Engineering Papers⌕ Search

Engineering topics

Fout, Timothy

Publications and source records attributed to Fout, Timothy.

At least 19 records

Insights from FEED studies for retrofitting existing fossil power plants with carbon capture technology

Recent United States Department of Energy (DOE) sponsored front-end engineering design (FEED) studies for retrofitting existing fossil-fueled power plants with state-of-the-art carbon capture technology contain previously overlooked real-world design considerations for near-term deployment of carbon capture. Insights from examining seven recently published FEED study reports are summarized in this paper. This includes a discussion of the design, performance, and cost implications associated with (1) location-specific considerations such as water availability, land availability, and accessibility; (2) host-plant-specific factors such as flue gas specifications, allowable degree of integration between the capture system and host plant, and operational mode; and (3) miscellaneous factors such as market conditions, permitting requirements, and business case incentives. In conclusion, this manuscript highlights (1) water availability as a key design and cost driver, with host plant steam extraction increasing capture system cooling water availability, (2) modularization and constructability impacts on the number of capture trains, (3) the impacts of host plant operational mode and capacity factor on the business case for installing capture, and (4) the merit of continued research, development, and demonstration efforts addressing steam extraction, host plant tie-in at the stack, solvent reclamation and air emissions control.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗

Research goals for minimizing the cost of CO 2 capture when using steam methane reforming for hydrogen production

This paper presents a techno-economic assessment of adding state-of-the-art solvent-based CO 2 capture technologies to greenfield steam methane reforming (SMR)-based H 2 production plants and quantifies the impacts of improvements in CO 2 capture technology. Current conventional capture technologies are reviewed, and future technologies in intermediate and long-term scenarios are analyzed. The results show that adding significantly more efficient solvent-based capture technologies leads to an equivalent rate of natural gas consumption as that of a conventional SMR plant without capture, despite capturing most of the CO 2 and producing the same amount of H 2 . Overall, improvements in reboiler duty and reductions in capital costs can significantly reduce the cost of H 2 production and cost of capture. Particularly, the reboiler duty of pre-combustion capture and the capital cost of post-combustion capture have the greatest impact. Based on the results, research goals are suggested. Solvent development is recommended—particularly pre-combustion solvents—for reducing the reboiler duties, and process schemes to reduce the capital costs. Costlier but more efficient solvents can be considered. A sensitivity analysis using natural gas price shows that technological improvements can reduce the impacts of high natural gas prices. The degree of economic feasibility of CO 2 capture increases with improvements to the capture technology.

08 HYDROGEN↗

Enhanced Weathering Screening Techno-Economic Analysis

This presentation reports on a screening techno-economic analysis that examines the impact of key factors that influence terrestrial enhanced weathering performance and cost. Two cases are considered for analysis based on the material used: (1) Naturally occurring mined igneous rock (2) Industrial waste materials (like biomass ash or cement kiln dust) The analysis considers locating the terrestrial enhanced weathering system in the Midwestern United States, because of proximity to alkaline materials, availability of farmland, and appropriate ambient conditions for weathering. For the igneous rock case, the size of the system is based on the average amount of igneous rock available from a single mine—250,000 tonnes/year. For the industrial waste case, the size of the system is based on the amount of suitable waste material produced by an industrial hub—150,000 tonnes/year.

Leptinsky, Sarah↗

Decarbonization of the Iron and Steel Sector: Challenges and Opportunities

With a global initiative to reduce greenhouse gas emissions, the iron & steel industry presents an impactful decarbonization opportunity. In the U.S., the iron & steel industry accounted for 4.8% of industrial CO2 emissions in 2019, or about 72 M tonnes of CO2. This poster presents on the techno-economics of retrofitting blast oxygen furnace (BOF) iron/steel plants in the U.S. with capture.

Hughes, Sydney↗

Screening Analysis of Terrestrial Enhanced Rock Weathering of Igneous Rocks and Industrial Waste Materials

This poster, presented at the 17th Greenhouse Gas Control Technology Conference, reports on an NETL screening level techno-economic assessment of enhanced weathering (EW). EW is a promising emerging carbon dioxide removal approach that involves harnessing and accelerating the natural weathering process by which atmospheric CO2 passively reacts with exposed alkaline minerals and is removed from the atmosphere. Two primary cases utilizing different sources of alkaline material are considered: (1) utilizing naturally occurring mined igneous rocks, and (2) utilizing industrial waste materials. The analysis highlights that utilizing materials with high weathering potential in suitable locations may result in relatively low levelized cost of captured. NETL is publishing a detailed and transparent report titled “Enhanced Weathering: Techno-Economic and Life Cycle Screening Analysis” that includes more detail on the screening level techno-economic analysis and includes a life cycle analysis.

carbon dioxide removal↗

Natural Gas Combined Cycle Power Plants with Carbon Capture and Exhaust Gas Recycle

This is a presentation given at the 3rd International Conference on Energy and Environment. The presentation highlights analysis work conducted by NETL to assess the cost and performance for natural gas combined cycle (NGCC) power plants that incorporate solvent-based post combustion carbon dioxide (CO2) capture and exhaust gas recycle (EGR). Increasing the inlet CO2 concentration by EGR is expected to improve the efficiency of the capture system and reduce its cost, however the analysis results show that the cost improvement is minimal as is the cost of capture reduction.

Hackett, Gregory↗

Technoeconomic Analysis of a Direct Air Capture System Utilizing a Looped CaCO3/Ca(OH)2 Process

This presentation reports preliminary results from a screening level techno-economic analysis of a looped CaCO3/Ca(OH)2 direct air capture process. Preliminary results reveal that the looped CaCO3/Ca(OH)2 process may be cost competitive with solvent- and sorbent-based DAC technologies. Results from a detailed sensitivity analysis revealing multiple avenues for system optimization and cost reduction are presented.

Homsy, Sally↗

Direct Air Capture (DAC) With Nuclear Power Sources

The presentation summarizes a recently published report, along with ANL and INL, on utilizing waste heat and power from nuclear power plants (NPP) for direct air capture (DAC) applications. Two DAC technologies are considered – solid sorbent (S-DAC) and liquid solvent (L-DAC). S-DAC uses both heat and power from NPPs, while L-DAC uses only power. The results show that using NPPs for DAC applications results in an economic benefit compared to using fossil fired power plants

Mantripragada, Hari↗

Natural Gas Combined Cycle (NGCC) Power Plants with Carbon Capture and Exhaust Gas Recycle (EGR)

The purpose of this study is to determine the cost and performance of natural gas combined cycle (NGCC) power plants using state-of-the-art gas turbines with post combustion carbon capture and recycle streams designed to increase the CO 2 concentration in the inlet to the capture system. Increasing the inlet CO 2 concentration by exhaust gas recycle (EGR) is expected to improve the efficiency of the capture system and reduce its costs. Primary results indicate that adding EGR to NGCC plants with CO 2 capture results in minimal improvement to the cost of electricity. The addition of 50 percent EGR in NGCC plants with CO 2 capture reduces the LCOE by 2 percent over the LCOE of the same design without EGR as reference. Including the EGR ductwork and cooler in a greenfield plant design could still be prudent since there is some cost advantage to EGR and it would allow more flexibility for taking advantage of future improvements in the technology.

20 FOSSIL-FUELED POWER PLANTS↗

Carbon Capture Technologies: Status and Challenges

This slide deck is a high-level presentation describing the current state of carbon capture technologies. Specifically discussed is the state-of-the-art and relevant challenges associated with solvent-, sorbent-, and/or membrane-based carbon reducing/removal technologies. This presentation was delivered on September 26, 2023 as part of the Air and Waste Management Association Electric Power Transformation MEGA Symposium in Pittsburgh, Pennsylvania.

Hackett, Gregory↗

Assessment of Nuclear Energy to Support Negative Emission Technologies

The feasibility and performance of nuclear energy coupled with Negative Emission Technology (NET) processes were investigated in this report. Three overarching questions from nuclear NET systems guided this research: which NET would be able to use heat and/or electricity from nuclear power plants (NPPs); what is the performance and cost of a nuclear NET system; and what would be the market outlook for this system? Among the various NETs that are actively being developed, several were found to potentially benefit from coupling with an NPP via (1) large amounts of decarbonized and constant-output electricity; (2) free waste heat or cheap low-temperature heat; or (3) high-temperature heat. NPPs were found to be compatible with Direct Air Capture (DAC) systems, and a detailed techno-economic analysis of coupled NPP&DAC systems was performed. Preliminary analysis also indicated that biomass and water-based NETs are potentially compatible with NPPs, but further work is needed to quantify the performance of these nuclear NET systems. Design and performance analyses were completed for both liquid solvent DAC (L-DAC) and solid sorbent DAC (S-DAC) technologies. A 1.0-GWth NPP coupled with L-DAC and S-DAC was found to be able to capture 12–15 Mt CO 2 /yr and 1.0–1.5 Mt CO 2 /yr, respectively. While the L-DAC process enables much greater CO 2 capture than the S-DAC process when both are sized with a 1 GWth NPP, the NPP&L-DAC system considered also requires >2 GWth natural gas oxy-combustion to reach adequate temperature in the calciner. CO 2 generated from natural gas combustion is also captured as part of the calcination process, in addition to the CO 2 captured from air, resulting in overall CO 2 sequestration of close to 30% more than what is captured from air. The cost of carbon capture calculated with the levelized cost of DAC (LCOD) had a range of $\$170–260$/tCO 2 for NPP&L-DAC systems and a range of $\$650–680$/tCO 2 for NPP&S-DAC systems. For both DAC systems, the NPP provides economic benefit when compared to previous National Energy Technology Laboratory (NETL) studies of non-nuclear DAC systems, leading to reduction of LCOD by 5–7% for L-DAC, and 8–13% for S-DAC. For the NPP&DAC systems, a preliminary market analysis reviewed potential CO 2 market prices and eligibility for incentives. The estimated potential revenues for CO 2 capture (coming from federal incentive, CO 2 commodity markets, or offset market) is in the range of $\$170–979$ tCO 2 , and the results show that because of lower LCOD, the NPP&L-DAC process would be more attractive to a market than the NPP&S-DAC process. The large investment needed for NPP&DAC processes would require long-term certainty of sufficient market size, CO 2 prices, and incentives. Enabling NPPs to ramp DAC operation up or down based on electricity market price is not expected to significantly increase revenues of the NPP&DAC system. This is because the revenues from CO 2 sequestration are required to be very high to justify the deployment and continuous operation of the very expensive DAC technologies. In this analysis, several new research questions were uncovered, and follow-up analyses are recommended for further investigation, including a detailed feasibility study of NPP coupled with other NET systems such as biomass pyrolysis and gasification with carbon capture and storage, and seawater carbon capture.

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗

Systems Analysis for Carbon Dioxide Removal

Presentation at the 2023 Annual Carbon Management Review Meeting covering Strategic Systems Analysis and Engineering work on Carbon Dioxide Removal technologies.

Fout, Timothy↗

Techno Economic Analysis Development for Enhanced Weathering and Marine Carbon Dioxide Removal

Enhanced weathering and marine carbon dioxide removal (CDR) are emerging technologies that can aid in the direct removal of CO2 from the atmosphere. This poster presents on NETL’s active (ongoing) work on the techno-economic analysis (TEA) of enhanced weathering and marine CDR. Financial assumptions will be common with already released Direct Air Capture Case Studies

Leptinsky, Sarah↗

Techno-economic Analysis of CO2 Capture From Pulp/Paper Plants

This poster presentation evaluates the cost of capturing CO2 from a 400,000 air dried tonne (adt)/year pulp production plant, using Shell’s CANSOLV post-combustion capture process. There are five steps in a pulp/paper process: wood preparation, pulping, chemical recovery, bleaching and papermaking. There are three sources of CO2: combustion of waste wood in the wood-preparation step; combustion of black liquor, a product of pulping; and combustion of natural gas coupled with CO2 generated from calcination of limestone in the lime kiln used in chemical recovery. Standalone (pulp only) and integrated (pulp + paper) mills are modeled. The base case results and sensitivity analyses are displayed.

Mantripragada, Hari↗

Retrofitting NGCC and PC Power Plants with Carbon Capture Technology

This is a poster that was presented at the 2023 Carbon Management Research Project Review Meeting. The poster highlights primary takeaways from two reports that were recently released by NETL on retrofitting natural gas combined cycle (NGCC) and pulverized coal (PC) power plants with solvent-based carbon capture technology. The poster highlights the performance and cost of retrofitting these plants at 90 and 95% carbon capture, including consideration of cases that attempt to makeup for steam turbine derates caused by extracting steam for use in the capture process. Additionally, the poster highlights NETL's recently released carbon capture retrofit databases (CCRD) for both NGCC and PC plants. The CCRDs are public-facing tools that allow the end-user to approximate the incremental cost of CO2 capture for a user defined plant with retrofitted capture technology.

Hackett, Gregory↗