Engineering Papers⌕ Search

Engineering topics

Esser, Ruth

Publications and source records attributed to Esser, Ruth.

28 records · Page 2

Exploring the temperature structure of coronal holes with a novel combination of visible Fe lines

The difficulty in establishing the temperature structure and temperature gradient within coronal holes from limb observations is due to the frequent veiling of coronal holes by hotter and denser quiet regions often surrounding them and shaping their boundaries. Nevertheless probing the coronal hole medium itself can be made with a judicious choice of spectral lines. We show how a set of visible forbidden Fe lines, namely Fe IX 3801, Fe X 6374 and Fe Xl 7892 A which are sensitive to plasma temperatures less than or equal to 10(exp 6) K can achieve this purpose. We propose to use these lines in a coordinated manner with coronagraph observations. In addition observations made with the Fe XIV 5303 A line should yield information about any hot material intercepting the line of sight. The proposed combination of these Fe lines offers a very powerful diagnostic tool for coronal hole temperatures and structures.

Habbal, Shadia Rifai↗

Demonstrating the limitations of line ratio temperature diagnostic using Fe X and Fe XIV spectral line intensity observations

The electron temperature in the inner corona can be derived from spectral line intensity measurements by comparing the ratio of the measured intensities of two spectral lines to the ratio calculated from theoretical models. In a homogeneous plasma the line ratio technique can be used for any two lines if the ratio of the intensities is independent of the density. The corona, however, is far from homogeneous. Even large coronal holes present at the solar poles at solar minimum can be partly or completely obscured by emission from hotter and denser surrounding regions. In this paper we investigate the effect of these surrounding regions on coronal hole temperatures. using daily intensity measurements at 1.15 Rs of the Fe XIV 5303 A and Fe X 6374 A spectral lines carried out at the National Solar Observatory at Sacramento Peak. We show that the temperatures derived using the line ratio technique for these two spectral lines can vary by more than 0.8 x 10(exp 6) K due to the contribution from surrounding regions. This example demonstrates the inadequacy of spectral lines with widely separate peak temperatures for temperature diagnostic.

Brickhouse, Nancy↗

Flow properties of the solar wind obtained from white light data and a two-fluid model

The flow properties of the solar wind from 1 R(sub s) to 1 AU were obtained using a two fluid model constrained by density and scale height temperatures derived from white light observations, as well as knowledge of the electron temperature in coronal holes. The observations were obtained with the white light coronographs on SPARTAN 201-1 and at Mauna Loa (Hawaii), in a north polar coronal hole from 1.16 to 5.5 R(sub s) on 11 Apr. 1993. By specifying the density, temperature, Alfven wave velocity amplitude and heating function at the coronal base, it was found that the model parameters fit well the constraints of the empirical density profiles and temperatures. The optimal range of the input parameters was found to yield a higher proton temperature than electron temperature in the inner corona. The results indicate that no preferential heating of the protons at larger distances is needed to produce higher proton than electron temperatures at 1 AU, as observed in the high speed solar wind.

Habbal, Shadia Rifai↗

Standing shocks in a two-fluid solar wind

We present a numerical study of the formation of standing shocks in the solar wind using a two-fluid time-dependent model in the presence of Alfven waves. Included in this model is the adiabatic cooling and thermal conduction of both electrons and protons. In this study, standing shocks develop in the flow when additional critical points form as a result of either localized momentum addition or rapid expansion of the flow tube below the existing sonic point. While the flow speed and density exhibit the same characteristics as found in earlier studies of the formation of standing shocks, the inclusion of electron and proton heat conduction produces different signatures in the electron and proton temperature profiles across the shock layer. Owing to the strong heat conduction, the electron temperature is nearly continuous across the shock, but its gradient has a negative jump across it, thus producing a net heat flux out of the shock layer. The proton temperature exhibits the same characteristics for shocks produced by momentum addition but behaves differently when the shock is formed by the rapid divergence of the flow tube. The adiabatic cooling in a rapidly diverging flow tube reduces the proton temperature so substantially that the proton heat conduction becomes negligible in the vicinity of the shock. As a result, protons experience a positive jump in temperature across the shock. While Alfven waves do not affect the formation of standing shocks, they contribute to the change of the mmomentum and energy balance across them. We also find that for this solar wind model the inclusion of thermal conduction and adiabatic cooling for the elctrons and protons increases significantly the range of parameters characterizing the formation of standing shocks over those previously found for isothermal and polytropic models.

Habbal, Shadia R.↗

On the derivation of empirical limits on the helium abundance in coronal holes below 1.5 solar radius

We present a simple technique describing how limits on the helium abundance, alpha, defined as the ratio of helium to proton number density, can be inferred from measurements of the electron density and temperature below 1.5 solar radius. As an illustration, we apply this technique to two different data sets: emission-line intensities in the extreme ultraviolet (EUV) and white-light observations, both measured in polar coronal holes. For the EUV data, the temperature gradient is derived from line intensity ratios, and the density gradient is replaced by the gradient of the line intensity. The lower limit on alpha derived from these data is 0.2-0.3 at 1 solar radius and drops very sharply to interplanetary values of a few percent below 1.06 solar radius. The white-light observations yield density gradients in the inner corona beyond 1.25 solar radius but do not have corresponding temperature gradients. In this case we consider an isothermal atmosphere, and derive an upper limit of 0.2 for alpha. These examples are used to illustrate how this technique could be applicable to the more extensive data to be obtained with the upcoming SOHO mission. Although only ranges on alpha can be derived, the application of the technique to data currently available merely points to the fact that alpha can be significantly large in the inner corona.

Habbal, Shadia Rifai↗

Temperature measurements in the inner corona

To increase the understanding of the acceleration of the solar wind, it is necessary to combine observations and theoretical approaches. The importance of coordinated measurements in the inner corona and interplanetary space to place constraints on solar wind models is demonstrated. Given the fact that the temperature in the inner corona is the most important parameter in solar wind modeling, observations from which reliable temperatures can be deduced are crucial for such coordinated approaches. The derivation of temperatures in the inner corona are addressed, as well as which assumptions and models are inherent in the temperatures derived using different observational techniques. Two examples of extreme ultraviolet (EUV) observations are chosen to demonstrate problems that can arise in the interpretation of measurements.

Esser, Ruth↗

Model dependence of velocities derived from coronal resonance lines

Intensity measurements of coronal resonance lines can be used to determine the outflow velocities of the scattering particles, provided the distribution of the densities, temperatures and velocities along the line of sight is known. A parameter study is designed and carried out to investigate the effect of surrounding denser regions with different temperatures and velocities on the velocity deduced from intensity measurements of the H I Lyman-alpha line in low density coronal holes.

Esser, Ruth↗

Spectral line and white-light intensities in the corona in the presence of propagating or standing shocks

The effect of a propagating shock on the H I Ly-alpha line and the polarization brightness in the inner solar wind region is investigated. The shock produces measurable changes in both, and, provided the measurements are made simultaneously, the alteration of the density and velocity across the shock can be derived. For a standing shock, the effect of the Ly-alpha line and the white-light radiation is much smaller.

Esser, Ruth↗

Flow of oxygen ions in the solar wind acceleration region

A solar wind model with protons, electrons, O VII and O VI ions is studied. It is found that ionization and recombination processes lead to an approximately constant density ratio of the oxygen states in the solar wind acceleration region. Although ionization and recombination have a significant effect on the flow speed of the O VI ions, these processes are not fast enough to bring the speed of O VI up to the flow speed of the O VII ions.

Esser, Ruth↗

Line-of-sight effects on spectroscopic measurements in the inner solar wind region

The effect of the integration along the line of sight on the spectral line profiles of the resonantly scattered Lyman alpha radiation emitted by low-density coronal holes at heights above 1.5 Rs from sun center is investigated. It is shown how the spectral lines from this region are influenced by the Lyman alpha emission from surrounding regions with higher densities. The coronal hole and the surrounding areas are described by a two-fluid solar wind model. It is shown that the line-of-sight effects can be important for the interpretation of the Lyman alpha spectral line measurements in the outer corona and inner solar wind.

Esser, Ruth↗