Surface Polishing Process for NAI Crystals
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Francis, J..
Explore the source record for details and available documents.
A wick-heater system has been selected for use to pressurize the Source Dewar of the Robotic Refueling Mission Phase 3 on-orbit cryogen transfer experiment payload for the International Space Station. Experimental results of autogenous pressurization of liquid argon and liquid nitrogen using a prototype wick-heater system are presented. The wick-heater generates gas to increase the pressure in the tank while maintaining a low bulk fluid temperature. Pressurization experiments were performed in 2013 to characterize the performance of the wick heater. This paper describes the experimental setup, pressurization results, and analytical model correlations.
The current development progress of the fluid management device (FMD) for the Robotic Resupply Mission 3 (RRM3) cryogen source Dewar is described. RRM3 is an on-orbit cryogenic transfer experiment payload for the International Space Station. The fluid management device is a key component of the source Dewar to ensure the ullage bubble is located away from the outlet during transfer. The FMD also facilitates demonstration of radio frequency mass gauging within the source Dewar. The preliminary design of the RRM3 FMD is a number of concentric cones of Mylar which maximizes the volume of liquid in contact with the FMD in the source Dewar. This paper describes the design of the fluid management device and progress of hardware development
Emergence of a terawatt scalable photovoltaic (PV) thin film technology is currently impeded by the limited supply of relatively rare elements like In or Te, which has spurred active research in recent years on earth-abundant PV materials. Instead of searching for alternative PV materials, we approach the problem here by structural modification through alloying of a known PV material, namely, tin sulfide. Although SnS is a strong visible light absorber that is naturally p-doped, its indirect band gap reduces the open circuit voltage of SnS-based solar cells. The anisotropic crystal structure results in undesirable anisotropic transport properties. Based on the observation that the isoelectronic sulfides MgS, CaS, and SrS assume the rock-salt structure, we use ab initio calculations to explore the structure and electronic properties of metastable Sn{sub 1−x}(II){sub x}S (II = Mg, Ca, Sr) alloys, finding that the isotropic rock-salt phase is stabilized above x = 0.2–0.3, and predicting direct band gaps in the range of interest for PV applications, i.e., 0.6–1.5 eV for Ca and Sr alloying. We subsequently synthesized such Sn{sub 1−x}(Ca){sub x}S films by pulsed laser deposition, confirmed the cubic rock-salt structure, and observed optical band gaps between 1.1 and 1.3 eV. These results highlight the potential of structural modification by alloying as a route to widen the otherwise limited materials base for promising earth-abundant materials.
Not Available