Engineering Papers⌕ Search

Engineering topics

Dera, Przemyslaw

Publications and source records attributed to Dera, Przemyslaw.

10 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2025

Graphene Activated Magnesium Diboride for Moderate Pressure and Temperature Hydrogenation to Magnesium Borohydride

The hydrogenation conditions of magnesium diboride (MgB2) to magnesium borohydride (Mg(BH4)2) can be significantly enhanced through the discovery of improved modifiers. This study demonstrates that the modification of MgB2 by mechanical milling with graphene nanoplatelets significantly reduces the hydrogenation conditions of MgB2 from 900 bar and 400 degrees C for pure MgB2 to 400 bar and 300 degrees C while achieving 77% conversion to Mg(BH4)2. The introduction of the graphene additives coupled with milling leads to a reduction of the temperature and pressure required for bulk hydrogenation by 100 degrees C and 500 bar, respectively, from that of pure MgB2. The identification of graphene additives that drastically improve the hydrogenation conditions of MgB2 represents an important step toward improving hydrogen uptake kinetics to Mg(BH4)2.

complex hydrides↗
DOE OSTI2024

Fast Seismic Anomalies Under Continents Explained by the Delaminated Lower Continental Crust—Implications From High Pressure‐Temperature Elasticity of Jadeite

Seismic tomography has shown that the shear wave velocities (Vs) under continents, especially under cratons, are extremely fast at 100–200 km depth, which is difficult to explain by low temperatures or high Mg#. Alternatively, delaminated eclogitic lower continental crust has been proposed to account for these fast seismic anomalies. However, the thermoelastic properties of jadeite which constitutes up to 60–80 mol% of clinopyroxene in the potentially delaminated lower continental crust are not well constrained. In this study, we measured the single-crystal elasticity of jadeite by Brillouin spectroscopy under simultaneous high pressure and temperature conditions for the first time. We found that the temperature dependence of Vs of jadeite is extremely small if not negligible. The seismic velocities of the potentially delaminated lower continental crusts were subsequently modeled and found to match the widely observed fast seismic anomalies under cratons between 100 and 200 km depth.

Geology↗
DOE OSTI2024

Pressure-induced phase transitions in Ni-bearing ferrosilite (Ni-En31Fs65)

Abstract Orthopyroxene is an abundant mineral in subducting slabs. Studying its phase transitions at high pressure is important to the understanding of mineralogy of subducting slabs in the deep Earth. Synchrotron-based single-crystal X-ray diffraction experiments were conducted on a synthetic Ni-bearing ferrosilite (Ni-En31Fs65) at pressures up to 33.8 GPa. Three phase transitions were observed at 12.1(6), 15.6(6), and 31.3(25) GPa. The first two phase transitions in Ni-En31Fs65 resemble the previously described phase transitions in Ni-free Fe-rich orthopyroxenes, i.e., the initial α-opx (Pbca) transforms to β-opx (P21/c), then the latter transforms to γ-opx (Pbca). This indicates that the incorporation of a few mol% NiSiO3 does not influence the phase transition path of Fe-rich orthopyroxene. After the third phase transition, the structure (P21ca) of Ni-En31Fs65 resembles the previously reported β-popx observed in En90 at high pressure, although the onset pressure of the phase transition in Ni-En31Fs65 is ~7 GPa lower than that in En90. β-popx has a post-pyroxene structure that contains fivefold- and sixfold-coordinated Si cations. Our results indicate that the post-pyroxene structure is β-popx (P21ca) for either Fe-poor or Fe-rich orthopyroxenes, although the phase transition path before the pyroxene → post-pyroxene is compositionally dependent. Additionally, unlike the second and third transitions, whose onset pressures are monotonously decreased by increasing Fe content, the Fe effect on shifting the first transition is much more significant for orthopyroxenes within En <50 mol% than that within En >50 mol%.

Geochemistry & Geophysics↗
DOE OSTI2021

High‐Pressure Phase Stability and Thermoelastic Properties of Iron Carbonitrides and Nitrogen in the Deep Earth

Abstract Iron‐dominant metallic phases are likely the primary hosts for nitrogen in the reduced deep Earth, hence the storage of nitrogen in the lower mantle and the core is governed by the behavior of the Fe‐N‐C system at high temperatures and pressures. In this study, phase transitions and thermoelastic properties of iron carbonitrides were investigated at high pressure‐temperature conditions by diamond anvil cell experiments and first‐principles calculations. Experimental data revealed no phase transition in ε ‐type Fe 4 (N 0.6 C 0.4 ) or Fe 7 (N 0.75 C 0.25 ) 3 up to 60 GPa at room temperature. At high temperature, Fe 7 (N 0.75 C 0.25 ) 3 transforms into the Fe 3 C‐type phase at ∼27 GPa, and then into the Fe 7 C 3 ‐type phase at ∼45 GPa, which is also corroborated by our theoretical calculations. We found that the phase stability of iron carbonitrides mainly depends on the N/C ratio, and the elastic properties of iron carbonitrides are dominantly affected by the Fe/(N+C) ratio. Iron carbonitrides with diverse structures may be the main host for nitrogen in the deep mantle. Some iron carbonitride inclusions in lower mantle diamonds could be the residue of the primordial mantle or originate from subducted nitrogen‐bearing materials, rather than iron‐enriched phases of the outer core. In addition, our experiments confirmed the existence of Fe 7 C 3 ‐type Fe 7 C 3 ‐Fe 7 N 3 solid solutions above 40 GPa. Fe 7 C 3 ‐type Fe 7 (C, N) 3 has comparable density and thermoelastic properties to its isostructural endmembers and may be a promising candidate constituent of the Earth's inner core.

Huang, Shengxuan↗
DOE OSTI2021

Room temperature facile synthesis of olivine-Co 2 SiO 4 nanoparticles utilizing a mechanochemical method

Co 2 SiO 4 is a ceramic pigment and promising battery material of significant technological interest, as well as a model end-member of one of the most important mineral families in the Earth's crust and upper mantle. All previously developed methods for synthesis of Co 2 SiO 4 require high-temperature processing, which promotes grain growth, while the nanocrystalline form is required for some important technological applications. Here, we report a successful method for synthesizing nanocrystalline Co 2 SiO 4 via a simple and inexpensive high-energy ball milling mechanochemical process. Products of the synthesis were characterized by a combination of XRD and TEM, and their crystal structures and elemental compositions are reported.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗