Engineering Papers⌕ Search

Engineering topics

Distefano, Sal

Publications and source records attributed to Distefano, Sal.

9 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2014

Goal Based Testing: A Risk Informed Process

A process for life demonstration testing is developed, which can reduce the number of resources required by conventional sampling theory while still maintaining the same degree of rigor and confidence level. This process incorporates state-of-the-art probabilistic thinking and is consistent with existing NASA guidance documentation. This view of life testing changes the paradigm of testing a system for many hours to show confidence that a system will last for the required number of years to one that focuses efforts and resources on exploring how the system can fail at end-of-life and building confidence that the failure mechanisms are understood and well mitigated.

Everline, Chester↗
NASA NTRS2014

The Use of Redundancy to Improve Reliability of Deep Space Missions Using Stirling Radioisotope Generator Power Sources

This study will look at the 140 We class generator as originally envisioned for the ASRG and a larger generator that is scaled up to use four times the fuel. The results discussed below quantify the effect of the use of smaller generators and indicates that a scheme that makes use of several smaller generators enhances the system reliability and allows for more graceful degradation.

Bolotin, Gary↗
NASA NTRS2005

Performance of High-Efficiency Advanced Triple-Junction Solar Panels for the LILT Mission Dawn

NASA's Discovery Mission Dawn is designed to (LILT) conditions. operate within the solar system's Asteroid belt, where the large distance from the sun creates a low-intensity, low-temperature (LILT) condition. To meet the mission power requirements under LlLT conditions, very high-efficiency multi-junction solar cells were selected to power the spacecraft to be built by Orbital Sciences Corporation (OSC) under contract with JPL. Emcore's InGaP/InGaAs/Ge advanced triple-junction (ATJ) solar cells, exhibiting an average air mass zero (AMO) efficiency of greater than 27.6% (one-sun, 28 C), were used to populate the solar panels [1]. The two solar array wings, to be built by Dutch Space, with 5 large- area panels each (total area of 36.4 sq. meters) are projected to produce between 10.3 kWe and 1.3 kWe of end-of life (EOL) power in the 1.0 to 3.0 AU range, respectively. The details of the solar panel design, testing and power analysis are presented.

triple junction solar cells↗
NASA NTRS1994

Battery study for the Mars Environmental Survey (MESUR) Pathfinder

Viewgraphs on the battery study for the Mars Environmental Survey (MESUR) Pathfinder are presented. Topics covered include: MESUR pathfinder introduction; power subsystem concept; battery technology selection; mission battery performance; cell/battery baseline design; charge methodology; and proposed testing.

Dawson, Stephen F.↗
NASA NTRS1993

NASA Center update: Jet Propulsion Laboratory

The topics covered are presented in viewgraph form and include the following: flight project support activities for TOPEX and the Mars Observer; and research/development and engineering activities for NiCd model development, secondary lithium battery development, the sodium-NiCl2 moderate temperature battery, Li-SOCl2 batteries for the Centaur launch vehicle, and direct hydrocarbon/methanol fuel cells.

Distefano, Sal↗
NASA NTRS1993

Electrical characterization of the Magellan batteries after storage

Two 22 cell batteries designed by Martin Marietta were tested. The batteries were rated at 26.5 Amp-Hr. The battery design is characterized by the following: Gates Aerospace 42B030AB15, 11 pos/12 neg, Pellon 2536 separator, passivated pos/teflonated neg. The tests can be summarized as follows: (1) no noticeable capacity loss after storage period; and (2) batteries exhibited larger non-uniformity of cell voltages during constant current charge.

Deligiannis, Frank↗
NASA NTRS1993

TOPEX/Poseidon battery performance

The following observations were made during the first occultation period: (1) C/D ratios tend to be higher during the initial and final segment of the occultation period; (2) the net overcharge parameter is useful in assessing C/D's; (3) small peak power cusps were present during the initial and final segment of the occultation period--no cusps during the remaining period; (4) small differential voltages (less than 12 mV) were recorded; and (5) the peak charge current was within the recommended limits. In summary, the batteries are operating within recommended limits, and their performance is excellent.

Deligiannis, Frank↗