Declan Mages | Engineering Papers

NASA NTRSDate not supplied

Thermal Protection Design for Uranus Orbiter Flagship Mission: Probes and Aerocapture

Introduction: The Decadal Strategy for Plane-tary Science and Astrobiology prioritized a Uranus Orbiter and Probe (UOP) as the highest-priority new Flagship mission for the 2023 – 2032 decade. Missions to the outer solar system require significant interplanetary cruise durations on the order of 12 – 15 years while carrying propellant to reduce velocity by several km/s to achieve a desired orbit. Parasitic mass and travel time can be traded where faster arrival velocities require more mass expensive capture burns. Recent advancements in Thermal Protection Systems (TPS) for planetary entry enable mass-efficient designs for atmospheric probes and missions that apply aerocapture for orbit insertion.

Uranus TPS Aerocapture Probe↗

NASA NTRSDate not supplied

Uranus Flagship-class Orbiter and Probe Using Aerocapture

Exploration of the Ice Giants, especially Uranus, via orbiter and atmospheric probes, is required to answer pressing science questions that have been raised in the latest National Academies of Sciences Planetary Decadal Survey. Since the Ice Giants are the farthest planets from Earth, traditional fully-propulsive orbit insertion missions have transit times to the planetary bodies bordering 13-15 years and require a large amount of propellant (wet mass percentages of around 60-70%) for the orbit insertion maneuver, leaving less mass for the scientific payload and a planetary probe. Aerocapture uses aerodynamic forces generated by flight within a planetary atmosphere to decelerate and achieve orbit insertion. Aerocapture has been considered for several past missions but it has not been demonstrated. However, recent developments in thermal protection systems (TPS), guidance and control (G&C), and interplanetary navigation capabilities show the potential for using rigid, heritage entry vehicle configurations already flown at other planetary bodies for Ice Giants aerocapture. Aerocapture can robustly deliver spacecraft to Ice Giant orbits, while substantially increasing on-orbit payload mass (more than 40%) that can be used for a robust atmospheric entry probe. Additionally, the aerocapture maneuver would reduce the interplanetary transit time by 2-5 years (15-30%) relative to fully-propulsive orbit insertion. Recent work has shown that a flagship-class mission can be conducted in a shorter time than fully-propulsive missions if using aerocapture. This paper will consider the merits of including aerocapture as the orbit-insertion mechanism for a Uranus mission. Specifically, the implications of aerocapture orbit insertion for in-situ atmospheric probes will be discussed. The Uranus Orbiter and Probe concept mission study [3] is considered as the potential payload. Results from a recent NASA Space Technology Mission Directorate (STMD)-funded activity that is designing an aerocapture mission for a Uranus orbiter will be presented.

Soumyo Dutta↗

NASA NTRSDate not supplied

Performance Analysis of Aerocapture Systems for Uranus Orbiters

A Uranus orbiter and probe mission is the highest priority science mission of the current decade. Aerocapture can be employed to support these missions by enabling shorter interplanetary trajectories and requiring less fuel for orbit insertion. This paper investigates the trajectory design and performance analysis of Uranus aerocapture using an MSL-derived aeroshell design. The trajectory tradespace for Uranus aerocapture is investigated to understand the relationship between interplanetary arrival speed and aeroshell aerodynamics to controllability. A 3 degree-of-freedom simulation framework is developed to assess the performance of bank angle fully numerical predictor-corrector aerocapture guidance. A series of Monte Carlo sensitivity studies are conducted to assess the effects that arrival navigation, arrival speeds, and atmosphere knowledge have on the aerocapture robustness and performance. The results suggest that bank angle modulation is a feasible option for Uranus orbit insertion where aerocapture can reduce transit times by 40% and save 1950 kg in propellant mass.

Rohan G. Deshmukh↗

NASA NTRSDate not supplied

Uranus Flagship-class Orbiter and Probe Using Aerocapture

Exploration of the Ice Giants, especially Uranus, via orbiter and atmospheric probes, is required to answer pressing science questions that have been raised in the latest National Academies of Sciences Planetary Decadal Survey. Since the Ice Giants are the farthest planets from Earth, traditional fully-propulsive orbit insertion missions have transit times to the planetary bodies bordering 13-15 years and require a large amount of propellant (wet mass percentages of around 60-70%) for the orbit insertion maneuver, leaving less mass for the scientific payload and a planetary probe. Aerocapture uses aerodynamic forces generated by flight within a planetary atmosphere to decelerate and achieve orbit insertion. Aerocapture has been considered for several past missions but it has not been demonstrated. However, recent developments in thermal protection systems (TPS), guidance and control (G&C), and interplanetary navigation capabilities show the potential for using rigid, heritage entry vehicle configurations already flown at other planetary bodies for Ice Giants aerocapture. Aerocapture can robustly deliver spacecraft to Ice Giant orbits, while substantially increasing on-orbit payload mass (more than 40%) that can be used for a robust atmospheric entry probe. Additionally, the aerocapture maneuver would reduce the interplanetary transit time by 2-5 years (15-30%) relative to fully-propulsive orbit insertion. Recent work has shown that a flagship-class mission can be conducted in a shorter time than fully-propulsive missions if using aerocapture. This paper will consider the merits of including aerocapture as the orbit-insertion mechanism for a Uranus mission. Specifically, the implications of aerocapture orbit insertion for in-situ atmospheric probes will be discussed. The Uranus Orbiter and Probe concept mission study [3] is considered as the potential payload. Results from a recent NASA Space Technology Mission Directorate (STMD)-funded activity that is designing an aerocapture mission for a Uranus orbiter will be presented.

Soumyo Dutta↗

NASA NTRSDate not supplied

Onboard Navigation Error Analysis for Aerocapture at Uranus

Capturing into an orbit around Uranus using aerocapture allows one to design a mission with faster interplanetary trajectories and less propellant requirements. Such an aerocapture mission would rely on the onboard Guidance, Navigation, and Control (GNC) subsystems to successfully capture into an orbit around Uranus. Uncertainty in the state information and the noise in the sensor measurements induce navigation errors in the guidance and control subsystems, which can affect the overall performance of the aerocapture mission at Uranus. Understanding the effect of these navigation errors on mission performance is essential. To this end, this work considers different sensors with varying quality to understand their impact on the overall mission performance. In addition, this paper studies the impact of the uncertainty in the initial states used to initialize the onboard navigation filter and understands their effect on mission performance. This paper also shows the onboard navigation errors obtained from the Linear Covariance (LinCov) analysis and uses them for verification and validation (V&V) of the results from Program to Optimize and Simulate Trajectories-II (POST2).

Pardha Sai Chadalavada↗

NASA NTRSDate not supplied

Aerocapture Solutions for Uranus Flagship-class Orbiter and Probe

Recent planetary mission assessments, such as the 2022 Planetary Science Decadal Survey released by the National Academies of Science, have focused on the need for a flagship-class mission to the Ice Giant planets, particularly Uranus. The Uranus Orbit and Probe mission proposal was used by the National Academies of Science as the baseline while making its recommendation as the top flagship-class mission for NASA in the 2020-2030\'s. This mission which was based on a launch date of 2031 or 2032, used a fully-propulsive orbit insertion maneuver at Uranus (requiring 60-70% of total mass for propellant), and reached the planet after 13 years of interplanetary cruise before the 2049 equinox, a goal of the science community. A pre-2033 launch date is required to conduct a necessary Jupiter fly-by as the giant planet will be not be in the proper alignment for a later launch date. However, as the budget constraints of the NASA budget have pushed back the start date of a Uranus mission, a launch date of a flagship mission before 2033 seems unreasonable. Aerocapture, an orbit insertion maneuver that uses the atmosphere to decelerate, can reduce the propellant load needed for a captured orbit. Additionally, the aerocapture maneuver can decelerate safely while approaching the planet at higher arrival velocities, thus allowing a mission to use a highly energetic trajectory and reduce the cruise time by several years. An aerocapture-enabled solution has launch opportunities in the mid 2030's, including as late as 2038 to reach Uranus by 2049. This paper will discuss the feasibility of an aerocapture option for a Flagship-class mission to Uranus.

Soumyo Dutta↗

NASA NTRSDate not supplied

Aerocapture Solutions for Uranus Flagship-class Orbiter and Probe

Recent planetary mission assessments, such as the 2022 Planetary Science Decadal Survey released by the National Academies of Science, have focused on the need for a flagship-class mission to the Ice Giant planets, particularly Uranus. The Uranus Orbit and Probe mission proposal was used by the National Academies of Science as the baseline while making its recommendation as the top flagship-class mission for NASA in the 2020-2030\'s. This mission which was based on a launch date of 2031 or 2032, used a fully-propulsive orbit insertion maneuver at Uranus (requiring 60-70% of total mass for propellant), and reached the planet after 13 years of interplanetary cruise before the 2049 equinox, a goal of the science community. A pre-2033 launch date is required to conduct a necessary Jupiter fly-by as the giant planet will be not be in the proper alignment for a later launch date. However, as the budget constraints of the NASA budget have pushed back the start date of a Uranus mission, a launch date of a flagship mission before 2033 seems unreasonable. Aerocapture, an orbit insertion maneuver that uses the atmosphere to decelerate, can reduce the propellant load needed for a captured orbit. Additionally, the aerocapture maneuver can decelerate safely while approaching the planet at higher arrival velocities, thus allowing a mission to use a highly energetic trajectory and reduce the cruise time by several years. An aerocapture-enabled solution has launch opportunities in the mid 2030's, including as late as 2038 to reach Uranus by 2049. This paper will discuss the feasibility of an aerocapture option for a Flagship-class mission to Uranus.

Soumyo Dutta↗

NASA NTRSDate not supplied

Onboard Navigation Error Analysis for Aerocapture at Uranus

Capturing into an orbit around Uranus using aerocapture allows one to design a mission with faster interplanetary trajectories and less propellant requirements. Such an aerocapture mission would rely on the onboard Guidance, Navigation, and Control (GNC) subsystems to successfully capture into an orbit around Uranus. Uncertainty in the state information and the noise in the sensor measurements induce navigation errors in the guidance and control subsystems, which can affect the overall performance of the aerocapture mission at Uranus. Understanding the effect of these navigation errors on mission performance is essential. To this end, this work considers different sensors with varying quality to understand their impact on the overall mission performance. In addition, this paper studies the impact of the uncertainty in the initial states used to initialize the onboard navigation filter and understands their effect on mission performance. This paper also shows the onboard navigation errors obtained from the Linear Covariance (LinCov) analysis and uses them for verification and validation (V\&V) of the results from Program to Optimize and Simulate Trajectories-II (POST2).

Aerocapture↗