Engineering Papers⌕ Search

Engineering topics

Domitz, S.

Publications and source records attributed to Domitz, S..

12 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1984

Optical and interfacial electronic properties of diamond-like carbon films

Hard, semitransparent carbon films were prepared on oriented polished crystal wafers of silicon, indium phosphide and gallium arsenide, as well as on KBr and quartz. Properties of the films were determined using IR and visible absorption spectrocopy, ellipsometry, conductance-capacitance spectroscopy and alpha particle-proton recoil spectroscopy. Preparation techniques include RF plasma decomposition of methane (and other hydrocarbons), ion beam sputtering, and dual-ion-beam sputter deposition. Optical energy band gaps as large as 2.7 eV and extinction coefficients lower than 0.1 at long wavelengths are found. Electronic state densities at the interface with silicon as low as 10 to the 10th states/eV sq cm per were found.

Woollam, J. A.↗
NASA NTRS1979

Neutralization tests on the SERT II spacecraft

Orbit precession returned the SERT II spacecraft to continuous sunlight in January 1979 for the first time since early 1972, and new experiments were planned and conducted. Neutralization of an ion beam was accomplished by a second neutralizer cathode located 1 meter away. Plasma potential measurements were made of the plasma surrounding the ion beam and connecting the beam to the second neutralizer. When the density of the connecting plasma was increased by turning on the main discharge of a neighboring ion thruster, the neutralization of the ion beam occurred with improved (lower) coupling voltage. These and other tests reported should aid in the future design of spacecraft using electric thruster systems. Data taken indicate that cross neutralization of ion thrusters in a multiple thruster array should occur readily.

Kerslake, W. R.↗
NASA NTRS1979

Effect of parasitic plasma currents on solar-array power output

Solar-array voltage-current curves are calculated by assuming the existence of parasitic loads that consist of local currents of charged particles collected by the array. Three cases of interest are calculated to demonstrate how the distribution and magnitude of parasitic currents affect output. Solar array performance degradation became significant when the total parasitic current plus the load current exceeded the short-circuit current. Approximate graphical methods were useful for many applications. Power loss, which was calculated by summing the product of parasitic current and the local potential, underestimated the loss in maximum power.

Domitz, S.↗
NASA NTRS1979

Neutralization tests on the SERT 2 spacecraft

Neutralization test data obtained on the SERT 2 spacecraft are presented. Tests included ion beam neutralization of a thruster by a close (normal design) neutralizer as well as by a distant (1 meter) neutralizer. Parameters affecting neutralization, such as neutralizer bias voltage, neutralizer anode voltage, local spacecraft plasma density, and solar array voltage configuration were varied and changes in plasma potentials were measured. A plasma model is presented as an approximation of observed results.

Kerslake, W. R.↗
NASA NTRS1976

The interactions of solar arrays with electric thrusters

The generation of a charge-exchange plasma by a thruster, the transport of this plasma to the solar array, and the interaction of the solar array with the plasma after it arrives are all described. The generation of this plasma can be described accurately from thruster geometry and operating conditions. The transport of the charge-exchange plasma was studied experimentally with a 15 cm thruster. A model was developed for simple thruster-array configurations. A variety of experiments were surveyed for the interaction of the plasma at the solar array.

Kaufman, H. R.↗
NASA NTRS1975

Current from a dilute plasma measured through holes in insulators

The current collected from a plasma through holes in insulated electrodes was measured. Holes of 0.051- and 2.54-cm diameters in Kapton H film and plasma number densities of 100 and 10,000 electrons/cu cm were used. The current collected by bare electrodes, that is, electrodes with no surrounding insulation, is also presented. For all the samples the current at a given voltage was a function of the surrounding insulator area rather than of the hole size or the underlying electrode size. In addition, at the low plasma density the I-V characteristic showed very steep rises for voltages below 1 kV. In one case the current jumped by a factor of approximately 70 to 200 V. Results are given for positive biases to 10 kV. For negative biases, sparking prevented testing most samples to the 10-kV limit.

Grier, N. T.↗
NASA NTRS1974

The interaction of spacecraft high voltage power systems with the space plasma environment

The development of spacecraft with electrical loads that require high voltage power is discussed. The high voltage solar array has been considered for supplying d.c. power directly to high voltage loads such as ion thrusters and communication tubes without intermediate power processing. Space power stations for transferring solar power to earth are being studied in the 40 kilovolt, multikilowatt regime. Analytical and experimental studies have determined that with the advent of high voltage power, new problems will arise through the interaction of the high voltage surfaces with the charged particle environment of space. The interactive environment has been identified and duplicated to some extent in simulation facilities at NASA-Lewis Research Center and at several contractor locations.

Domitz, S.↗
NASA NTRS1974

The interaction of spacecraft high voltage power systems with the space plasma environment

Research work has shown that the interaction of a spacecraft and its high voltage power systems with the space plasma environment can result in harmful power loss and damage to insulators and metal surfaces. Insulator and solar panel tests were performed and flight tests are planned. High voltage power processing equipment was shown to be affected by power loss, and by transients due to plasma interactions. Power loss was determined to be roughly proportional to the square of the voltage and increases approximately as the square root of the area. Kapton, Teflon, and glass were found to be satisfactory insulating materials and it is concluded that for large space power stations should consider the effect of large pinhole currents.

Domitz, S.↗