Engineering Papers⌕ Search

Engineering topics

Doggett, Robert V., Jr.

Publications and source records attributed to Doggett, Robert V., Jr..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1995

Flutter clearance flight tests of an OV-10A airplane modified for wake vortex flight experiments

The envelope expansion, flight flutter tests of a modified OV-10A aircraft are described. For the wake vortex research program, the airplane was modified to incorporate three forward-extending instrumentation booms, one extending forward from each wing tip and one from the right side of the fuselage. The booms were instrumented with sensors to measure the velocity and direction of local air flow. The flutter test results show that the modified OV-10A aircraft is free from flutter at speeds up to 330 KEAS at 5000 feet altitude.

Doggett, Robert V., Jr.↗
NASA NTRS1994

The use of the Regier number in the structural design with flutter constraints

This preliminary investigation introduces the use of the Regier number as a flutter constraint criterion for aeroelastic structural optimization. Artificial neural network approximations are used to approximate the flutter criterion requirements as a function of the design Mach number and the parametric variables defining the aspect ratio, center of gravity, taper ratio, mass ratio, and pitch inertia of the wing. The presented approximations are simple enough to be used in the preliminary design stage without a well defined structural model. An example problem for a low-speed, high-aspect-ratio, light-aircraft wing is presented. The example problem is analyzed for the flutter Mach number using doublet lattice aerodynamics and the PK solution method. The use of the Regier number constraint criterion to optimize the example problem for minimum structural mass while maintaining a constant flutter Mach number is demonstrated.

Dunn, H. J.↗
NASA NTRS1993

Attenuation of empennage buffet response through active control of damping using piezoelectric material

Dynamic response and damping data obtained from buffet studies conducted in a low-speed wind tunnel by using a simple, rigid model attached to spring supports are presented. The two parallel leaf spring supports provided a means for the model to respond in a vertical translation mode, thus simulating response in an elastic first bending mode. Wake-induced buffeting flow was created by placing an airfoil upstream of the model of that the wake of the airfoil impinged on the model. Model response was sensed by a strain gage mounted on one of the springs. The output signal from the strain gage was fed back through a control law implemented on a desktop computer. The processed signals were used to 'actuate' a piezoelectric bending actuator bonded to the other spring in such a way as to add damping as the model responded. The results of this 'proof-of-concept' study show that the piezoelectric actuator was effective in attenuating the wake-induced buffet response over the range of parameters investigated.

Heeg, Jennifer↗
NASA NTRS1993

Data acquisition for aeroelastic testing at the NASA Langley Transonic Dynamics Facility

Aeroelasticity is defined and different types of aeroelastic tests are described. The instrumentation and data acquisition requirements dictated by the time varying characteristics of aeroelastic phenomena are pointed out. Instrumentation needs for various types of tests are discussed. The hardware components and operational features of the real-time, digital-computer-controlled data acquisition system used to support testing at the Langley Transonic Dynamics Facility, which includes a major wind-tunnel, a helicopter-model hover facility, and two model setup and calibration laboratories are described.

Doggett, Robert V., Jr.↗
NASA NTRS1991

Flutter Spoilers

Spoiling devices deployed rapidly to prevent damage to airfoil surfaces. When flutter spoiler deployed, unsteady aerodynamic forces changed and flutter dynamic pressure increased. Because flutter spoiler deployed rapidly, violent increase in vibration amplitude that usually occurs at flutter prevented from occurring. Consists of one or more platelike structures hinged along leading edge to surface of wing or other lifting surface so spoiler rotated outward into airstream. Located on both upper and lower airfoil surfaces, but used on either. When not in use, fold against or into wing surface so aerodynamic contour of wing remains unchanged.

Doggett, Robert V., Jr.↗
NASA NTRS1991

On simple aerodynamic sensitivity derivatives for use in interdisciplinary optimization

Low-aspect-ratio and piston aerodynamic theories are reviewed as to their use in developing aerodynamic sensitivity derivatives for use in multidisciplinary optimization applications. The basic equations relating surface pressure (or lift and moment) to normal wash are given and discussed briefly for each theory. The general means for determining selected sensitivity derivatives are pointed out. In addition, some suggestions in very general terms are included as to sample problems for use in studying the process of using aerodynamic sensitivity derivatives in optimization studies.

Doggett, Robert V., Jr.↗
NASA NTRS1991

Structural dynamic and aeroelastic considerations for hypersonic vehicles

The specific geometrical, structural, and operational environment characteristics of hypersonic vehicles are discussed with particular reference to aerospace plane type configurations. A discussion of the structural dynamic and aeroelastic phenomena that must be addressed for this class of vehicles is presented. These phenomena are in the aeroservothermoelasticity technical area. Some illustrative examples of recent experimental and analytical work are given. Some examples of current research are pointed out.

Cazier, F. W., Jr.↗
NASA NTRS1991

NASP aeroservothermoelasticity studies

Some illustrative results obtained from work accomplished under the aerothermoelasticity work breakdown structure (WBS) element of the National Aerospace Plane (NASP) Technology Maturation Program (TMP) are presented and discussed. The objectives of the aerothermoelasticity element were to develop analytical methods applicable to aerospace plane type configurations, to conduct analytical studies to identify potential problems, to evaluate potential solutions to problems, and to provide an experimental data base to verify codes and analytical trends. Work accomplished in the three areas of experimental data base, unsteady aerodynamics, and integrated analysis methodology are described. Some of the specific topics discussed are: (1) transonic wind tunnel aeroelastic model tests of cantilever delta wing models, of an all-moveable delta-wing model, and of aileron buzz models; (2) unsteady aerodynamic theory correlation with experiment and theory improvements; and (3) integrated analysis methodology results for thermal effects on vibration, for thermal effects on flutter, and for improving aeroelastic performance by using active controls.

Doggett, Robert V., Jr.↗
NASA NTRS1991

Structural dynamic and aeroelastic considerations for hypersonic vehicles

Structural dynamic and aeroelastic considerations applicable to hypersonic vehicles are discussed. Emphasis is given to aerospace plane configurations. The definition of aerothermoelasticity and the operational flight environment are reviewed, and structural dynamic and aeroelastic areas of concern are individually discussed, including vibration, landing and taxiing, propellant dynamics, acoustics, lifting surface flutter, panel flutter, control surface buzz, buffeting, gust response, and static aeroelasticity. Recent research results from all-moveable delta-wing aerolastic studies, engine inlet lip aeroelastic analysis, and studies of thermal effects on vibration frequencies, aerodynamic heating effects on flutter, and active control of aeroelastic response are reviewed.

Cazier, F. W., Jr.↗
NASA NTRS1991

Some subsonic and transonic buffet characteristics of the twin-vertical-tails of a fighter airplane configuration

Vertical-tail buffet response data were obtained from tests in the Langley Transonic Dynamics Tunnel using a rigid, 1/6-size, full-span model of an F-18 airplane that was fitted with flexible vertical tails of two different levels of structural stiffness. Response data are presented at Mach numbers from 0.30 to 0.95 over a range of angles of attack from -10 to +40 degrees. These data indicate the following: (1) the buffet response occurs in the first bending mode; (2) the buffet response is a maximum in the angle of attack range from 30 to 40 degrees; (3) the buffet response increases with increasing dynamic pressure, but changes in response are not linearly proportional to the changes in dynamic pressure; (4) the buffet response is larger at M = 0.30 than it is at the higher Mach numbers; and (5) the maximum intensity of the buffeting is described as heavy to severe using an assessment criteria proposed by another investigator.

Moss, Steven W.↗
NASA NTRS1990

Some observations on the Houbolt-Rainey and peak-hold methods of flutter onset prediction

A subcritical response method for flutter onset prediction developed by Houbolt and Rainey in 1958 is compared with the Peak-Hold Method which was apparently first applied to flutter onset prediction by Sandford, Abel, and Gray in the early 1970's. The rational argument presented shows that the two methods are not different, but are actually the same. So, because there is an analytical foundation for the Houbolt-Rainey Method, then there is the same analytical foundation for the Peak-Hold Method. Further, it is suggested that, in applying Peak-Hold Method in cases where turbulence is used as the excitation force, the variation of the reciprocal of the response amplitude with the reciprocal of the dynamic pressure to be used to extrapolate to flutter onset rather than the variation with dynamic pressure which is the current practice because the linear trend which is predicted to occur for the former is easier to extrapolate to the flutter condition than the nonlinear trend predicted to occur for the latter.

Doggett, Robert V., Jr.↗
NASA NTRS1990

Some buffet response characteristics of a twin-vertical-tail configuration

A rigid, 1/6 size, full span model of an F-18 airplane was fitted with flexible vertical tails of two different levels of stiffness that were buffet tested in the Langley Transonic Dynamics Tunnel. Vertical tail buffet response results that were obtained over the range of angles of attack from -10 to 40 degs, and over the range of Mach numbers from 0.30 to 0.95 are presented. These results indicate the following: (1) the response occurs in the first bending mode; (2) the response increases with increasing dynamic pressure, but changes in response are not linearly proportional to the changes in dynamic pressure; (3) the response is larger at M = 0.30 than it is at the higher Mach numbers; (4) the maximum intensity of the buffeting is described as heavy to severe using an assessment criteria proposed by another investigator; and (5) the data at different dynamic pressures and for the different tails correlate reasonably well using the buffet excitation parameter derived from the dynamic analysis of buffeting.

Cole, Stanley R.↗
NASA NTRS1989

Experimental transonic flutter characteristics of two 72 deg-sweep delta-wing models

Transonic flutter boundaries are presented for two simple, 72 deg. sweep, low-aspect-ratio wing models. One model was an aspect-ratio 0.65 delta wing; the other model was an aspect-ratio 0.54 clipped-delta wing. Flutter boundaries for the delta wing are presented for the Mach number range of 0.56 to 1.22. Flutter boundaries for the clipped-delta wing are presented for the Mach number range of 0.72 to 0.95. Selected vibration characteristics of the models are also presented.

Doggett, Robert V., Jr.↗
NASA NTRS1989

Some effects of aerodynamic spoilers on wing flutter

The effects of deployment angle and size of symmetrically mounted upper-surface and lower-surface spoilers on the flutter characteristics of a simple, paddle-like, low-aspect-ratio, rectangular wing model that was tested at Mach number 0.80 in the Langley Transonic Dynamics Tunnel are presented. The results show that the flutter dynamic pressure is increased by increasing either spoiler deployment angle or spoiler size. For the configurations studied spoiler size was more effective than deployment angle in increasing the flutter dynamic pressure.

Doggett, Robert V., Jr.↗
NASA NTRS1989

Some low-speed flutter characteristics of simple low-aspect-ratio delta wing models

Some results from a combined experimental and analytical study of the low-speed flutter characteristics of low-aspect-ratio delta wings are presented. Data are presented which show the effects of sweep angle on the flutter characteristics of some simple plate models of constant planform area. The range of sweep angles studied was from 30 to 72 degrees. In addition, flutter results are presented for two 30 deg-sweep clipped-delta wing models. Further, results are presented that show the effects of root clamping (percentage length of the root chord that is cantilevered) for a 45 deg-sweep delta wing. The experimental data are compared with analytical results obtained by using kernel function and doublet lattice subsonic unsteady lifting surface theories.

Doggett, Robert V., Jr.↗
NASA NTRS1989

Some low-speed flutter characteristics of simple low-aspect-ratio delta wing models

Some results from a combined experimental and analytical study of the low-speed flutter characteristics of low-aspect-ratio delta wings are presented. Data are presented which show the effects of sweep angle on the flutter characteristics of some simple plate models of constant planform area. The range of sweep angles studied was from 30 to 72 degrees. In addition, flutter results are presented for two 30 deg-sweep clipped-delta wing models. Further results are presented that show the effects of root clamping (percentage length of the root chord that is cantilevered) for a 45 deg-sweep delta wing. The experimental data are compared with analytical results obtained by using kernel function and doublet lattice subsonic unsteady lifting surface theories.

Doggett, Robert V., Jr.↗
NASA NTRS1988

Aircraft aeroelasticity and structural dynamics research at the NASA Langley Research Center: Some illustrative results

Highlights of nine different research studies are described. Five of these topics relate directly to fixed-wing aircraft and range from flutter studies using relatively simple and inexpensive wind-tunnel models to buffet studies of the vertical tails of an advanced high performance configuration. The other four topics relate directly to rotary-wing aircraft and range from studies of the performance and vibration characteristics of an advanced rotor design to optimization of airframe structures for vibration attenuation.

Doggett, Robert V., Jr.↗