Engineering PapersSearch

Engineering topics

Finn, Robert

Publications and source records attributed to Finn, Robert.

A Zero-Gravity Cup for Drinking Beverages in Microgravity

To date, the method for astronauts to drink liquids in microgravity or weightless environments is to suck the liquid from a bag or pouch through a straw. A new beverage cup works in microgravity and allows astronauts to drink liquids from a cup in a manner consistent with that on Earth. The cup is capable of holding beverages with an angled channel running along the wall from the bottom to the lip. In microgravity, a beverage is placed into the cup using the galley dispenser. The angled channel acts as an open passage that contains only two sides where capillary forces move the liquid along the channel until it reaches the top lip where the forces reach an equilibrium and the flow stops. When one sips the liquid at the lip of the channel, the capillary force equilibrium is upset and more liquid flows to the lip from the reservoir at the bottom to re-establish the equilibrium. This sipping process can continue until the total liquid contents of the cup is consumed, leaving only a few residual drops about the same quantity as in a ceramic cup when it is drunk dry on Earth.

Pettit, Donald R.

Results From the USML-2 Interface Configuration Experiment

Mathematical theory predicts that small changes in container shape or in contact angle can give rise to large shifts of liquid in a microgravity environment. For studying such shifts, container shapes are described that were flown on board the Space Shuttle USML-2 mission as part of the Glovebox Interface Configuration Experiment. These containers are in the form of a circular cylinder with two diametrically opposed "canonical proboscis" protrusions. The containers were designed with the goal of having two desirable properties -that sufficient liquid would participate in the shift to permit easy observation, and that the change would be abrupt enough to allow accurate determination of critical contact angle. The observed behavior for these vessels is depicted, along with behavior for a movable wedge vessel, which also formed part of the experiment. The experimental results support the validity of the concept of macroscopic contact angle, basic to the theory, and thereby its use in predicting fluid behavior under reduced gravity. The results indicate, as well, the role of hysteresis in impeding orientation to equilibrium.

Concus, Paul

Liquid-Vapor Interface Configurations Investigated in Low Gravity

The Interface Configuration Experiment (ICE) is part of a multifaceted study that is exploring the often striking behavior of liquid-vapor interfaces in low-gravity environments. Although the experiment was posed largely as a test of current mathematical theory, applications of the results should be manifold. In space almost every fluid system is affected, if not dominated, by capillarity (the effects of surface tension). As a result, knowledge of fluid interface behavior, in particular an equilibrium interface shape from which any analysis must begin, is fundamental--from the control of liquid fuels and oxygen in storage tanks to the design and development of inspace thermal systems, such as heat pipes and capillary pumped loops. ICE has increased, and should continue to increase, such knowledge as it probes the specific peculiarities of current theory upon which our present understanding rests. Several versions of ICE have been conducted in the drop towers at the NASA Lewis Research Center, on the space shuttles during the first and second United States Microgravity Laboratory missions (USML-1 and USML-2), and most recently aboard the Russian Mir space station. These studies focused on interfacial problems concerning the existence, uniqueness, configuration, stability, and flow characteristics of liquid-vapor interfaces. Results to date have clearly demonstrated the value of the present theory and the extent to which it can predict the behavior of capillary systems.

Concus, Paul

Equilibrium Fluid Interface Behavior Under Low- and Zero-Gravity Conditions

The mathematical basis for the forthcoming Angular Liquid Bridge investigation on board Mir is described. Our mathematical work is based on the classical Young-Laplace-Gauss formulation for an equilibrium free surface of liquid partly filling a container or otherwise in contact with solid support surfaces. The anticipated liquid behavior used in the apparatus design is also illustrated.

Concus, Paul

Equilibrium fluid interface behavior under low- and zero-gravity conditions

We describe here some of our recent mathematical work, which forms a basis for the Interface Configuration Experiment scheduled for USML-2. The work relates to the design of apparatus that exploits microgravity conditions for accurate determination of contact angle. The underlying motivation for the procedures rests on a discontinuous dependence of the capillary free surface interface S on the contact angle gamma, in a cylindrical capillary tube whose section (base) omega contains a protruding corner with opening angle 2 alpha. Specifically, in a gravity-free environment, omega can be chosen so that, for all sufficiently large fluid volume, the height of S is uniquely determined as a (single-valued) function mu(x,y) entirely covering the base; the height mu is bounded over omega uniformly in gamma throughout the range absolute value of (gamma -(pion/2)) less than or equal to alpha, while for absolute value of (gamma - (pion/2)) greater than alpha fluid will necessarily move to the corner and uncover the base, rising to infinity (or falling to negative infinity) at the vertex, regardless of volume. We mention here only that procedures based on the phenomenon promise excellent accuracy when gamma is close pion/2 but may be subject to experimental error when gamma is close to zero (orpion), as the 'singular' part of the domain over which the fluid accumulates (or disappears) when a critical angle gamma theta is crossed then becomes very small and may be difficult to observe. We ignore the trivial case gamma is equal to pion/2 (planar free surface), to simplify the discussion.

Concus, Paul

Capillary surfaces in a wedge: Differing contact angles

The possible zero-gravity equilibrium configurations of capillary surfaces u(x, y) in cylindrical containers whose sections are (wedge) domains with corners are investigated mathematically, for the case in which the contact angles on the two sides of the wedge may differ. In such a situation the behavior can depart in significant qualitative ways from that for which the contact angles on the two sides are the same. Conditions are described under which such qualitative changes must occur. Numerically computed surfaces are depicted to indicate the behavior.

Concus, Paul

Interface Configuration Experiment: Preliminary Results

The Interface Configuration Experiment (ICE) was carried out on USML-1 to investigate liquid-gas interfaces in certain rotationally-symmetric containers having prescribed, mathematically derived shapes. These containers have the property that they admit an entire continuum of distinct equilibrium rotationally-symmetric interfaces for a given liquid volume and contact angle. Furthermore, it can be shown that none of these interfaces can be stable. It was found, after the containers were filled in orbit, that an initial equilibrium interface from the symmetric continuum re-oriented, when perturbed, to a stable interface that was not rotationally symmetric, in accordance with the mathematical theory.

Concus, Paul

An interface configuration experiment on USML-1

Experiments were carried out for 'exotic' rotationally symmetric containers aboard the first NASA United States Microgravity Laboratory Space Shuttle flight (USML-1). The containers have the property that they admit an entire continuum of distinct equilibrium rotationally-symmetric capillary free-surfaces for a given liquid volume and contact angle. It was found, after the containers were filled in orbit, that an initial equilibrium interface from the symmetric continuum reoriented, when perturbed, to a stable interface that was not rotationally symmetric, as predicted by the mathematical theory.

Concus, Paul

On canonical cylinder sections for accurate determination of contact angle in microgravity

Large shifts of liquid arising from small changes in certain container shapes in zero gravity can be used as a basis for accurately determining contact angle. Canonical geometries for this purpose, recently developed mathematically, are investigated here computationally. It is found that the desired nearly-discontinuous behavior can be obtained and that the shifts of liquid have sufficient volume to be readily observed.

Concus, Paul

On a comment by J. P. B. Vreeburg

This note addresses Vreeburg's (1990) comment on the paper by Langbein et al. (1990) regarding parabolic flight experiments on fluid surfaces and wetting. This last work in turn concerns the work of the present authors on capillary free surfaces in the absence of gravity (1974).

Concus, Paul

Exotic containers for capillary surfaces

This paper discusses 'exotic' rotationally symmetric containers that admit an entire continuum of distinct equilibrium capillary free surfaces. The paper extends earlier work to a larger class of parameters and clarifies and simplifies the governing differential equations, while expressing them in a parametric form appropriate for numerical integration. A unified presentation suitable for both zero and nonzero gravity is given. Solutions for the container shapes are depicted graphically along with members of the free-surface continuum, and comments are given concerning possible physical experiments.

Concus, Paul

Drop-tower experiments for capillary surfaces in an exotic container

Low-gravity drop-tower experiments are carried out for an 'exotic' rotationally-symmetric container, which admits an entire continuum of distinct equilibrium symmetric capillary free surfaces. It is found that an initial equilibrium planer interface, a member of the continuum, will reorient toward a non-symmetric interface, as predicted by recent mathematical theory.

Concus, Paul

Dichotomous behavior of capillary surfaces in zero gravity

A mathematical procedure is described for determining the behavior of the free surface of a fluid in static equilibrium and partly filling a cylindrical container with cross-section of general form in zero gravity. Either of two qualitatively distinct situations must prevail, depending on geometry and contact angle. Several illustrative examples are discussed, and the procedure is applied in detail to a container with a rectangular section on which the corners have been rounded, thereby determining the effect of rounding on the 'critical' contact angle that separates the two types of behavior. This last example is intended in part as a guide for application to general geometries.

Concus, Paul