Engineering topics

Foss, J. F.

Publications and source records attributed to Foss, J. F..

At least 19 records

NASA NTRS1997

An Experimental Study of the Near Field Region of a Free Jet with Passive Mixing Tabs

An experimental study was performed to determine the flow characteristics of a tabbed free jet. Results were acquired in the near field (nominally 2 tab widths upstream to 2 tab widths downstream of the exit plane) of a tabbed jet. Upstream pressure results showed static pressure distributions in both the x-and y-directions along the top surface of the tunnel. Hot-wire measurements showed rapid expansion of the core fluid into the ambient region. Two counter rotating regions of streamwise vorticity were shown on each side of the primary tab. An enhancement of the tabbed jet concept was proposed and tested. Specifically, two tabs, half the scale of the primary tab, were added to the primary tab to provide attachment surfaces for the normally occurring ejection of fluid. The secondary tabs caused a slight increase in the streamwise vorticity created from the upstream static pressure gradient while significantly increasing the re-oriented boundary layer vorticity. The combined pumping effect of the two counter rotating regions of vorticity caused a significant increase in the transport of the jet core fluid into the surrounding region.

Bohl, D. G.↗

NASA NTRS1989

Numerical and experimental evaluations of the flow past nested chevrons

An effort is made to contribute to the development of CFD by relating the successful use of vortex dynamics in the computation of the pressure drop past a planar array of chevron-shaped obstructions. An ensemble of results was used to compute the loss coefficient k, stimulating an experimental program for the assessment of the measured loss coefficient for the same geometry. The most provocative result of this study has been the representation of kinetic energy production in terms of vorticity source terms.

Foss, J. F.↗

NASA NTRS1989

The effects of forcing on a single stream shear layer and its parent boundary layer

The detailed response of a large single-stream shear layer to a sinusoidal forcing at x = 0 is quantitatively defined. Phase-averaged data are used to characterize the increased disturbance convection velocity and a width measure of the disturbance field. These findings are consistent with and complement those of Fiedler and Mensing (1985).

Haw, R. C.↗

NASA NTRS1987

A critical analysis of transverse vorticity measurements in a large plane shear layer

An evaluation is made of the roles played in four-wire hot wire probe arrays by the influence of (1) the transverse velocity component on pitch angle measurement; (2) the instantaneous spatial gradient of the pitch angle on transverse vorticity computation; (3) the uncertainties in the magnitude of instantaneous pitch angle spatial gradient in the transverse vorticity computation; and (4) the spatial dimension of the microcirculation domain and the evaluation of transverse vorticity. Attention is given to the probe configuration and its computation algorithm.

Foss, J. F.↗

NASA NTRS1987

Coherent motion induced fluctuations in the primary transition region of a plane shear layer

The naturally occurring large scale motions in a single stream shear layer (that is initiated from a fully turbulent boundary layer) are made evident by the induced velocities in the entrainment region beyond the active shear layer. The distinctive attributes of these induced motions are particularly evident in the Michigan State Univerity Free Shear Flow Facility since the total test section length (3m) is nominally the same as the location of the first, fully formed, coherent motion, ca/x theta (0) = 400 (or 2.5 m). Hence, detailed studies of the induced motions can be executed. Individual coherent motions are identified by the induced velocity signatures and conditional-ensemble statistics are used to represent the irrotational field properties. Clusters of such motions exist; some of their properties are substantially different from the unconditionally averaged values.

Foss, J. F.↗

NASA NTRS1987

Gravitationally defined velocities for a low speed hot-wire calibration

A technique to provide the reference velocity for a low speed hot-wire calibration is described. A pivoted arm falls under the action of gravity and the resulting velocity field can be used to define the transfer function coefficients in a modified Collis and Williams (1959) relationship. In nominal agreement with a published result, a deviation from this relationship for a film Reynolds number such that Re exp n of less than about 0.24 is observed.

Haw, R. C.↗

NASA NTRS1986

Transverse vorticity measurements using an array of four hot-wire probes

A comprehensive description of the technique used to obtain a time series of the quasi-instantaneous transverse vorticity from a four wire array of probes is presented. The algorithmic structure which supports the technique is described in detail and demonstration data, from a large plane shear layer, are presented to provide a specific utilization of the technique. Sensitivity calculations are provided which allow one contribution to the inherent uncertainty of the technique to be evaluated.

Foss, J. F.↗

NASA NTRS1985

Development of a temperature measurement system with application to a jet in a cross flow experiment

A temperature measurement system, which allows the simultaneous sampling of up to 80 separate thermocouples, was developed. The minimum resolution for the system corresponds to + or - 0.16 C per least significant bit of the A/D converter. The time constant values lambda, for each of the 64 thermocouples, were determined experimentally at 7 mps. Software routines were used to correct the measured temperatures for the effect of lambda for each thermocouple. The temperature measurement system was utilized to study the thermal field of a heated jet discharging perpendicularly into a low and a high disturbance level cross stream for a given momentum flux ratio and for three overheated values. The peak instantaneous temperatures reveal that strong molecular diffusion was operative. Various measures of the thermal field, for the disturbed case, suggest that the jet column remains relatively compact while being buffeted by the ambient turbulence field and that its penetration, into the cross wind, is inhibited by the presence of the strong disturbance field.

Wark, C.↗

NASA NTRS1985

Entrainment region phenomena for a large plane shear layer

The subatmospheric test section of the present free shear layer facility allows the entrainment air to be introduced with a negligible disturbance level. The very low frequency oscillations, which are prominently observed in the entrainment stream and which are present throughout the shear layer, are attributed to an inherent instability in the transition from a boundary layer to a free shear layer state. The basic features of the disturbance field are documented herein.

Ali, S. K.↗

NASA NTRS1984

Free stream turbulence and density ratio effects on the interaction region of a jet in a cross flow

Jets of low temperature air are introduced into the aft sections of gas turbine combustors for the purpose of cooling the high temperature gases and quenching the combustion reactions. Research studies, motivated by this complex flow field, have been executed by introducing a heated jet into the cross stream of a wind tunnel. The investigation by Kamotani and Greber stands as a prime example of such investigations and it serves as the principal reference for the present study. The low disturbance level of the cross stream, in their study and in similar research investigations, is compatible with an interest in identifying the basic features of this flow field. The influence of the prototypes' strongly disturbed cross flow is not, however, made apparent in these prior investigations.

Wark, C. E.↗

NASA NTRS1983

Advanced techniques for transverse vorticity measurements

A four wire array of probes is used to determine the velocity components, their derivatives, and the transverse vorticity in a small (approximately 1 x 1 mm) spatial domain. The algorithms that define this calculation scheme and the extended considerations: compensating for minor calibration changes, uncertainty considerations, and the determination of excessive pitch angles in the data set, are presented.

Foss, J. F.↗

NASA NTRS1979

Transverse vorticity measurements

A technique, involving programmed digital calculations, is proposed for evaluating transverse vorticity in typical laboratory shear flows from an array of four hot-wire probes. The computing scheme successfully recovers the velocity vector information from a wide range of velocity magnitudes and a wide range of pitch angles. It is readily implemented in a batch process mode on a digital computer.

Foss, J. F.↗

NASA NTRS1978

Measurements in a large angle oblique jet impingement flow

The flow field associated with the oblique impingement of an axisymmetric jet was investigated in the externally blown flap configuration for the STOL aircraft. The passive and active spreading characteristics of the shallow angle (a greater than or = approximately to 15 degrees) oblique impingement flow, the role of the initially azimuthal vorticity field, and the stagnation point region were studied, and compared to the large ( a = 45 degres) oblique jet impingement flow. A description of the characteristics of the large angle impingement flow is presented: A flow field near the plate as showing two distinct patterns, one near the location of the maximum surface pressure, and another about the geometric intersection of the jet axis with the plate; and turbulence in the region above the plate which is greater than the one accounted for by the convection of turbulence energy by the mean motion.

Foss, J. F.↗

NASA NTRS1977

The effects of the laminar/turbulent boundary layer states on the development of a plane mixing layer

The effect of the laminar/turbulent boundary layer state on the mean and rms velocities of a developing plane mixing layer was investigated. The use of commonly accepted nondimensional representations of the data confirm (at least) an approximately self-preserving condition. It is suggested that the effects of the laminar/turbulent initial condition persist in the self-preserving region.

Foss, J. F.↗

NASA NTRS1977

The effects of the laminar/turbulent boundary layer states on the development of a plane mixing layer

The effect, of the laminar/turbulent boundary layer state on the mean and rms velocities of a developing plane mixing layer, has been investigated. The maximum Ux/nu allowed by the facility was 6.7 x 100.000; the maximum x station surveyed corresponds to approximately 2000 and 700 initial momentum thicknesses for the laminar and turbulent cases respectively. The use of commonly accepted non-dimensional representations of the data confirm (at least) an approximately self-preserving condition. They also suggest that the effects of the laminar/turbulent initial condition persist in the self-preserving region. A direct comparison of the data reveals that the persistence so observed is illusory. An interpretation of the reason for this misunderstanding is advanced.

Foss, J. F.↗

NASA NTRS1976

The VORCOM. Part 1: Analytical considerations

The analytical considerations which support the computation of (1) two components of the velocity vector from an X-array and (2) the transverse vorticity from the X-array and an adjacent parallel wire pair are presented. The electronic circuit which will execute these computations at a 50 khz rate is also described. The factors limiting the accuracy of the measurements are identified and quantitative estimates are given for a typical x-probe. An extensive analysis of the factors which effect the output and which are unknown (or unknowable) during the measurements is presented. Quantitative estimates of these effects are developed in the form of an uncertainty analysis. Numerical values, calculated using the analytical structure of the response equations, are tabulated; other estimates which require special experiments are described.

Foss, J. F.↗

NASA NTRS1976

The oblique impingement of an axisymmetric jet

The mechanics of the oblique impingement of an axisymmetric jet on a plane surface are examined in detail. The stagnation point is discussed. A schematic drawing of the problem and coordinate system used to describe the flow field are given. The kinematic features of the flow above the plate are examined in the context of the conservation of mass, the vorticity of the jet, and the vorticity introduced by the jetplate interaction. The dynamic features of the flow are examined in terms of the surface pressure distribution and the cause-effect relationships which exist between the pressure and velocity/vorticity distributions. Flow calculations performed are given. The investigation is relevant to the flow resulting from the interaction of the propulsion jet with the main airfoil (STOL aircraft), and is appropriate to an over- or under- wing configuration.

Foss, J. F.↗

NASA NTRS1975

Mean flow characteristics for the oblique impingement of an axisymmetric jet

The oblique impingement of an axisymmetric jet has been investigated. A summary of the data and the analytical interpretations of the dominant mechanisms which influence the flow are reported. The major characteristics of the shallow angle oblique jet impingement flow field are: (1) minimal dynamic spreading as revealed by the surface pressure field, (2) pronounced kinematic spreading as revealed by the jet flow velocity field, (3) a pronounced upstream shift of the stagnation point from the maximum pressure point, (4) the production of streamwise vorticity by the impingement process.

Foss, J. F.↗