Engineering topics
Publications and source records attributed to Delcamp, Jared H..
Dicyanobenzothiadiazole based dyes have shown exceptional tunability of oxidizing strength and absorption energy. The photophysical thermodynamic and kinetic properties are studied with desirable properties shown for future use in photocatalysis.
Strong-field hexadentate ligands were synthesized and coordinated to cobalt metal centers to result in three new low-spin to low-spin Co(III/II) redox couples. The ligand backbone has been modified with dimethyl amine groups to result in redox potential tuning of the Co(III/II) redox couples from –200 to –430 mV versus Fc +/0 . The redox couples surprisingly undergo a reversible molecular switch rearrangement from five-coordinate Co(II) to six-coordinate Co(III) despite the ligands being hexadentate. The complexes exhibit modestly faster electron self-exchange rate constants of 2.2–4.2 M –1 s –1 compared to the high-spin to low-spin redox couple [Co(bpy) 3 ] 3 + /2 + at 0.27 M –1 s –1 , which is attributed to the change in spin state being somewhat offset by this coordination switching behavior. The complexes were utilized as redox shuttles in dye-sensitized solar cells with the near-IR AP25 + D35 dye system and exhibited improved photocurrents over the [Co(bpy) 3 ] 3 + /2 + redox shuttle (19.8 vs 18.0 mA/cm 2 ). Finally, future directions point toward pairing the low-spin to low-spin Co(II/III) tunable series to dyes with significantly more negative highest occupied molecular orbital potentials that absorb into the near-IR where outer sphere redox shuttles have failed to produce efficient dye regeneration.
Strong photoinduced oxidants are important to organic synthesis and solar energy conversion, to chemical fuels or electric. For these applications, visible light absorption is important to solar energy conversion and long–lived excited states are needed to drive catalysis. With respect to these desirable qualities, a series of five 5,6–dicyano[2,1,3]benzothiadiazole (DCBT) dyes are examined as organic chromophores that can serve as strong photooxidants in catalytic systems. The series utilizes a DCBT core with aryl groups on the periphery with varying electron donation strengths relative to the core. The dyes are studied via both steady–state and transient absorption and emission studies. Additionally, computational analysis, voltammetry, crystallography, and absorption spectroelectrochemistry are also used to better understand the behavior of these dyes. Ultimately, a strong photooxidant is arrived at with an exceptionally long excited state lifetime for an organic chromophore of 16 µs. Finally, the long–lived excited state photosensitizer is well–suited for use in catalysis, and visible light driven photosensitized water oxidation is demonstrated using a water–soluble photosensitizer.
A Cu complex featuring a hexadentate ligand was synthesized and evaluated as a redox shuttle in dye-sensitized solar cell (DSC) devices, which exhibited excellent performance under low-light conditions. Cu-based redox shuttles (RSs) have been shown to perform remarkably well under low-light conditions; however, most of the known Cu-based RSs employ bidentate pyridyl ligands and often require bulky flanking groups adjacent to the nitrogen donors of these ligands to prevent distortion and binding of exogenous Lewis bases such as 4- tert -butylpyridine (TBP) that are added to enhance cell performance. Without the bulky substituents, the bidentate ligands are susceptible to ligand exchange with TBP. In this context, we have developed a Cu-based RS with a preorganized multidentate ligand designed to facilitate efficient electron transfer kinetics and high stability via the chelate effect. The Cu system, [Cu(bpyPY4)] 2+/+ , reported here is supported by the hexadentate polypyridyl ligand bpyPY4 (6,6'-bis(1,1-di(pyridine-2-yl)ethyl)-2,2'-bipyridine) and examined as a RS in DSCs. From X-ray crystallography and variable-temperature 1 H NMR studies, bpyPY4 provides a dynamic coordination environment around the metal center. Cyclic voltammetry and UV–visible and NMR spectroscopy indicate that noncoordinated pyridyl donors block binding of TBP to copper. DSC devices using [Cu(bpyPY4)] 2+/+ as the redox electrolyte gave a power conversion efficiency (PCE) value of 4.9% under 1 sun illumination (100 mW/cm 2 ). Strikingly, the device performance increased to 11.11% when irradiated with 2400 lux (0.5 mW/cm 2 ) via a fluorescent lamp light source and improved further to 15.2% PCE at 13500 lux (2.10 mW/cm 2 ). In conclusion, the Cu redox shuttle is an intriguing candidate for implementation with narrow band gap sensitizers with low oxidation potentials, which are important for high photocurrent DSC devices.
Slowing non-desirable electron transfer reactions at metal oxide-dye interfaces is important for many technologies. Specifically, after an interfacial photoinduced charge separation event at a metal oxide-dye interface, it is critically important to limit the rate of electron transfer reactions back to sensitizers and to limit electron transfer reactions between the electrolyte and the metal oxide. Ruthenium-based dyes at metal oxide interfaces are widely used in many fields; however, these dyes often have poor surface insulation resulting in fast recombination kinetics with transition metal-based redox shuttles in an electrolyte. This work explores two semiconductor surface modification strategies designed to minimize recombination events of electrons in TiO 2 with oxidized redox shuttles using a fluorinated siloxane insulator (PFTS) and a metal oxide insulator (MgO) with a well-known Ru dye, B11. Additionally, the influence of these treatments on the rate and duration of photoinduced interfacial charge separation at the TiO 2 -dye interface was examined. The TiO 2 -dye-redox shuttle systems were studied via dye-sensitized solar cell current-voltage curve, incident photon-to-current conversion efficiency, small-modulated photovoltage transient, time-correlated single photon counting, and transient absorption spectroscopy measurements. MgO was found to decrease the rate of the electron transfer reaction from the metal oxide to the electrolyte, decrease the rate of the electron transfer reaction to the oxidized dye from TiO 2 , increase the electron transfer reaction rate from a reduced redox shuttle to an oxidized dye, and decrease the electron injection rate from the photoexcited dye to TiO2. Interestingly, PFTS was found to desirably improve on these rates relative to MgO or untreated TiO 2 . Here, a model based on electrostatic interactions is presented to explain the exceptional behavior of PFTS with DFT computational analysis of PFTS supporting this model.
Dye-sensitized solar cells (DSCs) are celebrating their 30 th birthday and they are attracting a wealth of research efforts aimed at unleashing their full potential. Righteous font designed by Astigmatic and licensed under the Open Font License.