Engineering Papers⌕ Search

Engineering topics

Duxbury, T. C.

Publications and source records attributed to Duxbury, T. C..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2005

Model Development and Testing for THEMIS Controlled Mars Mosaics

As part of our work [1] to develop techniques and procedures to create regional and eventually global THEMIS mosaics of Mars, we are developing algorithms and software to photogrammetrically control THEMIS IR line scanner camera images. We have found from comparison of a limited number of images to MOLA digital image models (DIMs) [2] that the a priori geometry information (i.e. SPICE [3]) for THEMIS images generally allows their relative positions to be specified at the several pixel level (e.g. approx.5 to 13 pixels). However a need for controlled solutions to improve this geometry to the sub-pixel level still exists. Only with such solutions can seamless mosaics be obtained and likely distortion from spacecraft motion during image collection removed at such levels. Past experience has shown clearly that such mosaics are in heavy demand by users for operational and scientific use, and that they are needed over large areas or globally (as opposed to being available only on a limited basis via labor intensive custom mapping projects). Uses include spacecraft navigation, landing site planning and mapping, registration of multiple data types and image sets, registration of multispectral images, registration of images with topographic information, recovery of thermal properties, change detection searches, etc.

Archinal, B. A.↗
NASA NTRS2005

Topography of the 81/P Wild 2 Nucleus Derived from Stardust Stereoimages

On 2 January, 2004, the Stardust spacecraft flew by the nucleus of comet 81P/Wild 2 with a closest approach distance of approx. 240 km. During the encounter, the Stardust Optical Navigation Camera (ONC) obtained 72 images of the nucleus with exposure times alternating between 10 ms (near-optimal for most of the nucleus surface) and 100 ms (used for navigation, and revealing additional details in the coma and dark portions of the surface. Phase angles varied from 72 deg. to near zero to 103 deg. during the encounter, allowing the entire sunlit portion of the surface to be imaged. As many as 20 of the images near closest approach are of sufficiently high resolution to be used in mapping the nucleus surface; of these, two pairs of short-exposure images were used to create the nucleus shape model and derived products reported here. The best image resolution obtained was approx. 14 m/pixel, resulting in approx. 300 pixels across the nucleus. The Stardust Wild 2 dataset is therefore markedly superior from a stereomapping perspective to the Deep Space 1 MICAS images of comet Borrelly. The key subset of the latter (3 images) covered only about a quarter of the surface at phase angles approx. 50 - 60 and less than 50 x 160 pixels across the nucleus, yet it sufficed for groups at the USGS and DLR to produce digital elevation models (DEMs) and study the morphology and photometry of the nucleus in detail.

Kirk, R. L.↗
NASA NTRS2004

Asteroid 5535 Annefrank size, shape, and orientation: Stardust first results

The NASA Discovery Stardust spacecraft flew by the main belt asteroid 5535 Annefrank at a distance of 3100 km and a speed of 7.4 km/s in November 2002 to test the encounter sequence developed for its primary science target, the comet 81P/Wild2. During this testing, over 70 images of Annefrank were obtained, taken over a phase angle range from 40 to 140 degrees.

Asteroids NASA Stardust Mission↗
NASA NTRS2004

The Stardust: A Successful Encounter with the Remarkable Comet Wild 2

On January 2, 2004 the Stardust spacecraft completed a close flyby of comet Wild2 (P81). Flying at a relative speed of 6.1 km/s within 237km of the 5 km nucleus, the spacecraft took 72 close-in images, measured the flux of impacting particles and did in-situ compositional analysis of freshly released dust with a time-of-flight mass spectrometer. The primary goal of the mission is to collect >500 particles >15 m diameter and return them to Earth on January 15, 2006. The cometary particles ranging in size from a micron to approx.100 microns were collected in low density silica aerogel. After returning over a hundred 2x4x3 cm aerogel collection cells will be processed at the curatorial facility at the NASA Johnson Space Center and 5 to 100 micron size extracted cometary particles will be distributed to analysts by a system that will be based on the allocation procedures for cosmic dust, Antarctic meteorites and lunar samples.

Brownlee, D. E.↗
NASA NTRS2004

Preparing for Themis Controlled Global Mars Mosaics

We have begun work to prepare for producing controlled 2001 Mars Odyssey THEMIS infrared (IR) and visible (VIS) global mosaics of Mars. This effort is being coordinated with colleagues from Arizona State University and on the THEMIS team who plan to address radiometric issues in making such mosaics. We are concentrating on geometric issues. Several areas of investigation are now in progress, including: a) characterizing the absolute pointing accuracy of THEMIS images; b) investigating whether automatic tie point matching algorithms could be used to provide connections between overlapping THEMIS images; c) developing algorithms to allow for the photogrammetric (bundle) adjustment of the THEMIS IR (line scanner) camera images. Our primary goal in this pilot study effort will be to make several test control THEMIS mosaics and better determine which methods could be used, which require development, and what level of effort is required, in order to make large regional or global controlled THEMIS mosaics.

Archinal, B. A.↗
NASA NTRS2003

Phase curve and albedo of asteroid 5534 Annefrank

Seventy-two images of the S-class asteroid 5535 Annefrank, acquired on 2 November 2002 at target ranges of 11,415??8.5 km, were transmitted to Earth as a part of an engineering readiness test of the Stardust mission. Forty-four of these were used to create a phase curve extending to 134, the largest angle yet achieved for any S-class asteroid. Flux fell by more than six magnitudes between the extrapolated 0 and 134. A maximum illuminated cross section of 16 km2 was seen at a phase angle of 47.2. Assuming a camera efficiency of 75%, a broadband (470?? nm) geometric albedo of 0.24 was derived for Annefrank.

Solar system comets small bodies↗
NASA NTRS2003

Mars Digital Image Model 2.1 Control Network

USGS is currently preparing a new version of its global Mars digital image mosaic, which will be known as MDIM 2.1. As part of this process we are completing a new photogrammetric solution of the global Mars control network. This is an improved version of the network established earlier by RAND and USGS personnel, as partially described previously. MDIM 2.1 will have many improvements over earlier Viking Orbiter (VO) global mosaics. Geometrically, it will be an orthoimage product, draped on Mars Orbiter Laser Altimeter (MOLA) derived topography, thus accounting properly for the commonly oblique VO imagery. Through the network being described here it will be tied to the newly defined IAU/IAG 2000 Mars coordinate system via ties to MOLA data. Thus, MDIM 2.1 will provide complete global orthorectified imagery coverage of Mars at the resolution of 1/256 deg of MDIM 2.0, and be compatible with MOLA and other products produced in the current coordinate system.

Archinal, B. A.↗
NASA NTRS2002

The exploration of Asteroid Annefrank by STARDUST

The NASA Discovery STARDUST spacecraft is set to flyby the vicinity of the main belt asteroid Annefrank in November of this year on its way to encounter the comet P/Wild 2 in January 2004.

Annefrank asteroid STARDUST↗
NASA NTRS2002

A MOLA-controlled RAND-USGS Control Network for Mars

We are undertaking, in support of the Mars Digital Image Mosaic (MDIM) 2.1, many improvements in the RAND-USGS photogrammetric control network for Mars, primarily involving the use of Mars Orbiter Laser Altimeter (MOLA)-derived radii and DIMs to improve control point absolute radii and horizontal positions. Additional information is contained in the original extended abstract.

Archinal, B. A.↗
NASA NTRS2001

Mars and Phobos DTM's for planning new missions

The global digital topography and elevation models of Mars produced by the Mars Global Surveyor (MGS) Mars Orbiter Laser Altimeter (MOLA) and of Mars derived from Viking Orbiter stereo imaging have many uses for geodesy, geophysics, morphology and cartography studies of these two planetary bodies.

Phobos DTM's new mission planning↗
NASA NTRS2001

Mars Express: exploration of Phobos

The ESA Mars Express Orbiter will be nearly polar and have an initial orbital period of 7.6 hours for the first 440 days and then will reduce its period to 6.7 hours. As periapsis of the elliptical orbit walks around Mars every 2 years, the ascending and descending nodes of the Mars Express orbit on the Mars equatorial plane will have the same radius as the orbit of Phobos and close encounters of Phobos will occur when Phobos is near the node as Mars Express passes.

Mars Express exploration of Phobos↗
NASA NTRS2001

A New Era in Geodesy and Cartography: Implications for Landing Site Operations

The Mars Global Surveyor (MGS) Mars Orbiter Laser Altimeter (MOLA) global dataset has ushered in a new era for Mars local and global geodesy and cartography. These data include the global digital terrain model (Digital Terrain Model (DTM) radii), the global digital elevation model (Digital Elevation Model (DEM) elevation with respect to the geoid), and the higher spatial resolution individual MOLA ground tracks. Currently there are about 500,000,000 MOLA points and this number continues to grow as MOLA continues successful operations in orbit about Mars, the combined processing of radiometric X-band Doppler and ranging tracking of MGS together with millions of MOLA orbital crossover points has produced global geodetic and cartographic control having a spatial (latitude/longitude) accuracy of a few meters and a topographic accuracy of less than 1 meter. This means that the position of an individual MOLA point with respect to the center-of-mass of Mars is know to an absolute accuracy of a few meters. The positional accuracy of this point in inertial space over time is controlled by the spin rate uncertainty of Mars which is less than 1 km over 10 years that will be improved significantly with the next landed mission.

Duxbury, T. C.↗
NASA NTRS2001

MOLA-Based Landing Site Characterization

The Mars Global Surveyor (MGS) Mars Orbiter Laser Altimeter (MOLA) data provide the basis for site characterization and selection never before possible. The basic MOLA information includes absolute radii, elevation and 1 micrometer albedo with derived datasets including digital image models (DIM's illuminated elevation data), slopes maps and slope statistics and small scale surface roughness maps and statistics. These quantities are useful in downsizing potential sites from descent engineering constraints and landing/roving hazard and mobility assessments. Slope baselines at the few hundred meter level and surface roughness at the 10 meter level are possible. Additionally, the MOLA-derived Mars surface offers the possibility to precisely register and map project other instrument datasets (images, ultraviolet, infrared, radar, etc.) taken at different resolution, viewing and lighting geometry, building multiple layers of an information cube for site characterization and selection. Examples of direct MOLA data, data derived from MOLA and other instruments data registered to MOLA arc given for the Hematite area.

Duxbury, T. C.↗