Engineering Papers⌕ Search

Engineering topics

DeCamp, M. F.

Publications and source records attributed to DeCamp, M. F..

Dynamic strain evolution in an optically excited Pt thin film

The structural evolution of a Pt thin film following photo-thermal excitation by 1 ps optical laser pulses was studied with a time resolution of 100 ps over a total time period of 1 ms. Laser pulse fluences below 50 mJ/cm 2 were insufficient to relax the residual stress state of the as-prepared film even after 10 000 pulses. In this fluence regime, a rapid initial lattice expansion and a decrease in the lattice coherence length due to ultrafast photo-thermal heating were observed. The lattice expansion reached a maximum, and the coherence length reached a minimum, 100–200 ps after excitation before monotonically decaying back to their initial values in about 1 µs. Laser pulse fluences greater than 50 mJ/cm 2 produced irreversible stress relaxation within the first 10 optical pulses. In this regime, the lattice expansion was qualitatively similar to that in the low fluence regime, except that the initial structural state was not recovered. The evolution in the coherence length, however, was more complex. Following an initial decrease similar to that observed at low fluence, the coherence length then increased to a broad maximum greater than the initial value, before recovery.

36 MATERIALS SCIENCE↗

Lattice parameter evolution in Pt nanoparticles during photo-thermally induced sintering and grain growth

An in-situ optical pump/x-ray probe technique has been used to study the size dependent lattice parameter of Pt nanoparticles subjected to picosecond duration optical laser pulses. The as-prepared Pt nanoparticles exhibited a contracted lattice parameter consistent with the response of an isolated elastic sphere to a compressive surface stress. During photo-thermally induced sintering and grain growth, however, the Pt lattice parameter did not evolve with the inverse particle size dependence predicted by simple surface stress models. Lastly, the observed behavior could be attributed to the combined effects of a compressive surface/interface stress and a tensile stress arising from intergranular material.

77 NANOSCIENCE AND NANOTECHNOLOGY↗

X-ray diffraction study of laser-driven solid-state diffusional mixing and new phase formation in Ni-Pt multilayers [X-ray diffraction study of laser-driven solid-state diffusional mixing and new phase formation]

An in situ optical pump and x-ray probe technique has been utilized to study photoinitiated solid-state diffusion in a Ni-Pt multilayer system. Hard x-ray diffraction has been used to follow the systematic growth of the NiPt alloy as a function of laser intensity and total energy deposited. It is observed that new phase growth can be driven in as little as one laser pulse, and that repeated photoexcitation can completely convert the entire multilayer structure into a single metallic alloy. In conclusion, the data suggest that lattice strain relaxation takes place prior to atomic diffusion and the formation of a NiPt alloy.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Pump–probe spectrometer for measuring x-ray induced strain

A hard x-ray pump–probe spectrometer using a multi-crystal Bragg reflector is demonstrated at a third generation synchrotron source. This device derives both broadband pump and monochromatic probe pulses directly from a single intense, broadband x-ray pulse centered at 8.767 keV. In conclusion, we present a proof-of-concept experiment which directly measures x-ray induced crystalline lattice strain.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Transient crystalline superlattice generated by a photoacoustic transducer

Designing an efficient and simple method for modulating the intensity of x-ray radiation on a picosecond time-scale has the potential to produce ultrafast pulses of hard x-rays. In this work, we generate a tunable transient superlattice, in an otherwise perfect crystal, by photoexciting a metal film on a crystalline substrate. The resulting transient strain has amplitudes approaching 1%, wavevectors greater than 0.002 Å−1, and lifetimes approaching 1 ns. This method has the potential to generate isolated picosecond x-ray bursts with scattering efficiencies in excess of 10%.

Loether, A.↗