Engineering topics

Dinh, L. N.

Publications and source records attributed to Dinh, L. N..

3 records

DOE OSTI2023

Refined Outgassing Model for the LiH/LiOH System

Previous models for H 2 and H 2 O outgassing from moisture exposed LiH specimens were based on temperature programmed desorption/decomposition (TPD) experiments and analyses that yielded kinetic descriptions which were specific to defined sets of initial conditions. Subsequently the inputs to the kinetic models were refined to correlate with infrared spectra of the adsorbed species. In this current enhancement, better agreement between prediction and experiment was obtained through: 1) refining the reaction mechanisms for some of the decomposition reactions; 2) developing the potential range of kinetic parameters by simultaneous fitting of all the TPD outgassing curves obtained at different heating rates; and, 3) limiting the scope of possible kinetic parameters to an optimized subset by matching the outgassing prediction curves at 3 different temperatures to the outcomes from the accurate but cumbersome, non-intuitive, and effort demanding isoconversional analysis.

36 MATERIALS SCIENCE↗

DOE OSTI2023

The kinetics of the PuO 2 to Pu 2 O 3 conversion

Here in an oxidizing environment, the oxide formed on plutonium (Pu) metal is composed of a plutonium dioxide (PuO 2 ) top layer and a thin cubic plutonium sesquioxide (Pu 2 O 3 ) middle layer. In a reducing environment, the PuO 2 layer auto-reduces to cubic Pu 2 O 3 . The speed and extent of this conversion depend on the combination of temperature and time. While PuO 2 provides a strong diffusion barrier against unwanted Pu corrosion by gaseous species (like hydrogen), Pu 2 O 3 does not, since its crystal structure has chains of oxygen vacancies. The kinetics of the PuO 2 reduction are, therefore, of fundamental interest and enable researchers to better protect Pu from corrosion. In this report, the oxygen-diffusion-limited kinetics of the dioxide to sesquioxide conversion were obtained by dynamically heating a PuO 2 -covered Pu sample from 294 to 418 K in a high-vacuum vessel equipped with an in situ spectroscopic ellipsometer. The physical/chemical constraints in the conversion process were combined with the ellipsometry method of multi-sample analysis to track the percentage of PuO 2 and to compute the extent of Pu 2 O 3 formation. The resulting diffusion coefficients were compared against and then combined with complementary literature data to produce a comprehensive set of kinetic parameters for reliably modeling oxide conversion over a larger temperature range than spanned by prior studies. The extracted thermal activation energy barrier (43.7 kJ/mol) and pre-exponential factor (5.0 × 10 -10 cm 2 /s) for the oxygen-diffusion-limited process can be used to accurately model the PuO 2 to Pu 2 O 3 transformation in vacuum and/or inert gas applications.

36 MATERIALS SCIENCE↗

DOE OSTI2021

Develop low-temperature diffusional moisture outgassing model for silica-filled silicones

A universal outgassing model for all silica-filled silicones would allow researchers to make moisture outgassing predictions for many different silica-filled silicones using the same sets of kinetic parameters (but with different intensities for the outgassing constituents). In FY 2020, we succeeded in developing such a model for outgassing in a vacuum/dry environment after ~ 1-2 hours of room temperature vacuum pump. That means the FY2020 model does not account for the low temperature diffusional moisture outgassing during the first few hours under vacuum pump. In FY 2021, we have used the experimental technique of dynamic vapor sorption together with the modified Page diffusion model to measure and quantify the low temperature (i. e. room temperature) diffusional moisture release to complete our universal moisture outgassing model for silica-filled silicones from low temperatures to high temperatures.

36 MATERIALS SCIENCE↗