evaluation of pitch control designs for highly augmented STOVL aircraft

Analyses of design variations on a pitch axis stabilization and command augmentation system (SCAS) for a STOVL fighter aircraft are performed in a moving base simulation experiment. The primary goal of this study is to determine if turbulence-induced control activity could be reduced by modifying SCAS parameters while keeping the response-to-command characteristics of the baseline system that provide Level 1 flying qualities. Pilot ratings and control utilization statistics for the baseline system are in agreement with similar data gathered in a prior simulation test involving the same aircraft and control system.

Engelland, S. A.↗

Collaborative research on V/STOL control system/cockpit display tradeoffs under the NASA/MOD joint aeronautical program

Summarized here are activities that have taken place from 1979 to the present in a collaborative program between NASA Ames Research Center and the Royal Aerospace Establishment (now Defence Research Agency), Bedford on flight control system and cockpit display tradeoffs for low-speed and hover operations of future V/STOL aircraft. This program was created as Task 8A of the Joint Aeronautical Program between NASA in the United States and the Ministry of Defence (Procurement Executive) in the United Kingdom. The program was initiated based on a recognition by both parties of the strengths of the efforts of their counterparts and a desire to participate jointly in future simulation and flight experiments. In the ensuing years, teams of NASA and RAE engineers and pilots have participated in each other's simulation experiments to evaluate control and display concepts and define design requirements for research aircraft. Both organizations possess Harrier airframes that have undergone extensive modification to provide in-flight research capabilities in the subject areas. Both NASA and RAE have profited by exchanges of control/display concepts, design criteria, fabrication techniques, software development and validation, installation details, and ground and flight clearance techniques for their respective aircraft. This collaboration has permitted the two organizations to achieve jointly substantially more during the period than if they had worked independently. The two organizations are now entering the phase of flight research for the collaborative program as currently defined.

Franklin, J. A.↗

Powered-lift aircraft technology

Powered lift aircraft have the ability to vary the magnitude and direction of the force produced by the propulsion system so as to control the overall lift and streamwise force components of the aircraft, with the objective of enabling the aircraft to operate from minimum sized terminal sites. Power lift technology has contributed to the development of the jet lift Harrier and to the forth coming operational V-22 Tilt Rotor and the C-17 military transport. This technology will soon be expanded to include supersonic fighters with short takeoff and vertical landing capability, and will continue to be used for the development of short- and vertical-takeoff and landing transport. An overview of this field of aeronautical technology is provided for several types of powered lift aircraft. It focuses on the description of various powered lift concepts and their operational capability. Aspects of aerodynamics and flight controls pertinent to powered lift are also discussed.

Deckert, W. H.↗

Flight evaluation of augmented controls for approach and landing of powered-lift aircraft

Flight experiments were conducted with Ames Research Center's Quiet Short-Haul Research Aircraft to evaluate the influence of highly augmented control modes on the ability of pilots to execute precision instrument flight operations in the terminal area, particularly approaches to and landings on a short runway. The aircraft is a powered-lift, short-takeoff and landing configuration that is equipped with a modern digital fly-by-wire flight control system, a head-up display, and a solar head-down display that make it possible to investigate control concepts and display format and content for full envelope, powered-lift operations. Considerable attention has been devoted in this flight program to assessing flightpath and airspeed command and stabilization modes developed using nonlinear, inverse model-following methods. The primary benefit of this control concept was realized when the pilot was required to execute a complex transition and approach under instrument conditions and in the presence of a wide range of wind and turbulence conditions.

Franklin, J. A.↗

Control of V/STOL aircraft

This paper deals with control of V/STOL aircraft in powered-lift flight. A review of representative operational mission tasks is presented for the take-off, transition, hover and landing flight phases. Characteristics inherent in the basic airframe and propulsion system and the behavior associated with control augmentation systems are considered. Demands for augmented stability and control response to meet certain mission operational requirements are discussed. Experience from ground-based simulation and flight experiments that illustrates the impact of augmented stability and control on aircraft design is related by example.

Franklin, J. A.↗

Control and display requirements for decelerating approach and landing of fixed- and rotary-wing VSTOL aircraft

This paper reviews the results of several simulation investigations of rotary-wing and fixed-wing VSTOL aircraft performing terminal-area operations that include decelerating approaches under instrument conditions and recovery to either fixed landing pads or a ship. By concentrating on instrument decelerating approaches and the hover and landing, it is possible to compare directly the control and display requirements for similar tasks for aircraft with and without vectored thrust capability. Collectively, the results from these experiments, together with other simulator and flight experiments and operational experience, provide a consistent view of control and display complexity required for similar operational capability in adverse weather for the two types of VSTOL configurations. Some initial data showing influence of the transition corridor on flying qualities during transition are pesented and lead to a general discussion of the problem of operating margin definition.

Lebacqz, J. V.↗

Powered-lift technology on the threshold

A design configuration study and comparative performance evaluation is presented for current and planned V/STOL military aircraft and their powerplant and control systems, with a view to the effect of the operational capabilities uniquely furnished by such aircraft for battlefield tactics. Attention is given to V/STOL naval aircraft and the carrier or ship's deck conditions under which they must be able to operate. Thrust-vectoring and tilt rotor configurations are the most prominent among successful experimental and operational aircraft of this type; cargo aircraft have most often incorporated short/rough airfield operation capabilities rather than full VTOL. A major development thrust has been mounted for a supersonic short takeoff/vertical landing aircraft.

Deckert, W. H.↗

Flight evaluation of highly augmented controls and electronic displays for precision approach and landing of powered-lift aircraft

Experiments were conducted on simulators and on the Quiet Short-Haul Research Aircraft to evaluate the effect of highly augmented control modes and electronic displays on the ability of pilots to execute precision approaches and landings on a short runway. It is found that the primary benefits of highly augmented flightpath and airspeed controls and electronic displays are realized when the pilot is required to execute precisely a complex transition and approach under instrument conditions and in the presence of a wide range of wind and turbulence conditions. A flightpath and airspeed command and stabilization system incorporating nonlinear, inverse system concepts produced fully satisfactory flightpath control throughout the aircraft's terminal operating envelope.

Franklin, J. A.↗

V/STOL maneuverability and control

Maneuverability and control of V/STOL aircraft in powered-lift flight is studied with specific considerations of maneuvering in forward flight. A review of maneuverability for representative operational mission tasks is presented and covers takeoff, transition, hover, and landing flight phases. Maneuverability is described in terms of the ability to rotate and translate the aircraft and is specified in terms of angular and translational accelerations imposed on the aircraft. Characteristics of representative configurations are reviewed, including experience from past programs and expectations for future designs. The review of control covers the characteristics inherent in the basic airframe and propulsion system and the behavior associated with ontrol augmentation systems. Demands for augmented stability and control response to meet certain mission operational requirements are discussed. Experience from ground-based simulation and flight experiments that illustrates the impact of augmented stability and control on aircraft design is related by example.

Franklin, J. A.↗

Design criteria for flightpath and airspeed control for the approach and landing of STOL aircraft

A flight research program was conducted to assess requirements for flightpath and airspeed control for glide-slope tracking during a precision approach and for flare control, particularly as applied to powered-lift, short takeoff and landing (STOL) aircraft. Ames Research Center's Augmentor Wing Research Aircraft was used to fly approaches on a 7.5 deg glide slope to landings on a 30 X 518 m (100 X 1700 ft) STOL runway. The dominant aircraft response characteristics determined were flightpath overshoot, flightpath-airspeed coupling, and initial flightpath response time. The significant contribution to control of the landing flare using pitch attitude was the short-term flightpath response. The limiting condition for initial flightpath response time for flare control with thrust was also identified. It is possible to define flying-qualities design criteria for glide-slope and flare control based on the aforementioned response characteristics.

Franklin, J. A.↗

Flight evaluation of the STOL flare and landing during night operations

Simulated instrument approaches were made to Category 1 minimums followed by a visual landing on a 100 x 1700 ft STOL runway. Data were obtained for variations in the aircraft's flare response characteristics and control techniques and for different combinations of aircraft and runway lighting and a visual approach slope indication. With the complete aircraft and runway lighting and visual guidance no degradation in flying qualities or landing performance was observed compared to daylight operations. elimination of the touchdown zone floodlights or the aircraft landing lights led to somewhat greater pilot workload; however, the landing could still be accomplished successfully. Loss of both touchdown zone and aircraft landing lights led to a high workload situation and only a marginally adequate to inadequate landing capability.

Franklin, J. A.↗

Flight evaluation of stabilization and command augmentation system concepts and cockpit displays during approach and landing of powered-lift STOL aircraft

A flight research program was conducted to assess the effectiveness of manual control concepts and various cockpit displays in improving altitude (pitch, roll, and yaw) and longitudinal path control during short takeoff aircraft approaches and landings. Satisfactory flying qualities were demonstrared to minimum decision heights of 30 m (100 ft) for selected stabilization and command augmentation systems and flight director combinations. Precise landings at low touchdown sink rates were achieved with a gentle flare maneuver.

Franklin, J. A.↗

Flight evaluation of configuration management system concepts during transition to the landing approach for a powered-lift STOL aircraft

Flight experiments were conducted to evaluate two control concepts for configuration management during the transition to landing approach for a powered-lift STOL aircraft. NASA Ames' augmentor wing research aircraft was used in the program. Transitions from nominal level-flight configurations at terminal area pattern speeds were conducted along straight and curved descending flightpaths. Stabilization and command augmentation for attitude and airspeed control were used in conjunction with a three-cue flight director that presented commands for pitch, roll, and throttle controls. A prototype microwave system provided landing guidance. Results of these flight experiments indicate that these configuration management concepts permit the successful performance of transitions and approaches along curved paths by powered-lift STOL aircraft. Flight director guidance was essential to accomplish the task.

Franklin, J. A.↗

Lift/cruise fan VTOL aircraft

The paper gives an overview of the technology related to lift/cruise fan VTOL aircraft, covering propulsion systems, thrust deflection, flight dynamics, controls, displays, aerodynamics, and configurations. Piloting problems are discussed, and the need for integration of power management and thrust-vector controls is pointed out. Major components for a high-bypass-ratio lift/cruise fan propulsion system for VTOL aircraft have been tested.

Quigley, H. C.↗

Flight evaluation of flight-path control required for the approach and landing of STOL aircraft

Flight experiments have been conducted as part of a program to assess requirements for flight-path control for glide-slope tracking and for control of the flare and landing for STOL aircraft. The Augmentor Wing Research Aircraft was used to perform landing approaches on a 7.5 deg glide slope to landings on a 30 x 518 m STOL runway. The flight results identified flight-path overshoot and vertical velocity damping to be the dominant aircraft response characteristics that affect glide-slope tracking. The one prominent contribution to control of flare using pitch attitude was the short-term path response.

Franklin, J. A.↗

Flight evaluation of advanced flight control systems and cockpit displays for powered-lift STOL Aircraft

A flight research program was conducted to assess the improvements, in longitudinal path control during a STOL approach and landing, that can be achieved with manual and automatic control system concepts and cockpit displays with various degrees of complexity. NASA-Ames powered-lift Augmentor Wing Research Aircraft was used in the research program. Satisfactory flying qualities were demonstrated for selected stabilization and command augmentation systems and flight director combinations. The ability of the pilot to perform precise landings at low touchdown sink rates with a gentle flare maneuver was also achieved. The path-control improvement is considered to be applicable to other powered-lift aircraft configurations.

Franklin, J. A.↗

Flight-path and airspeed control during landing approach for powered-lift aircraft

Manual control of flight path and airspeed during landing approach has been investigated for powered-lift transport aircraft. An analysis was conducted to identify the behavior of the aircraft which would be potentially significant to the pilot controlling flight path and airspeed during the approach. The response characteristics found to describe the aircraft behavior were (1) the initial flight-path response and flight-path overshoot for a step change in thrust, (2) the steady-state coupling of flight path and airspeed for a step change in thrust, and (3) the sensitivity of airspeed to changes in pitch attitude. The significance of these response characteristics was evaluated by pilots on a large-motion, ground-based simulator at Ames Research Center. Coupling between flight path and airspeed was considered by the pilot to be the dominant influence on handling qualities for the approach task. Results are compared with data obtained from flight tests of three existing powered-lift V/STOL aircraft.

Franklin, J. A.↗