Engineering Papers⌕ Search

Engineering topics

Erzberger, H.

Publications and source records attributed to Erzberger, H..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Automation of On-Board Flightpath Management

The status of concepts and techniques for the design of onboard flight path management systems is reviewed. Such systems are designed to increase flight efficiency and safety by automating the optimization of flight procedures onboard aircraft. After a brief review of the origins and functions of such systems, two complementary methods are described for attacking the key design problem, namely, the synthesis of efficient trajectories. One method optimizes en route, the other optimizes terminal area flight; both methods are rooted in optimal control theory. Simulation and flight test results are reviewed to illustrate the potential of these systems for fuel and cost savings.

Erzberger, H.↗
NASA NTRS1981

Algorithm for fuel conservative horizontal capture trajectories

A real time algorithm for computing constant altitude fuel-conservative approach trajectories for aircraft is described. The characteristics of the trajectory computed were chosen to approximate the extremal trajectories obtained from the optimal control solution to the problem and showed a fuel difference of only 0.5 to 2 percent for the real time algorithm in favor of the extremals. The trajectories may start at any initial position, heading, and speed and end at any other final position, heading, and speed. They consist of straight lines and a series of circular arcs of varying radius to approximate constant bank-angle decelerating turns. Throttle control is maximum thrust, nominal thrust, or zero thrust. Bank-angle control is either zero or aproximately 30 deg.

Neuman, F.↗
NASA NTRS1981

Optimum climb and descent trajectories for airline missions

The characteristics of optimum fixed-range trajectories whose structure is constrained to climb, steady cruise, and descent segments are derived by application of optimal control theory. The performance function consists of the sum of fuel and time costs, referred to as direct operating cost (DOC). The state variable is range to go and the independent variable is energy. In this formulation a cruise segment always occurs at the optimum cruise energy for sufficiently large range. At short ranges (400 n. mi. and less), a cruise segment may also occur below the optimum cruise energy. The existence of such a cruise segment depends primarily on the fuel flow vs thrust characteristics and on thrust constraints. If thrust is a free control variable along with airspeed, it is shown that such cruise segments will not generally occur. If thrust is constrained to some maximum value in climb and to some minimum in descent, such cruise segments generally will occur.

Erzberger, H.↗
NASA NTRS1981

Design of a fuel-efficient guidance system for a STOL aircraft

In the predictive mode, the system synthesizes a horizontal path from an initial aircraft position and heading to a desired final position and heading and then synthesizes a fuel-efficient speed-altitude profile along the path. In the track mode, the synthesized trajectory is reconstructed and tracked automatically. An analytical basis for the design of the system is presented and a description of the airborne computer implementation is given. A detailed discussion of the software, which should be helpful to those who use the actual software developed for these tests, is also provided.

Mclean, J. D.↗
NASA NTRS1981

Cost-minimized aircraft trajectories

For aircraft operating over fixed range, operating costs are basically sum of fuel cost and time cost; but determining minimum cost trajectory can be complex. Program optimizes trajectories with respect to cost function that is based on weighed sum of fuel cost and time cost. Minimum fuel, minimum time, and various delay trajectories are obtained by specifying particular values for fuel and time cost factors.

Lee, H.↗
NASA NTRS1980

Algorithm for fixed-range optimal trajectories

An algorithm for synthesizing optimal aircraft trajectories for specified range was developed and implemented in a computer program written in FORTRAN IV. The algorithm, its computer implementation, and a set of example optimum trajectories for the Boeing 727-100 aircraft are described. The algorithm optimizes trajectories with respect to a cost function that is the weighted sum of fuel cost and time cost. The optimum trajectory consists at most of a three segments: climb, cruise, and descent. The climb and descent profiles are generated by integrating a simplified set of kinematic and dynamic equations wherein the total energy of the aircraft is the independent or time like variable. At each energy level the optimum airspeeds and thrust settings are obtained as the values that minimize the variational Hamiltonian. Although the emphasis is on an off-line, open-loop computation, eventually the most important application will be in an on-board flight management system.

Lee, H. Q.↗
NASA NTRS1980

Constrained optimum trajectories with specified range

The characteristics of optimum fixed-range trajectories whose structure is constrained to climb, steady cruise, and descent segments are derived by application of optimal control theory. The performance function consists of the sum of fuel and time costs, referred to as direct operating costs (DOC). The state variable is range-to-go and the independent variable is energy. In this formulation a cruise segment always occurs at the optimum cruise energy for sufficiently large range. At short ranges (500 n. mi. and less) a cruise segment may also occur below the optimum cruise energy. The existence of such a cruise segment depends primarily on the fuel flow vs thrust characteristics and on thrust constraints. If thrust is a free control variable along with airspeed, it is shown that such cruise segments will not generally occur. If thrust is constrained to some maximum value in climb and to some minimum in descent, such cruise segments generally will occur. The performance difference between free thrust and constrained thrust trajectories has been determined in computer calculations for an example transport aircraft.

Erzberger, H.↗
NASA NTRS1979

Fuel-conservative guidance system for powered-lift aircraft

A concept for automatic terminal area guidance, comprising two modes of operation, was developed and evaluated in flight tests. In the predictive mode, fuel efficient approach trajectories are synthesized in fast time. In the tracking mode, the synthesized trajectories are reconstructed and tracked automatically. An energy rate performance model derived from the lift, drag, and propulsion system characteristics of the aircraft is used in the synthesis algorithm. The method optimizes the trajectory for the initial aircraft position and wind and temperature profiles encountered during each landing approach. The design theory and the results of simulations and flight tests using the Augmentor Wing Jet STOL Research Aircraft are described.

Erzberger, H.↗
NASA NTRS1979

Fuel-conservative guidance system for powered-lift aircraft

A concept for automatic terminal-area guidance, comprising two modes of operation, has been developed and evaluated in flight tests. In the first or predictive mode, fuel-efficient approach trajectories are synthesized in fast time. In the second or tracking mode, the synthesized trajectories are reconstructed and tracked automatically. An energy rate performance model derived from the lift, drag, and propulsion-system characteristics of the aircraft is used in the synthesis algorithm. The method optimizes the trajectory for the initial aircraft position and wind and temperature profiles encountered during each landing approach. The paper describes the design theory and discusses the results of simulations and flight tests using the Augmentor Wing Jet STOL Research Aircraft.

Erzberger, H.↗
NASA NTRS1979

Application of trajectory optimization principles to minimize aircraft operating costs

This paper summarizes various applications of trajectory optimization principles that have been or are being devised by both government and industrial researchers to minimize aircraft direct operating costs (DOC). These costs (time and fuel) are computed for aircraft constrained to fly over a fixed range. Optimization theory is briefly outlined, and specific algorithms which have resulted from application of this theory are described. Typical results which demonstrate use of these algorithms and the potential savings which they can produce are given. Finally, need for further trajectory optimization research is presented.

Sorensen, J. A.↗
NASA NTRS1978

Characteristics of constrained optimum trajectories with specified range

Necessary conditions of optimality are derived for trajectories whose structure is limited to climb, steady cruise, and descent segments. The performance function consists of the sum of fuel and time costs, referred to as direct operating cost (DOC). The state variable is range to go and the independent variable is energy. In this formulation a cruise segment always occurs at the optimum cruise energy for sufficiently large range. At short ranges (500 n. mi. and less) a cruise segment may also occur below the optimum cruise energy. The existence of such a cruise segment depends primarily on the fuel flow vs thrust characteristics and on thrust constraints. If thrust is a free control variable along with airspeed, it is shown that such cruise segments will not generally occur. If thrust is constrained to some maximum value in climb and to some minimum in descent, such cruise segments generally will occur. Computer calculations of typical short-range trajectories obtained about a 1% cost penalty for constraining the thrust.

Erzberger, H.↗
NASA NTRS1978

Optimum horizontal guidance techniques for aircraft

Some problems of automatic guidance of an aircraft in the horizontal plane are described. The horizontal guidance tasks, which such a flight control system should be capable of performing, were identified as being of three types: guiding the aircraft from any initial location and initial heading to (1) any final location and heading; (2) intercept and fly along a line of specified direction; and (3) a final location with arbitrary final heading. Guidance problems such as capturing an ILS beam at a specified point on the beam, intercepting a VOR radial, and point-to-point navigation can be formulated in terms of these problems. The guidance laws minimize the arc distance to fly between initial and final conditions subject to constraints on the minimum turning radius.

Erzberger, H.↗
NASA NTRS1975

Fixed-range optimum trajectories for short-haul aircraft

An algorithm, based on the energy-state method, is derived for calculating optimum trajectories with a range constraint. The basis of the algorithm is the assumption that optimum trajectories consist of, at most, three segments: an increasing energy segment (climb); a constant energy segment (cruise); and a decreasing energy segment (descent). This assumption allows energy to be used as the independent variable in the increasing and decreasing energy segments, thereby eliminating the integration of a separate adjoint differential equation and simplifying the calculus of variations problem to one requiring only pointwise extremization of algebraic functions. The algorithm is used to compute minimum fuel, minimum time, and minimum direct-operating-cost trajectories, with range as a parameter, for an in-service CTOL aircraft and for an advanced STOL aircraft. For the CTOL aircraft and the minimum-fuel performance function, the optimum controls, consisting of air-speed and engine power setting, are continuous functions of the energy in both climb and descent as well as near the maximum or cruise energy. This is also true for the STOL aircraft except in the descent where at one energy level a nearly constant energy dive segment occurs, yielding a discontinuity in the airspeed at that energy. The reason for this segment appears to be the relatively high fuel flow at idle power of the engines used by this STOL aircraft. Use of a simplified trajectory which eliminates the dive increases the fuel consumption of the total descent trajectory by about 10 percent and the time to fly the descent by about 19 percent compared to the optimum.

Erzberger, H.↗
NASA NTRS1975

Time-controlled descent guidance in uncertain winds

A procedure has been developed for constructing a statistical model of the altitude-dependent mean wind profile from the historical record of wind measurements at particular locations. The model is constructed by fitting a Markov process, with altitude as the stage variable, to the historical wind data. The wind model, together with the aircraft dynamics and the error characteristics of the navigation system, are incorporated in the design of a state estimator, which gives the minimum variance estimate of the aircraft state and the wind vector. The state and wind estimates are used as inputs to a linear feedback law for guiding the aircraft along the nominal trajectory. An example design of a time-constrained (4D RNAV) descent guidance system is presented, showing tracking accuracy, control activity, and probability of arrival time with and without the wind estimator.

Menga, G.↗
NASA NTRS1975

Optimum flight profiles for short haul missions

An algorithm, based on the energy-state method, is derived for calculating optimum trajectories with a range constraint. The basis of the algorithm is the assumption that optimum trajectories consist of, at most, three segments: an increasing energy segment (climb); a constant energy segment (cruise); and a decreasing energy segment (descent). The algorithm is used to compute minimum fuel, minimum time, and minimum direct-operating-cost trajectories, with range as a parameter, for an in-service CTOL aircraft and for an advanced STOL aircraft. Use of a simplified trajectory increases the fuel consumption of the total descent trajectory by about 10 percent and the time to fly the descent by about 19 percent compared to the optimum.

Erzberger, H.↗
NASA NTRS1974

Simulation of 4D RNAV in the terminal area

A terminal area control concept based on 4D RNAV (3D plus time) has been developed to take full advantage of STOL aircrafts' unique performance capabilities. The 4D RNAV concept involves an airborne system, a ground system and a protocol for information exchange between aircraft and ground. The function of the airborne system is to synthesize the curved three dimensional (3D) flight path, to predict and control the landing time (4D) and to generate flight director or autopilot commands. The airborne system assumes the ground system will specify the 3D path and assign a conflict-free landing time. A real time simulation of this concept has been developed to evaluate its effectiveness for terminal areas control of STOL aicraft. Key elements of the simulation are a computer graphics traffic display, a scheduling display and a keyboard language for issuing controller commands to simulated aircraft. Initial results and planned experiments are described.

Tobias, L.↗
NASA NTRS1973

Pilot's manual for automated 4D guidance system

Operational procedures and modes of an experimental 4D guidance system are described from the pilot's point of view. The system consists of the experimental avionics equipment referred to as STOLAND and a specially developed software package for the STOLAND digital computer. A capture mode of the system provides arrival time control and automatic tracking of the 4D flight path from any feasible initial aircraft state to any waypoint. Precise arrival time at a waypoint is achieved by means of speed control or, if large delays are required, by path stretching. Continuous recomputation and display of the capture flight path prior to engaging the system permits the pilot to determine the exact moment for terminating a holding or path stretching maneuver in order to achieve a specified arrival time.

Erzberger, H.↗