Engineering topics
Publications and source records attributed to Ford, H..
We report the detection of Cepheid variable stars in the barred spiral galaxy NGC 1365, located in the Fornax cluster, using the Hubble Space Telescope Wide Field and Planetary Camera 2. Twelve V (F555W) and four I (F814W) epochs of observation were obtained.
The distance to NGC 4725 has been derived from Cepheid variables, as part of the Hubble Space Telescope Key Project on the Extragalactic Distance Scale.
We report the Discovery of Cepheid variable stars in the galaxy NGC 4414, as part of the Hubble Space Telescope (HST) Key Project on the Extragalactic Distance Scale. Observations were obtained with the HST Wide Field and Planetary Camera 2 (WFPC2) for 13 epochs at V (F555W) and 4 at I (F814W).
The distance to NGC 7331 has been derived from Cepheid variables observed with HST/WFPC2, as part of the Extragalactic Distance Scale Key Project. Multi-epoch exposures in F555W(~V) and F814W (~1), with photometry derived independently from DoPHOT and DAOPHOT/ALLFRAME programs, which were used to detect a total of 14 reliable Cepheids, with periods between 11 and 42 days.
Accurate distances to galaxies are critical to determining the present expansion rate of the Universe or Hubble Constant (H(sub 0)). An important step in resolving the current uncertainty in H(sub 0) is the measurement of the distance to the Virgo cluster of galaxies. New observations using the Hubble Space Telescope yield a distance of 17.1 +/- 1.8 Mpc to the Virgo cluster galaxy M100. This distance leads to a value of H(sub 0) = 17 km/sec/Mpc. A comparable value of H(sub 0) is also derived from the Coma cluster using independent estimates of its distance ratio relative to the Virgo cluster.
As part of both the Early Release Observations fromthe Hubble Space Telescope and the Key PRoject on the Extragalctic Distance Scale, we have obtained multi-wavelength BVR WFPC2 images for the face-on Virgo cluster spiral galaxy M11 = NGC 4321.
This paper presents initial observations, including the discovery of 30 Cepheids in the nearby galaxy M81, made using the Wide Field Camera (WFC).
This paper describes the Extragalactic Distance Scale Key Project for Hubble Space Telescope which aims to employ the Cepheid period-luminosity relation to measure galaxy distances out as far as the Virgo cluster.
It is well known that all linear time-invariant controllable systems can be transformed to Brunovsky canonical form by a transformation consisting only of coordinate changes and linear feedback. However, the actual procedures for doing this have tended to be overly complex. The technique introduced here is envisioned as an on-line procedure and is inspired by George Meyer's tangent model for nonlinear systems. The process utilizes Meyer's block triangular form as an intermedicate step in going to Brunovsky form. The method also involves orthogonal matrices, thus eliminating the need for the computation of matrix inverses. In addition, the Kronecker indices can be computed as a by-product of this transformation so it is necessary to know them in advance.
Redshift surveys for rich superclusters were carried out in five regions of the sky containing surface-density enhancements of Abell clusters. While several superclusters are identified, projection effects dominate each field, and no system contains more than five rich clusters. Two systems are found to be especially interesting. The first, field 0136 10, is shown to contain a superposition of at least four distinct superclusters, with the richest system possessing a small velocity dispersion. The second system, 2206 - 22, though a region of exceedingly high Abell cluster surface density, appears to be a remarkable superposition of 23 rich clusters almost uniformly distributed in redshift space between 0.08 and 0.24. The new redshifts significantly increase the three-dimensional information available for the distance class 5 and 6 Abell clusters and allow the spatial correlation function around rich superclusters to be estimated.
The design and basic performance characteristics of the Faint Object Spectrograph (FOS), one of five instruments built for use on the Space Telescope observatory, is summarized briefly. The results of the recently completed instrument-level calibration are presented with special emphasis on issues affecting plans for FOS astronomical observations. Examples include such fundamental characteristics as: limiting magnitudes (system sensitivity and noise figures), spectral coverage and resolution, scattered light properties, and instrumental polarization and modulation efficiencies. Also gated toward intended users, a rather detailed description of FOS operating modes is given. The discussion begins with the difficulties anticipated during target acquisition and their hoped-for resolution. Both the 'normal' spectroscopic operating modes of the FOS and its 'exotic' features (e.g. spectropolarimetric, time-tagged, and time-resolved modes) are presented. The paper concludes with an overview of the activities to assure proper alignment and operation of the FOS within the entire Space Telescope system (orbital and ground-based).
Redshift measurements and finding charts are presented for galaxy clusters in the field of two rich, distant superclusters. Both systems are shown to have morphological and dynamical properties similar to the nearby superclusters, including small internal velocity dispersions and high density contrasts in redshift space. This data is consistent with two interpretations: either both superclusters are highly flattened systems with major axes close to the plane of the sky, or the observed velocity dispersions do not arise from unperturbed Hubble flow. If the latter explanation is correct, these radial velocity data are a powerful probe of the large scale matter density in the universe.
On-line off-line H-alpha plates of M31's nucleus revealed four bright stellar objects (m sub R being approximately 14.9, 15.0, 15.8, 16.4) within 1.2 kpc of the galaxy center. Spectrophotometric observations made 10 days later showed the stars were novae in the stage of early decline. In the 10 day interval, the H-alpha emission from these novae faded less than a magnitude, despite the fact that their continua had long since faded from view. The high luminosity and long decay time of the H-alpha emission suggest it might make an excellent standard candle for extragalactic distance measurements.
Arp (1979, 1980) has found quasars with similar redshifts which appear to be paired across low-redshift galaxies. Arp concludes that the pairings provide evidence for an association between high-redshift quasars and a small, low-redshift galaxy. Oort et al. (1981) suggested an alternative hypothesis to explain the close redshift pairs. They proposed that the two closest pairs are in superclusters at the cosmological distances implied by the quasars' redshifts. The low-redshift quasar pair U7/U10 (0.303/0.305) is close enough to allow detection of any associated clusters of galaxies on deep red photographs. The present investigation had originally the objective to test the supercluster hypothesis by searching for faint clusters which might comprise a supercluster at z approximately 0.3. Unfortunately, the disappearance of the pairs makes it impossible to test the hypothesis in this field. The search for a supercluster at z = 0.30 revealed a faint rich cluster of galaxies near the quasar U10 (z = 0.305). It was found that U10 is not associated with the cluster.
A technique for designing automatic flight controllers for aircraft which utilizes the transformation theory of nonlinear systems to linear systems is presently being developed at NASA Ames Research Center. A method is considered in which a given nonlinear is transformed to a controllable linear system in Brunovsky canonical form. A linear approximation is introduced to the nonlinear system called the modified tangent model. This model is easily computed. Constructing the transformation for this model enables the designer to find an approximate transformation for the nonlinear system.
The Faint Object Spectrograph (FOS) designed for use with The Space Telescope (ST), is currently preparing for instrument assembly, integration, alignment, and calibration. Nearly all optical and detector elements have been completed and calibrated, and selection of flight detectors and all but a few optical elements has been made. Calibration results for the flight detectors and optics are presented, and plans for forthcoming system calibration are briefly described.
The paper presents the Faint Object Spectrograph (FOS) for the Space Telescope to provide a digitized spectra of faint astronomical objects over the 115 to 700 nm wavelength range at resolving powers of 1000 and 100. A variety of concave gratings and prisms is employed to form nearly stigmatic spectra on one of the two Digicon photon counting detectors which are optimized for two different but overlapping ranges. The scientific goals associated with quasars, active galaxies, and objects within our solar system are discussed, and the FOS optical design features, including detectors, electronics, signal processing, power supplies, and data handling are examined. The FOS structural system, mechanism, and controls are described, along with the predicted performance capabilities in the spectral and spectropolarimetry modes. Finally, system performance parameters, including spatial resolution, time resolution, noise, and efficiency are discussed.
Electroplating lead on fluorocarbon polymer parts is accomplished by etching the parts to be plated with sodium, followed by successive depositions of silver and lead from ultrasonically agitated plating solutions. Metals other than lead may be electroplated on the silvered parts.