Engineering Papers⌕ Search

Engineering topics

Donlan, C. J.

Publications and source records attributed to Donlan, C. J..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

The Space Transportation System

The Space Transportation System, consisting of the Space Shuttle, Spacelab, and the Space Tug, is discussed from the viewpoint of reductions in the cost of space operations. Each of the three vehicles is described along with its mission capabilities, and the time table for system development activities is outlined. Basic attributes of the Space Transportation System are reviewed, all operational modes are considered, and the total cost picture of the system is examined from the standpoint of a mission economic analysis. It is concluded that as the features of the Space Transportation System, especially the Shuttle and the Tug, are put to more efficient use during the maturing-operation phase, the total cost of conducting space missions should be about half of what it would be if any other system were employed.

Donlan, C. J.↗
NASA NTRS1976

An approximate spin design criterion for monoplanes, 1 May 1939

An approximate empirical criterion, based on the projected side area and the mass distribution of the airplane, was formulated. The British results were analyzed and applied to American designs. A simpler design criterion, based solely on the type and the dimensions of the tail, was developed; it is useful in a rapid estimation of whether a new design is likely to comply with the minimum requirements for safety in spinning.

Seidman, O.↗
NASA NTRS1976

Spin tests of a 1/20-scale model of the XP-39 airplane, 15 March 1939

The tests were performed to determine the spinning characteristics of a 1/20-scale model of the Bell XP-39 airplane. Effects of loading changes and of various control dispositions were studied. Subsequent tests were performed to determine the effect of a change in wing dihedral.

Donlan, C. J.↗
NASA NTRS1976

Spin tests of a 1/20-scale model of the XF4U-1 airplane, 12 July 1939

These tests were performed to determine the spinning characteristics of the 1/20-scale model of the XF4U-1 airplane. Effects of loading changes and various control dispositions using both the original and modified vertical tail surfaces were studied. Subsequent tests were made to determine the effects of additional tail modifications.

Donlan, C. J.↗
NASA NTRS1976

Spin tests of a low-wing monoplane to investigate scale effect in the model test range, May 1941

Concurrent tests were performed on a 1/16 and a 1/20 scale model (wing spans of 2.64 and 2.11 ft. respectively) of a modern low wing monoplane in the NACA 15 foot free-spinning wind tunnel. Results are presented in the form of charts that afford a direct comparison between the spins of the two models for a number of different conditions. Qualitatively, the same characteristic effects of control disposition, mass distribution, and dimensional modifications were indicated by both models. Quantitatively, the number of turns for recover and the steady spin parameters, with the exception of the inclination of the wing to the horizontal, were usually in good agreement.

Donlan, C. J.↗
NASA NTRS1976

Methods of analyzing wind-tunnel data for dynamic flight conditions

The effects of power on the stability and the control characteristics of an airplane are discussed and methods of analysis are given for evaluating certain dynamic characteristics of the airplane that are not directly discernible from wind tunnel tests alone. Data are presented to show how the characteristics of a model tested in a wind tunnel are affected by power. The response of an airplane to a rolling and a yawing disturbance is discussed, particularly in regard to changes in wing dihedral and fin area. Solutions of the lateral equations of motion are given in a form suitable for direct computations. An approximate formula is developed that permits the rapid estimation of the accelerations produced during pull-up maneuvers involving abrupt elevator deflections.

Donlan, C. J.↗
NASA NTRS1976

The effect of cowling shape on the stability characteristics of an airplane, September 1942

Three widely different nose shapes were tested on a fuselage alone and on a complete model in the NACA stability tunnel to investigate the effect of cowling shape on stability characteristics. The results are presented in the form of charts which show the variation in the aerodynamic characteristics with the three nose shapes for the propeller-removed condition over a wide range of angles of attack and yaw. The results indicated that large changes in the cowling shape produced relatively small changes in the aerodynamic characteristics. The effects may be appreciable, however, in the case of an airplane that has marginal stability.

Donlan, C. J.↗
NASA NTRS1976

Some theoretical considerations of longitudinal stability in power-on flight with special reference to wind-tunnel testing, November 1942

Some problems relating to longitudinal stability in power-on flight are considered. A derivation is included which shows that, under certain conditions, the rate of change of the pitching moment coefficient with lift coefficient as obtained in wind tunnel tests simulating constant power operation is directly proportional to one of the indices of stability commonly associated with flight analysis, (the slope of the curve relating the elevator angle for trim and lift coefficient). The necessity of analyzing power-on wind tunnel data for trim conditions is emphasized, and a method is provided for converting data obtained from constant thrust tests to simulated constant throttle flight conditions.

Donlan, C. J.↗
NASA NTRS1976

Lateral stability and control tests of the XP-77 airplane in the NACA full-scale tunnel, 16 June 1944

Tests were made in the NACA full-scale tunnel to determine the lateral stability and control characteristics of the XP-77 airplane. Measurements were made of the forces and moments on the airplane at various angles of attack and angles of yaw. The measurements were made with the propeller removed and with the propeller installed and operating at various thrust coefficients, and with the landing flaps retracted and deflected. The effects of aileron, elevator, and rudder deflection on control surface effectiveness and hinge moments were determined. The tests were planned to obtain the data required to evaluate as completely as possible the Army Air Force requirements on lateral stability and control for pursuit-type airplanes.

Czarnecki, K. R.↗
NASA NTRS1976

The stability and control of tailless airplanes, 19 August 1944

In the present state of the design of tailless airplanes, it appears that: (1) Sweepback affords a method of supplying tail length for directional and longitudinal stability and control and allows the utilization of a high-lift flap but introduces undersirable tip stalling tendencies that must be overcome before the advantages of sweepback can be realized. (2) The damping in pitching appears to have little effect on the longitudinal behavior of the airplane provided the static margin is never permitted to become negative. (3) The directional stability must be as great as for conventional airplanes if the same requirements regarding satisfactory stability and control characteristics are to be adhered to. (4) The influence of the lateral resistance and the damping in yawing on the flying qualities is somewhat obscure.

Donlan, C. J.↗
NASA NTRS1976

Wind-tunnel tests of a 1/4 scale model of the Bell XS-1 transonic airplane. 1: Longitudinal stability and control characteristics

A 1/4 scale model of the Bell XS-1 transonic aircraft was tested in the Langley 300 mile-per-hour 7 by 10 foot tunnel to determine its low speed longitudinal stability and control characteristics. Pertinent longitudinal flying qualities expected of the XS-1 research airplane were estimated from the results of these tests including the effects of compressibility likely to be encountered at speeds below the force break. It appears that the static longitudinal stability and elevator control power will be adequate, but that the elevator control force gradient in steady flight will be undesirably low for all configurations. It is suggested that a centering spring be incorporated in the elevator control system of the airplane in order to increase the control force gradient in steady flight and in maneuvers.

Donlan, C. J.↗
NASA NTRS1976

Current status of longitudinal stability, 24 May 1948

The problems of static and dynamic longitudinal stability both at high speeds and at low speeds are discussed and data are presented which indicate progress made in the solution of these problems. It is shown that the incorporation of large amounts of sweepback on both the wing and the horizontal tail can significantly increase the Mach number at which critical trim changes and stability changes occur and can greatly reduce the trim changes and stability changes encountered at supercritical speeds. Data are also presented which demonstrate the possibility of obtaining satisfactory longitudinal stability in the landing configuration for wings with sweepback of the order of 45 deg utilizing various stall control devices. Optimum arrangements for such devices, however, should be determined experimentally.

Donlan, C. J.↗
NASA NTRS1976

Low-speed wind-tunnel investigation of the longitudinal stability characteristics of a model equipped with a variable-speed wing, 23 May 1949

The longitudinal stability characteristics of a complete model equipped with a variable sweep wings at angles of sweepback of 45 deg, 30 deg, 15 deg, and 0 deg investigated. Various wing modifications and an extern 1 flap arrangement designed to minimize the shift in neutral point accompanying the change in sweep angle were studied. The results indicate that stability at the stall was obtained at a sweep angle of 15 deg without recourse to stall control devices. The basic neutral point movement accompanying the change in sweep angle from 45 deg to 15 deg amounted to 56 percent of the mean aerodynamic chord (at zero sweep angle) and the most effective modification investigated only reduced this change to 47 percent of the chord. It appears, therefore, that for designs in which the fuselage is the major load carrying element some relative movement between the wing and center of gravity will be required to assure satisfactory stability at all sweep angles.

Donlan, C. J.↗
NASA NTRS1976

Estimated transonic flying qualities of a tailless airplane based on a model investigation, 8 June 1949

Flying qualities of a tailless airplane with the wing quarter chord line swept back 35 deg were analyzed in the Mach number range from 0.40 to 0.91 based on tests of a model of this airplane in the Langley high speed 7 by 10 foot tunnel. The results indicate that longitudinal control position instability exists at transonic speeds but the accompanying trim changes are not large. Control position maneuvering stability, however, is present for all speeds. Longitudinal and lateral control appear adequate, but the damping of the short period longitudinal and lateral oscillations at high altitudes is poor and would probably require artificial damping.

Donlan, C. J.↗