Skip to content

Engineering topics

Despotopulos, John D.

Publications and source records attributed to Despotopulos, John D..

26 records · Page 2

All sources NASA NTRS DOE OSTI

DOE OSTI2022

Development of Chemical Procedures for Isotope Harvesting: Separation of Trace Hafnium from Tungsten

The separation of trace hafnium from bulk tungsten alloys is of interest for isotope harvesting at the National Superconducting Cyclotron Laboratory and the Facility for Rare Ion Beams because 172 Hf, the parent of 172 Lu, accumulates in tungsten alloy beam blockers at these facilities. In this work, a procedure for the separation of trace hafnium from a bulk tungsten alloy (454 g) was established using tracer isotopes ( 175 Hf, 88 Zr, 173 Lu, and 88 Y). Here, the procedure employed dissolution in an HF–HNO 3 solution followed by a calcium fluoride precipitation, and then extraction chromatography was used for more selective separation steps. Two stages of column separations using LN resin (HDEHP based) and TRU resin (CMPO based) were performed. Gamma-ray spectroscopy and mass spectrometry were used to analyze the final hafnium sample and follow the steps in the chemical processing. Furthermore, the final recovery of hafnium was high (90 ± 8)%, and the mass of tungsten and other transition metals was reduced to near background levels (as determined by ICP-MS of the blank acid solutions). Zirconium follows hafnium quantitatively in this procedure; there was no detectable 173 Lu in the final hafnium sample.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

DOE OSTI2022

Extraction of radium and actinium with dibenzo-21-crown-7 resin and Rose Bengal

The extraction of 224 Ra and 228 Ac with dibenzo-21-crown-7 resin was studied in solutions with Rose Bengal and identical solutions without Rose Bengal (blanks) from pH 3 to 12. Batch studies demonstrated that actinium is extracted at high pH (> 10) from both solutions but with a significantly higher extraction from the Rose Bengal solutions (maximum extraction ~ 60,000) than the blank solutions (maximum extraction ~ 2,000). In the Rose Bengal solutions, there was a weak extraction of actinium at lower pH (4–10) as well. There was no uptake of radium from the blank solutions, and a weak extraction at all pH levels from the Rose Bengal solutions. Kinetics studies were performed for actinium only, as radium had no significant extraction. Two column studies are demonstrated for the separation of radium from actinium. These separations are moderately effective with ~ 78% of the actinium recovered with no detectable radium.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

DOE OSTI2022

Extraction of gold, mercury, and lead with TEVA resin from HCl and HNO 3

The extraction behavior of 212 Pb, 197m Hg, and 194 Au on TEVA resin in HCl and HNO 3 solutions was studied with batch uptake, kinetics, and column studies. The uptake of mercury and gold was extremely high from HCl solutions, with maximum k’ >80,000 for both elements. The uptake of mercury was lower in HNO3 than HCl with a maximum k’ of ~ 8,000 in 0.02 M HNO 3 and decreasing uptake at higher concentrations of HNO3, which agrees well with previous work. The batch uptake of gold in HNO 3 was not measured, as it had been reported previously. The uptake of lead on TEVA resin in HCl was low with a maximum k’ of only ~ 90 in 1 M HCl. The uptake of lead in HNO 3 was negligible. The uptake kinetics of gold and mercury were characterized in HCl and HNO 3 solutions and high uptake was seen after ~ 60 s for both elements. Column separations of 212 Pb, 197m Hg, and 194 Au on TEVA resin from HCl and HNO 3 solutions are reported with high yields of mercury and lead, but with high losses of gold, which is retained on the resin. A rapid, high yield separation of 197m Hg from irradiated gold foils is presented with yields of ~ 100% for both elements and a total separation time of < 2 h.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

DOE OSTI2022

Extraction of 197 mHg with TIBPS in HNO 3 and HCl media

Here, the extraction of no carrier added mercury by tri-isobutyl phosphine sulfide (TIBPS) was characterized in HCl and HNO 3 media. The extraction of 197 mHg as a function of acid concentration was similar in both acids over a large acid concentration (0.001 M to conc.) with high extraction (D ~ 1000) at low concentrations and decreasing extraction for higher concentrations (≥ 4 M). The kinetics of extraction were rapid (~ 5 min.) in both acids. Speciation experiments indicated that the extraction mechanism is 1:2 ( 197 mHg:TIBPS) in HCl and 1:1 in HNO 3 .

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

DOE OSTI2021

Unsaturated Sulfur Crown Ethers Can Extract Mercury(II) and Show Promise for Future Copernicium(II) Studies: A Combined Experimental and Computational Study

The unsaturated hexathia-18-crown-6 (UHT18C6) molecule was investigated for the extraction of Hg(II) in HCl and HNO3 media. This extractant can be directly compared to the recently studied saturated hexathia-18-crown-6 (HT18C6). The default conformation of the S lone pairs in UHT18C6 is endodentate, where the pocket of the charge density, according to the crystal structures, is oriented toward the center of the ring, which should allow better extraction for Hg(II) compared to the exodentate HT18C6. Batch study experiments showed that Hg(II) had better extraction at low acid molarity (ca. 99% in HCl and ca. 95% in HNO 3 ), while almost no extraction was observed above 0.4 M HCl and 4 M HNO 3 (<5%). Speciation studies were conducted with the goal of delineating a plausible extraction mechanism. Density functional theory calculations including relativistic effects were carried out on both Hg(II)-encapsulated HT18C6 and UHT18C6 complexes to shed light on the binding strength and the nature of bonding. Our calculations offer insights into the extraction mechanism. In addition to Hg(II), calculations were performed on the hypothetical divalent Cn(II) ion, and showed that HT18C6 and UHT18C6 could extract Cn(II). Finally, the extraction kinetics were explored to assess whether this crown can extract the short-lived Cn(II) species in a future online experiment.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

DOE OSTI2021

Extraction of gold, mercury and lead on CL resin in HCl

The uptake behavior of 197 mHg, 194 Au and 212 Pb in HCl on CL resin (Triskem) was studied. The extraction of mercury and gold is high (D w > 5,000) at all concentrations of HCl, with a maximum extraction of gold at 4 M HCl (D w ~ 53,000) and maximum extraction of mercury at 0.01 M HCl (D w ~ 44,000). Lead has moderate uptake on CL resin (D w ~ 100) from lower concentrations of HCl (0.001 to 0.05 M) and no uptake on the resin in concentrations ≥ 0.4 M. The uptake kinetics are similar for all three isotopes with high weight distribution ratios (>1,000 for 197 mHg, 194 Au and > 100 for 212 Pb) in ~ 30 s and equilibrium established at ~ 5 min. A column study was performed to demonstrate that 197m Hg, 194 Au and 212 Pb could be retained on CL resin in dilute HCl and 212 Pb eluted in 1 M HCl with no detectable 197m Hg or 194 Au. Elution of 197 mHg and 194 Au was performed with concentrated HNO 3 , but with significant losses to the column, particularly for 194 Au.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

DOE OSTI2021

Separation of zirconium and hafnium from early actinides and rare earth elements with eichrom’s pb resin in HCl

The separation of zirconium and hafnium isotopes from the early actinides and rare earth elements (REE) with Eichrom’s Pb resin has been studied. Batch studies were performed to characterize the behavior of actinium, thorium, zirconium, hafnium, lutetium, and yttrium on Pb resin from HCl solutions (0.001 M to 11 M). The early actinides and REE had no affinity for the resin at any concentration of HCl, but zirconium and hafnium showed a moderate uptake at high concentrations of HCl with a maximum extraction at 11 M HCl. Several column separations were tested, including with only tracer isotopes and with mass. Rapid, simple separations of zirconium from actinium, thorium, protactinium, and the REE with high yields and low elution volumes are presented with applications for tracer isotope production and fission product separations. Furthermore, the resin is less suitable for hafnium separations as hafnium tends to bleed off the resin even at high concentrations of HCl.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

DOE OSTI2020

Transactinide studies with sulfur macrocyclic extractant using mercury

Mercury extraction has been studied in nitric and hydrochloric acids with hexathia-18-crown-6 dissolved in carbon tetrachloride. Batch study experiments have been performed to determine the best conditions for maximum extraction. In both acids, Hg(II) was best extracted at low molarity while almost no extraction was observed above 2 M. Furthermore, speciation studies were carried out in an attempt to describe the extraction mechanism, but the exact composition of the extracted species was not determined. The extraction kinetics were studied to assess the feasibility of this crown ether for extracting Cn and/or Fl in a future online experiment.

197mHg↗