Engineering Papers⌕ Search

Engineering topics

Drinkwater, F. J., III

Publications and source records attributed to Drinkwater, F. J., III.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Flight test pilot evaluation of a delayed flap approach procedure

Using NASA's CV-990 aircraft, a delayed flap approach procedure was demonstrated to nine guest pilots from the air transport industry. Four demonstration flights and 37 approaches were conducted under VFR weather conditions. A limited pilot evaluation of the delayed flap procedure was obtained from pilot comments and from questionaires they completed. Pilot acceptability, pilot workload, and ATC compatibility were quantitatively rated. The delayed flap procedure was shown to be feasible, and suggestions for further development work were obtained.

Bull, J. S.↗
NASA NTRS1976

Delayed flap approach procedures for noise abatement and fuel conservation

The NASA/Ames Research Center is currently investigating the delayed flap approach during which pilot actions are determined and prescribed by an onboard digital computer. The onboard digital computer determines the proper timing for the deployment of the landing gear and flaps based on the existing winds and airplane gross weight. Advisory commands are displayed to the pilot. The approach is flown along the conventional ILS glide slope but is initiated at a higher airspeed and in a clean aircraft configuration that allows for low thrust and results in reduced noise and fuel consumption. Topics discussed include operational procedures, pilot acceptability of these procedures, and fuel/noise benefits resulting from flight tests and simulation.

Edwards, F. G.↗
NASA NTRS1975

Exploratory flight investigation of aircraft response to the wing vortex wake generated by the augmentor wing jet STOL research aircraft

A brief exploratory flight program was conducted at Ames Research Center to investigate the vortex wake hazard of a powered-lift STOL aircraft. The study was made by flying an instrumented Cessna 210 aircraft into the wake of the augmentor wing jet STOL research aircraft at separation distances from 1 to 4 n.mi. Characteristics of the wake were evaluated in terms of the magnitude of the upset of the probing aircraft. Results indicated that within 1 n.mi. separation the wake could cause rolling moments in excess of roll control power and yawing moments equivalent to rudder control power of the probe aircraft. Subjective evaluations by the pilots of the Cessna 210 aircraft, supported by response measurements, indicated that the upset caused by the wake of the STOL aircraft was comparable to that of a DC-9 in the landing configuration.

Jacobsen, R. A.↗
NASA NTRS1975

Status report on NASA two-segment approach program

NASA, in cooperation with the FAA, is evaluating the two-segment approach as a routine procedure for reducing aircraft noise. The program calls for separate flight evaluations using a 727 and a DC-8, and an extrapolation of these results to determine the adaptability of the technique to the rest of the fleet. After a review of the total program, this paper presents (1) the profile and procedures developed and the noise reduction achievable, (2) the vortex characteristics behind an aircraft on a two-segment path, and (3) cost estimates for retrofitting aircraft with two-segment avionics.

Denery, D. G.↗
NASA NTRS1975

Flight performance of a navigation, guidance, and control system concept for automatic approach and landing of space shuttle orbiter

Unpowered automatic approaches and landings were conducted to study navigation, guidance, and control problems associated with terminal area approach and landing for the space shuttle vehicle. The flight tests were performed in a Convair 990 aircraft equipped with a digital flight control computer connected to the aircraft control system and displays. The tests were designed to evaluate the performance of a navigation and guidance concept that utilized blended radio/inertial navigation with VOR, DME, and ILS as the ground navigation aids. Results from 36 automatic approaches and landings from 11,300 m (37,000 ft) to touchdown are presented. Preliminary results indicate that this concept may provide sufficient accuracy to accomplish automatic landing of the shuttle orbiter without air-breathing engines.

Edwards, F. G.↗
NASA NTRS1974

Resume of the status and benefits of the two-segment approach and its applicability to the jet transport fleet

NASA, in cooperation with the FAA, is evaluating the two-segment approach as a routine procedure for reducing aircraft noise. The program calls for separate flight evaluations using a 727 and a DC-8, and an extrapolation of these results to determine the adaptability of the technique to the rest of the fleet. The total program is reviewed. The profile and procedures developed and the noise reduction achievable are presented. The vortex characteristics behind an aircraft on a two-segment path is covered. Finally, cost estimates for retrofitting aircraft with two-segment avionics are presented.

Denery, D. G.↗
NASA NTRS1974

Flight test of an automatic approach and landing concept for a simulated space shuttle represented by the NASA Convair 990 aircraft

Unpowered automatic approaches and landings were conducted to study navigation, guidance, and control problems associated with terminal area, approach, and landing operation for the space shuttle. A Convair 990 aircraft was equipped with a digital flight-control computer connected to the aircraft control systems and displays. The flight tests evaluated, from 11,300 m to touchdown, the performance of a navigation and guidance concept that utilized blended radio/inertial navigation with VOR, DME, and ILS as the ground radio navigation aids. The results from 36 automatic approaches and landings are analyzed. Preliminary results indicate that this concept may provide sufficient accuracy that automatic landing of the unpowered shuttle orbiter can be accomplished on a conventional size runway.

Smith, D. W.↗
NASA NTRS1973

Takeoff certification considerations for large subsonic and supersonic transport airplanes using the Ames flight simulator for advanced aircraft

Data for use in development of takeoff airworthiness standards for new aircraft designs such as the supersonic transport (SST) and the large wide-body subsonic jet transport are provided. An advanced motion simulator was used to compare the performance and handling characteristics of three representative large jet transports during specific flight certification tasks. Existing regulatory constraints and methods for determining rotation speed were reviewed, and the effects on takeoff performance of variations in rotation speed, pitch attitude, and pitch attitude rate during the rotation maneuver were analyzed. A limited quantity of refused takeoff information was obtained. The aerodynamics, wing loading, and thrust-to-weight ratio of the subject SST resulted in takeoff speeds limited by climb (rather than lift-off) considerations. Take-off speeds based on U.S. subsonic transport requirements were found unacceptable because of the criticality of rotation-abuse effects on one-engine-inoperative climb performance. Adequate safety margin was provided by takeoff speeds based on proposed Anglo-French supersonic transport (TSS) criteria, with the limiting criterion being that takeoff safety speed be at least 1.15 times the one-engine-inoperative zero-rate-of-climb speed. Various observations related to SST certification are presented.

Snyder, C. T.↗
NASA NTRS1972

Motion simulator study of longitudinal stability requirements for large delta wing transport airplanes during approach and landing with stability augmentation systems failed

A ground-based simulator investigation was conducted in preparation for and correlation with an-flight simulator program. The objective of these studies was to define minimum acceptable levels of static longitudinal stability for landing approach following stability augmentation systems failures. The airworthiness authorities are presently attempting to establish the requirements for civil transports with only the backup flight control system operating. Using a baseline configuration representative of a large delta wing transport, 20 different configurations, many representing negative static margins, were assessed by three research test pilots in 33 hours of piloted operation. Verification of the baseline model to be used in the TIFS experiment was provided by computed and piloted comparisons with a well-validated reference airplane simulation. Pilot comments and ratings are included, as well as preliminary tracking performance and workload data.

Snyder, C. T.↗
NASA NTRS1972

Flight evaluation of three-dimensional area navigation for jet transport noise abatement.

The NASA, working with American Airlines, has completed the first phase of research to evaluate the operational feasibility of two-segment approaches for noise abatement. For these tests, area navigation was used to establish the upper glide slope and an ILS was used to establish the lower. The flight director was modified to provide command information during the entire approach. Twenty-eight pilots representing the airlines, professional pilot associations, FAA, and NASA participated. With an ILS approach for comparison, the procedure gave a noise reduction of 18 EPNdB at the outer marker and 8 EPNdB 1.1 n. mi. from touchdown.

Denery, D. G.↗
NASA NTRS1972

Low-lift-to-drag-ratio approach and landing studies using a CV-990 airplane

The results are presented of a flight-test program utilizing a CV-990 airplane, flow in low-lift-to-drag-ratio (L/D) configurations, to simulate terminal area operation, approach, and landing of large unpowered vehicles. The results indicate that unpowered approaches and landings are practical with vehicles of the size and performance characteristics of the proposed shuttle vehicle. Low L/D landings provided touchdown dispersion patterns acceptable for operation on runways of reasonable length. The dispersion pattern was reduced when guidance was used during the final approach. High levels of pilot proficiency were not required for acceptable performance.

Kock, B. M.↗