Engineering topics

Farbridge, J. E.

Publications and source records attributed to Farbridge, J. E..

3 records

NASA NTRS1979

The Transonic Multifoil Augmentor Wing

The paper describes the development of a thick (t/c = 0.18) transonic, multifoil, blown augmentor-wing section and discusses the results of a series of wind-tunnel tests on the configuration. The results show that the blown multifoil section enjoys two advantages over a conventional unblown single-foil supercritical section or the same overall thickness-chord ratio: 1) "effective" drag reduced by blowing, and 2) increased drag rise Mach number (M(sub D) = 0.75); they also demonstrate that augmentor blowing improves the buffet boundaries of the section. Thus, overall, it has been shown that the augmentor flap configuration is capable of extending the speed range of a jet transport aircraft to the very low approach speeds required by STOL aircraft [as demonstrated by the NASA/DITC (Canadian Department of Industry Trade and Commerce) augmentor-wing STOL research aircraft] and also to the high subsonic speed required for cruise, where it is shown to be competitive with the plain supercritical airfoil.

Smith, Ronald C.↗

NASA NTRS1978

Some aspects of powerplant airframe integration affecting fuel conservation

The performance criteria for STOL transport aircraft place many constraints on engineering design, which, in turn, may have a direct bearing on fuel efficiency: these constraints become even more severe with the introduction of powered-lift for turbofan aircraft. Consideration is given to some aspects of performance and design which arise as a result of powerplant/airframe integration and an attempt is made to assess these factors in terms of transport fuel efficiency. The drag polars of various powered lift concepts are analyzed to determine the installed thrust/weight required and a simple method of relating this to fuel efficiency is suggested. Some other factors have been identified as being important to this aspect of design and these are discussed in more general terms. Finally, special consideration is given to recent Canadian research in the realm of supercritical airfoil technology as applied to an multi-foil section which could be utilized both for the STOL regime of flight and for cruise at transonic speeds.

Farbridge, J. E.↗

NASA NTRS1977

The transonic multi-foil Augmentor-Wing

The paper describes the development of a transonic blown multi-foil Augmentor-Wing airfoil section that has a thickness/chord (t/c) value of 0.18. In comparison with an unblown single-foil supercritical section of the same overall t/c the new multi-foil section is characterized by an increased drag rise Mach number, increased buffet boundaries, and a reduction in 'effective' drag due to blowing. Potential advantages of the Augmentor-Wing are considered and the testing of three high-speed models in a trisonic pressurized wind tunnel (possessing a two-dimensional transonic insert) is discussed. The data indicate that a very thick wing is feasible since separations toward the rear of the main foil can be controlled both by shroud location and augmentor blowing.

Farbridge, J. E.↗