Engineering topics

Ercius, Peter

Publications and source records attributed to Ercius, Peter.

102 records · Page 6

DOE OSTI2019

Functional Materials Under Stress: In Situ TEM Observations of Structural Evolution

The operating conditions of functional materials usually involve varying stress fields, resulting in structural changes, whether intentional or undesirable. Complex multiscale microstructures including defects, domains, and new phases, can be induced by mechanical loading in functional materials, providing fundamental insight into the deformation process of the involved materials. On the other hand, these microstructures, if induced in a controllable fashion, can be used to tune the functional properties or to enhance certain performance. In situ nanomechanical tests conducted in scanning/transmission electron microscopes (STEM/TEM) provide a critical tool for understanding the microstructural evolution in functional materials. In our study, select results on a variety of functional material systems in the field are presented, with a brief introduction into some newly developed multichannel experimental capabilities to demonstrate the impact of these techniques.

36 MATERIALS SCIENCE↗

DOE OSTI2019

Real time imaging of two-dimensional iron oxide spherulite nanostructure formation

The formation of complex hierarchical nanostructures has attracted a lot of attention from both the fundamental science and potential applications point of view. Spherulite structures with radial fibrillar branches have been found in various solids; however, their growth mechanisms remain poorly understood. Here, we report real time imaging of the formation of two-dimensional (2D) iron oxide spherulite nanostructures in a liquid cell using transmission electron microscopy (TEM). By tracking the growth trajectories, we show the characteristics of the reaction front and growth kinetics. Our observations reveal that the tip of a growing branch splits as the width exceeds certain sizes (5.5–8.5 nm). The radius of a spherulite nanostructure increases linearly with time at the early stage, transitioning to nonlinear growth at the later stage. Furthermore, a thin layer of solid is accumulated at the tip and nanoparticles from secondary nucleation also appear at the growing front which later develop into fibrillar branches. The spherulite nanostructure is polycrystalline with the co-existence of ferrihydrite and Fe3O4 through-out the growth. Finally, a growth model is further established, which provides rational explanations on the linear growth at the early stage and the nonlinearity at the later stage of growth.

77 NANOSCIENCE AND NANOTECHNOLOGY↗

DOE OSTI2019

Hierarchically-structured large superelastic deformation in ferroelastic-ferroelectrics

Large superelastic deformation in ferroelastic-ferroelectrics (FMs) is a complex phenomenon involving multiple mechanisms operating simultaneously. Understanding how these mechanisms contribute corporately is critical to apply this useful property to the intrinsically brittle FMs, which can therefore display both excellent functional and mechanical performance. Here, we have directly observed and quantitatively analyzed in situ in a transmission electron microscope the three main mechanisms of twinning domain, phase transformation and mobile point defect contributing to extremely large superelastic deformation in single-crystal BaTiO 3 (5.0% strain) and Pb(Mg 1/3 Nb 2/3 )O 3 -PbTiO 3 (10.1% strain). Finally, our results reveal the hierarchical origin of large recoverable strain in “brittle” FMs.

36 MATERIALS SCIENCE↗

DOE OSTI2019

Estimation of Line Cross Sections Using Critical-Dimension Grazing-Incidence Small-Angle X-Ray Scattering

Currently, the semiconductor industry is continuously pushing the limits of photolithography, with feature sizes now smaller than 10 nm. To ensure quality, it has become necessary to look beyond the conventional metrological techniques. X-ray scattering has emerged as a possible contender to determine the average shape of a line grating with subnanometer precision. Yet, to fulfill its promise, faster algorithms must also be developed to interpret and extract metrics from reciprocal-space scattering data. In this paper, we present a fast and accurate x-ray technique and analysis algorithm: critical-dimension grazing-incidence small-angle x-ray scattering (CD GISAXS). The CD GISAXS technique is used in grazing-incidence configuration with a continuous azimuthal rotation of the sample, and thus does not require high-energy x-rays to penetrate the wafer and greatly reduces the data-acquisition times, permitting analysis within the framework of the distorted-wave Born approximation.

36 MATERIALS SCIENCE↗

DOE OSTI2019

Mechanisms of local stress sensing in multifunctional polymer films using fluorescent tetrapod nanocrystals

Nanoscale stress-sensing can be used across fields ranging from detection of incipient cracks in structural mechanics to monitoring forces in biological tissues. We demonstrate how tetrapod quantum dots (tQDs) embedded in block-copolymers act as sensors of tensile/compressive stress. Remarkably, tQDs can detect their own composite dispersion and mechanical properties, with a switch in optomechanical response when tQDs are in direct contact. Using experimental characterizations, atomistic simulations and finite-element analyses, we show that under tensile stress, densely-packed tQDs exhibit a photoluminescence peak shifted to higher energies (“blue-shift”) due to volumetric compressive stress in their core; loosely-packed tQDs exhibit a peak shifted to lower energies (“red-shift”) from tensile stress in the core. The stress-shifts result from the tQD's unique branched morphology in which the CdS arms act as antennas that amplify the stress in the CdSe core. Our nanocomposites exhibit excellent cyclability and scalability with no degraded properties of the host polymer. Colloidal tQDs allow sensing in many materials to potentially enable auto-responsive, smart structural nanocomposites that self-predict impending fracture.

36 MATERIALS SCIENCE↗

DOE OSTI2019

Shape-controlled synthesis and in situ characterisation of anisotropic Au nanomaterials using liquid cell transmission electron microscopy

Understanding the mechanisms behind crystal nucleation and growth is a fundamental requirement for the design and production of bespoke nanomaterials with controlled sizes and morphologies. In this work, we select gold (Au) nanoparticles as the model system for our study due to their representative applications in biology, electronics and optoelectronics. We investigate the radiation-induced in situ growth of gold (Au) particles using liquid cell transmission electron microscopy (LCTEM) and study the growth kinetics of non-spherical Au structures. Under controlled electron fluence, liquid flow rate and Au 3+ ion supply, we show the favoured diffusion-limited growth of multi-twinned nascent Au seed particles into branched structures when using thin liquid cells (100 nm and 250 nm) in LCTEM, whereas faceted structures (e.g., spheres, rods, and prisms) formed when using a 1 μm thick liquid cell. In addition, we observed that anisotropic Au growth could be modulated by Au-binding amyloid fibrils, which we ascribe to their capability to regulate Au 3+ ion diffusion and mass transfer in solution. We anticipate that this study will provide new perspectives on the shape-controlled synthesis of anisotropic metallic nanomaterials using LCTEM.

36 MATERIALS SCIENCE↗

DOE OSTI2019

Atomic Resolution Probing of Phase Transformations and Domain Evolution During Large Superelastic Deformation in Ferroelectrics with in situ TEM

Intrinsically brittle Ferroelectrics have attractive applications such as flexible/wearable electronic devices and mechanically-written high-density memory that depend on both functional and mechanical performance. One potential way to mitigate their brittle behavior is through large superelastic deformation stemming from strain-driven phase transformations and domain evolution. Therefore, in this work, we investigated free-standing single-crystal BaTiO 3 and Pb(Mg 1/3 Nb 2/3 )O 3 -PbTiO 3 sub-micrometer pillars during large superelastic deformation, directly observing the stress-induced phase transformations and domain evolution by using in situ Scanning Transmission Electron Microscope (STEM). We found ultra-small and multiple-phase coexistence with sizes down to a few unit cells, and we were able to study them at atomic resolution while under load. Notably, extremely small phase transformation structures and domain structures are often introduced during the large superelastic deformations since the stress field is not screened in ferroelectrics, as compared to the situation with electrical field or thermal cycling.

36 MATERIALS SCIENCE↗

DOE OSTI2019

The 4D Camera: Very High Speed Electron Counting for 4D-STEM

A vast array of new experimental modalities have been enabled in the past several years through the development of pixelated detectors synchronized to probe scanning electronics. Such camera systems can then acquire the rich information present in the central portion of the convergent beam electron diffraction pattern as a function of probe position (4D-STEM). Here, we present the development, installation, and characterization of the 4D Camera, a CMOS Active Pixel Sensor that consists of a 576 x 576 array of 10 μm pixels of a design related to the original TEAM detector and an outer HAADF detector with 16 concentric quadrant diodes.

47 OTHER INSTRUMENTATION↗

DOE OSTI2019

In situ TEM observation of neck formation during oriented attachment of PbSe nanocrystals

Oriented attachment of nanocrystals is an important route to constructing epitaxially-connected nanocrystal superlattices for various applications. During oriented attachment of semiconductor nanocrystals, neck can be formed between nanocrystals and it strongly influences the properties of the resulting superlattice. However, the neck formation mechanism is poorly understood. Here, we use in situ liquid cell transmission electron microscopy to directly observe the initiation and growth of homoepitaxial necks between PbSe nanocrystals with atomic details. We find that neck initiation occurs slowly (~ 10 s) when two nanocrystals approach to each other within an edge-to-edge distance of 0.6 nm. During neck initiation, Pb and Se atoms defuse from other facets into the gap, forming “dynamic reversible” filaments. Once the filament (neck) width is larger than a critical size of 0.9 nm, it gradually (15 s) widens into a 3-nm-wide neck. The atomic structure of the neck is further obtained using ex situ aberration-corrected scanning TEM imaging. Neck initiation and growth mechanisms are elucidated with density functional theory calculations. As a result, our direct unveiling of the atomic pathways of neck formation during oriented attachment shed light into the fabrication of nanocrystal superlattices with improved structural order and electronic properties.

77 NANOSCIENCE AND NANOTECHNOLOGY↗

DOE OSTI2019

Metal-insulator transition in quasi-one-dimensional HfTe 3 in the few-chain limit

The quasi-one-dimensional linear chain compound HfTe 3 is experimentally and theoretically explored in the few- to single-chain limit. Confining the material within the hollow core of carbon nanotubes allows isolation of the chains and prevents the rapid oxidation which plagues even bulk HfTe 3 . High-resolution transmission electron microscopy coupled with density functional theory calculations reveals that, once the triple-chain limit is reached, the normally parallel chains spiral about each other, and simultaneously a short-wavelength trigonal anti-prismatic rocking distortion occurs that opens a significant energy gap. This ends in a size-driven metal-insulator transition.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

DOE OSTI2019

Observing crystal nucleation in four dimensions using atomic electron tomography

Nucleation plays a critical role in many physical and biological phenomena that range from crystallization, melting and evaporation to the formation of clouds and the initiation of neurodegenerative diseases. However, nucleation is a challenging process to study in experiments, especially in the early stage when several atoms or molecules start to form a new phase from a parent phase. A number of experimental and computational methods have been used to investigate nucleation processes, but experimental determination of the three-dimensional atomic structure and the dynamics of early stage nuclei has been unachievable. Here we use atomic electron tomography to study early stage nucleation in four dimensions (4D: that is, including time) at atomic resolution. Using FePt nanoparticles as a model system, we find that early stage nuclei are irregularly shaped, each has a core of one to a few atoms with the maximum order parameter, and the order parameter gradient points from the core to the boundary of the nucleus. We capture the structure and dynamics of the same nuclei undergoing growth, fluctuation, dissolution, merging and/or division, which are regulated by the order parameter distribution and its gradient. These experimental observations are corroborated by molecular dynamics simulations of heterogeneous and homogeneous nucleation in liquid–solid phase transitions of Pt. Our experimental and molecular dynamics results differ from classical nucleation theory, indicating that a theory beyond this is needed to describe early stage nucleation at the atomic scale. Looking forward, we anticipate that the reported approach will open the door to the study of many fundamental problems in materials science, nanoscience, condensed matter physics and chemistry, such as phase transition, atomic diffusion, grain boundary dynamics, interface motion, defect dynamics and surface reconstruction with 4D atomic resolution.

77 NANOSCIENCE AND NANOTECHNOLOGY↗

DOE OSTI2019

Dynamic deformability of individual PbSe nanocrystals during superlattice phase transitions

The behavior of individual nanocrystals during superlattice phase transitions can profoundly affect the structural perfection and electronic properties of the resulting superlattices. However, details of nanocrystal morphological changes during superlattice phase transitions are largely unknown due to the lack of direct observation. Here, we report the dynamic deformability of PbSe semiconductor nanocrystals during superlattice phase transitions that are driven by ligand displacement. Real-time high-resolution imaging with liquid-phase transmission electron microscopy reveals that following ligand removal, the individual PbSe nanocrystals experience drastic directional shape deformation when the spacing between nanocrystals reaches 2 to 4 nm. The deformation can be completely recovered when two nanocrystals move apart or it can be retained when they attach. The large deformation, which is responsible for the structural defects in the epitaxially fused nanocrystal superlattice, may arise from internanocrystal dipole–dipole interactions.

36 MATERIALS SCIENCE↗