Engineering Papers⌕ Search

Engineering topics

Farr, T. G.

Publications and source records attributed to Farr, T. G..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1991

Measurement of surface microtopography

Acquisition of ground truth data for use in microwave interaction modeling requires measurement of surface roughness sampled at intervals comparable to a fraction of the microwave wavelength and extensive enough to adequately represent the statistics of a surface unit. Sub-centimetric measurement accuracy is thus required over large areas, and existing techniques are usually inadequate. A technique is discussed for acquiring the necessary photogrammetric data using twin film cameras mounted on a helicopter. In an attempt to eliminate tedious data reduction, an automated technique was applied to the helicopter photographs, and results were compared to those produced by conventional stereogrammetry. Derived root-mean-square (RMS) roughness for the same stereo-pair was 7.5 cm for the automated technique versus 6.5 cm for the manual method. The principal source of error is probably due to vegetation in the scene, which affects the automated technique but is ignored by a human operator.

Wall, S. D.↗
NASA NTRS1989

Spaceborne radar observations: A guide for Magellan radar-image analysis

Geologic analyses of spaceborne radar images of Earth are reviewed and summarized with respect to detecting, mapping, and interpreting impact craters, volcanic landforms, eolian and subsurface features, and tectonic landforms. Interpretations are illustrated mostly with Seasat synthetic aperture radar and shuttle-imaging-radar images. Analogies are drawn for the potential interpretation of radar images of Venus, with emphasis on the effects of variation in Magellan look angle with Venusian latitude. In each landform category, differences in feature perception and interpretive capability are related to variations in imaging geometry, spatial resolution, and wavelength of the imaging radar systems. Impact craters and other radially symmetrical features may show apparent bilateral symmetry parallel to the illumination vector at low look angles. The styles of eruption and the emplacement of major and minor volcanic constructs can be interpreted from morphological features observed in images. Radar responses that are governed by small-scale surface roughness may serve to distinguish flow types, but do not provide unambiguous information. Imaging of sand dunes is rigorously constrained by specific angular relations between the illumination vector and the orientation and angle of repose of the dune faces, but is independent of radar wavelength. With a single look angle, conditions that enable shallow subsurface imaging to occur do not provide the information necessary to determine whether the radar has recorded surface or subsurface features. The topographic linearity of many tectonic landforms is enhanced on images at regional and local scales, but the detection of structural detail is a strong function of illumination direction. Nontopographic tectonic lineaments may appear in response to contrasts in small-surface roughness or dielectric constant. The breakpoint for rough surfaces will vary by about 25 percent through the Magellan viewing geometries from low to high Venusian latitudes. Examples of anomalies and system artifacts that can affect image interpretation are described.

Ford, J. P.↗
NASA NTRS1989

Measurement of surface microtopography using helicopter-mounted stereo film cameras and two stereo matching techniques

A common problem in acquiring ground-truth data for use in microwave interaction modeling is the capture of surface roughness data that are both sampled at distances comparable to a fraction of the wavelength and extensive enough to represent the surface statistics in at least one resolution cell of the microwave remote sensor used. A technique has been developed for acquiring the necessary photogrammetric data using twin 70-mm film cameras mounted on a helicopter boom. The apparatus is described, and the accuracy with which ground surface roughness can be characterized using this device is estimated. Both standard and cross-correlation methods were used for data reduction. Stereogrammetry is compared with a completely automated image-matching technique. Dense disparity images were generated from the helicopter stereo pairs. Using interior orientation parameters supplied by the camera manufacturers, and assuming that exterior orientation parameters remain constant between control target and test field photography, an extremely dense DEM (digital elevation model) for a test field has been derived. Results are compared, and accuracy estimates are presented.

Wall, S. D.↗
NASA NTRS1989

Inference of geophysical parameters from multifrequency polarimetric radar observations and model inversion

In summer 1988 an intensive field experiment was conducted in the vicinity of the Pisgah lava flow in the Mojave Desert. Physical properties such as microtopography, composition, soil moisture, and dielectric constant were measured at five sites representing surfaces with rms heights varying from less than one centimeter to tens of centimeters. In addition, polarimetric radar images at P-band, L-band, and C-band were acquired at three different incidence angles with the NASA/JPL airborne imaging radar polarimeter. Using trihedral corner reflectors deployed in the area prior to imaging, the L- and C-band images were calibrated to provide sigma0 values for each resolution element in the scene. The results of inferring geophysical parameters such as rms surface height and correlation length of the measured surfaces by fitting the observed signatures with those predicted by the small-perturbation model are presented: for smoother surfaces, the rms height values inferred are in good agreement with in situ measurements.

Van Zyl, J. J.↗
NASA NTRS1988

Inference of geologic surface parameters from polarimetric radar observations and model inversion

The results of inferring geologic parameters such as rms surface height, correlation length, and dielectric constant of rough surfaces by fitting observed polarization signatures with those predicted by the second order Rice model are discussed. The inferred results are compared to measured values of rms height and correlation length. The rms height values inferred are in good agreement with in situ measurements. The inferred correlation lengths generally do not agree with measured values. The results allow the separation of the effects of surface roughness and dielectric constant on the overall backscatter from rough surfaces.

Vanzyl, Jakob J.↗
NASA NTRS1986

A Fourier-based textural feature extraction procedure

A procedure is presented to discriminate and characterize regions of uniform image texture. The procedure utilizes textural features consisting of pixel-by-pixel estimates of the relative emphases of annular regions of the Fourier transform. The utility and derivation of the features are described through presentation of a theoretical justification of the concept followed by a heuristic extension to a real environment. Two examples are provided that validate the technique on synthetic images and demonstrate its applicability to the discrimination of geologic texture in a radar image of a tropical vegetated area.

Stromberg, W. D.↗
NASA NTRS1986

Multipolarization radar images for geologic mapping and vegetation discrimination

NASA has developed an airborne SAR that simultaneously yields image data in four linear polarizations in L-band with 10-m resolution over a swath of about 10 km. Signal data are recorded both optically and digitally and annotated in each of the channels to facilitate completely automated digital correlation. Comparison of the relative intensities of the different polarizations furnishes discriminatory mapping information. Local intensity variations in like-polarization images result from topographic effects, while strong cross polarization responses denote the effects of vegetation cover and, in some cases, possible scattering from the subsurface. In each of the areas studied, multiple polarization data led to the discrimination and mapping of unique surface unit features.

Evans, D. L.↗
NASA NTRS1985

Age-dating volcanic and alluvial surfaces with multipolarization data

A false-color multipolarization version of one of the images of Owens Valley area acquired by the JPL Synthetic Aperture Radar (SAR) is given. A geologic map of the alluvial fans there (Gillespie, 1982) is also given for comparison. In general, brightness in the multipolarization images can be seen to be inversely proportional to the age of the surfaces. A more detailed investigation of the relationship between backscatter and age of the surfaces was undertaken with calibrated aircraft SAR data. The quantitative relationship between backscatter coefficient and age for the three polarizations is shown. The straight lines connecting the measured data points imply a steady-state process, although the process or processes leading to this relationship may have operated at rates that varied with climate fluctuations, such as the glacial ages. It is expected that the relationship between radar brightness and age is a consistent one, and that with the wider availability of calibrated radar backscatter data, these relationships can be less well-known areas. The effect of variable such as past climate fluctuations, tectonic disturbance, and rock type must be understood before extension beyond the Mojave Desert region can be attempted.

Farr, T. G.↗
NASA NTRS1984

Quantitative use of multiincidence-angle SAR for geologic mapping

It is proposed that techniques be developed and used for quantitative interpretation of shuttle imaging radar-B (SIR-B) data for lithologic identification and mapping. The use of backscatter versus incidence angle signatures derived from SIR-B images is to be investigated. The use of SIR-B with other sensors for geologic mapping is also to be considered. Anticipated results are discussed in terms of geologic mapping.

Farr, T. G.↗
NASA NTRS1984

Recent advances in geologic mapping by radar

Quantitative techniques are available which allow the analysis of SAR images for the derivation of geological surface and process data. In conjunction with calibrated radar sensors operating at several incidence angles, wavelengths, and polarizations, the compilation of multiparameter radar signatures of lithological and geomorphic units can accordingly proceed for geological mapping in unknown areas. While radar image tone can be used in arid zones to derive surface micromorphology, heavily vegetated tropical regions require the analysis of radar image texture by means of Fourier techniques which decompose the image into bandpasses that represent different scales of texture.

Farr, T. G.↗