Engineering topics
Publications and source records attributed to Dobrotin, B. M..
Time-response simulation studies carried out in support of the development and validation of the guidance/steering subsystem of a wire-following-vehicle (WFV) are described. A lateral guidance system is outlined, field testing and simulation validation are covered, and time response simulation results are discussed.
A Mars rover is planned for the mid-1980's as a follow-up to the Viking program, and as a prelude to a return-to-earth mission of Martian samples in the late eighties or early nineties. An overall view of the rover's configuration is presented with a summary of basic design parameters. Six subsystems are outlined: computing, with a 10 to the 8th bit bubble memory; mobility, designed for a journey of 100 km in 2 earth years; science sample acquisition, including a soil auger and hard rock drill; power, supplied by an RTG and stored in batteries; telecommunication, with 50 K bit UHF transmission relayed through an orbiter; and visual imaging, employing two television cameras, each with an 800 x 800 pixel charge coupled device. Scientific research goals include information about Martian seismic characteristics, magnetic field, surface heat flow, chemical composition, geology along a transverse, and meteorology. Attention is given to the necessity of rover autonomy from earth commands.
The replacement of the driver with an automatic system which could perform the functions of guiding and routing a vehicle with a human's capability of responding to changing traffic demands was discussed. The problem was divided into four technological areas; guidance, routing, computing, and communications. It was determined that the latter three areas being developed independent of any need for fully automated urban traffic. A guidance system that would meet system requirements was not being developed but was technically feasible.
This paper presents an approach to a microprocessor based computing system for a Mars Roving Vehicle. This represents a practical example in that it combines a breadboard robot (the Rover) with a distributed microprocessor computing system, both of which are under development at JPL and are being considered for a 1984 Mars Rover Mission. A summary of the Rover functions is presented, along with an approach of applying distributed computers. The Rover is then partitioned into its main subsystems (executive, locomotion, manipulation, and vision) and subsystem and system interfaces established. Computing requirements are discussed and a system diagram developed.
A brief outline of NASA's current robotics program is presented. Efforts are being concentrated on a roving surface vehicle for Mars exploration. This vehicle will integrate manipulative, locomotive, and visual functions and will feature an electromechanical manipulator, stereo TV cameras, a laser rangefinder, a minicomputer, and a remote off-line computer. The program hinges on the iterative development of complex scenarios describing the robot's mission and the interrelationships among its various subsystems.
Strapdown electrostatic aerospace navigator /SEAN/ using electrostatically suspended gyros /ESG/ for inertial reference, including drift and computer tests
Formulation of problem of guiding low thrust spacecraft back to nominal trajectory