Engineering topics

Ferro, F.

Publications and source records attributed to Ferro, F..

7 records

DOE OSTI2022

Characterisation of the dip-bump structure observed in proton–proton elastic scattering at $\sqrt{s}$ = 8 TeV

The TOTEM collaboration at the CERN LHC has measured the differential cross-section of elastic proton–proton scattering at √s = 8TeV in the squared four-momentum transfer range 0.2GeV 2 < |t| < 1.9GeV 2 . This interval includes the structure with a diffractive minimum (“dip”) and a secondary maximum (“bump”) that has also been observed at all other LHC energies, where measurements were made. A detailed characterisation of this structure for √s = 8 TeV yields the positions, |t| dip = (0.521 ± 0.007)GeV 2 and |t| bump = (0.695 ± 0.026)GeV 2 , as well as the cross-section values, dσ/dt| dip = (15.1 ± 2.5)μb/GeV 2 and dσ/dt| bump = (29.7 ± 1.8)μb/GeV 2 , for the dip and the bump, respectively.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

DOE OSTI2020

Elastic differential cross-section ${\mathrm{d}}\sigma /{\mathrm{d}}t$ at $\sqrt{s}=2.76\hbox {TeV}$ and implications on the existence of a colourless C-odd three-gluon compound state

The proton-proton elastic differential cross section dσ/dt has been measured by the TOTEM experiment at √ s = 2.76 TeV energy with β* = 11 m beam optics. The Roman Pots were inserted to 13 times the transverse beam size from the beam, which allowed to measure the differential cross-section of elastic scattering in a range of the squared four-momentum transfer (|t|) from 0.36 GeV 2 to 0.74 GeV 2 . The differential cross-section can be described with an exponential in the |t|-range between 0.36 and 0.54 GeV 2 , followed by a diffractive minimum (dip) at |t dip | = (0.61 ± 0.03) GeV 2 and a subsequent maximum (bump). The ratio of the dσ/dt at the bump and at the dip is 1.7±0.2. When compared to the proton–antiproton measurement of the D0 experiment at √ s = 1.96 TeV, a significant difference can be observed. Under the condition that the effects due to the energy difference between TOTEM and D0 can be neglected, the result provides evidence for a colourless C-odd three-gluon bound state exchange in the t-channel of the proton-proton and proton–antiproton elastic scattering.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

DOE OSTI2019

Elastic differential cross-section measurement at $\sqrt{s}=13$ TeV by TOTEM

The TOTEM collaboration has measured the elastic proton-proton differential cross section dσ/d t at √s = 13 TeV LHC energy using dedicated β* = 90 m beam optics. The Roman Pot detectors were inserted to 10σ distance from the LHC beam, which allowed the measurement of the range [0.04 GeV 2 ; 4 GeV 2 ] in four-momentum transfer squared | t |. The efficient data acquisition allowed to collect about 10 9 elastic events to precisely measure the differential cross-section including the diffractive minimum (dip), the subsequent maximum (bump) and the large-| t | tail. The average nuclear slope has been found to be B = (20.40 ± 0.002 stat ± 0.01syst) GeV –2 in the | t |-range 0.04–0.2 GeV 2 . The dip position is | t dip | = (0.47 ± 0.004 stat ± 0.01 syst ) GeV 2 . The differential cross section ratio at the bump vs. at the dip R = 1.77 ± 0.01 stat has been measured with high precision. The series of TOTEM elastic pp measurements show that the dip is a permanent feature of the pp differential cross-section at the TeV scale.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

DOE OSTI2019

First measurement of elastic, inelastic and total cross-section at $$\sqrt{s}=13$$ s = 13 TeV by TOTEM and overview of cross-section data at LHC energies: TOTEM Collaboration

The TOTEM collaboration has measured the proton–proton total cross section at s√=13 TeV with a luminosity-independent method. Using dedicated β*=90 m beam optics, the Roman Pots were inserted very close to the beam. The inelastic scattering rate has been measured by the T1 and T2 telescopes during the same LHC fill. After applying the optical theorem the total proton–proton cross section is σ tot =(110.6 ± 3.4 ) mb, well in agreement with the extrapolation from lower energies. This method also allows one to derive the luminosity-independent elastic and inelastic cross sections σ el =(31.0 ± 1.7) mb and σ inel =(79.5 ± 1.8) mb .

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

DOE OSTI2017

Diamond detectors for the TOTEM timing upgrade

This paper describes the design and the performance of the timing detector developed by the TOTEM Collaboration for the Roman Pots (RPs) to measure the Time-Of-Flight (TOF) of the protons produced in central diffractive interactions at the LHC . The measurement of the TOF of the protons allows the determination of the longitudinal position of the proton interaction vertex and its association with one of the vertices reconstructed by the CMS detectors. The TOF detector is based on single crystal Chemical Vapor Deposition (scCVD) diamond plates and is designed to measure the protons TOF with about 50 ps time precision. This upgrade to the TOTEM apparatus will be used in the LHC run 2 and will tag the central diffractive events up to an interaction pileup of about 1. A dedicated fast and low noise electronics for the signal amplification has been developed. The digitization of the diamond signal is performed by sampling the waveform. In conclusion, after introducing the physics studies that will most profit from the addition of these new detectors, we discuss in detail the optimization and the performance of the first TOF detector installed in the LHC in November 2015.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

DOE OSTI2016

Measurement of elastic pp scattering at $\sqrt{\hbox {s}} = \hbox {8}$ TeV in the Coulomb–nuclear interference region: Determination of the ρ-parameter and the total cross-section

Here, the TOTEM experiment at the CERN LHC has measured elastic proton–proton scattering at the centre-of-mass energy s√=8TeV and four-momentum transfers squared, |t|, from 6 × 10 –4 to 0.2 GeV 2 . Near the lower end of the t-interval the differential cross-section is sensitive to the interference between the hadronic and the electromagnetic scattering amplitudes. This article presents the elastic cross-section measurement and the constraints it imposes on the functional forms of the modulus and phase of the hadronic elastic amplitude. The data exclude the traditional Simplified West and Yennie interference formula that requires a constant phase and a purely exponential modulus of the hadronic amplitude. For parametrisations of the hadronic modulus with second- or third-order polynomials in the exponent, the data are compatible with hadronic phase functions giving either central or peripheral behaviour in the impact parameter picture of elastic scattering. In both cases, the ρ-parameter is found to be 0.12±0.03. The results for the total hadronic cross-section are σ tot = (102.9±2.3) mb and (103.0±2.3) mb for central and peripheral phase formulations, respectively. Both are consistent with previous TOTEM measurements.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

DOE OSTI2016

LHC Forward Physics

The goal of this report is to give a comprehensive overview of the rich field of forward physics, with a special attention to the topics that can be studied at the LHC. The report starts presenting a selection of the Monte Carlo simulation tools currently available, chapter 2, then enters the rich phenomenology of QCD at low, chapter 3, and high, chapter 4, momentum transfer, while the unique scattering conditions of central exclusive production are analyzed in chapter 5. The last two experimental topics, Cosmic Ray and Heavy Ion physics are presented in the chapter 6 and 7 respectively. Chapter 8 is dedicated to the BFKL dynamics, multiparton interactions, and saturation. The report ends with an overview of the forward detectors at LHC. Each chapter is correlated with a comprehensive bibliography, attempting to provide to the interested reader with a wide opportunity for further studies.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗