Engineering Papers⌕ Search

Engineering topics

Danon, Yaron

Publications and source records attributed to Danon, Yaron.

At least 37 records · Page 2

Experimental Validation of Thermal Scattering Evaluations

In order to test the performance of new neutron thermal scattering law (TSL) evaluations it is desirable to have experimental data that is highly sensitive to the TSL and provides high fidelity information on the energy dependent performance of TSL evaluations. Three relevant experiments are discussed including: accurate thermal total cross section measurements, thermal neutron die-away experiments, and neutron leakage experiments. The experimental setups and results are reviewed, and examples provided for some moderators including polyethylene, Plexiglas, and YHx. For the experiments preformed thus far, there is generally good agreement between the measured total cross section and simulations using current TSL evaluations, however in certain energy ranges differences were observed. Similarly, neutron die-away and leakage measurements for samples at room temperature are in good agreement with data computed from TSLs, however leakage measurements for polyethylene at 29K show discrepancies with TSL evaluations.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

On Integral Benchmarks for Resolving TSL Conflicts for ENDF/B-VIII.1 Release [Slides]

This presentation touches on polystyrene ORNL evaluation in TSL review process for ENDF/B-VIII.1. the presentation found excellent agreement with INS and transmission measurements. Additionally, PS and PE evaluations with different phonon spectra, similar total xs., calculate keff similarly. This presentation found for critical benchmarks. While extremely useful for validation of nuclear data at all energies, critical benchmarks are not the best tool to provide a definitive answer on conflicting TSLs. In conclusion this presentation found INS and transmission measurements need to be the basis of validation of TSLs.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

ORNL’s Continuing Efforts in Evaluating and Validating TSLs [Slides]

This presentation finds that INS measurements are not as variable based on sample composition, because phonon spectra is a properly of the bulk material. Additionally, INS and transmission measurements are and should be the most significant part of TSL validation, as they are the fundamental quantities used by Monte Carlo neutronics codes. This presentation reasons that relaying solely on theoretical atomistic calculations for TSL evaluation is not enough, they are highly dependent on inter-atomic potentials (which are not the most accurate depending on the quantity trying to be reproduced) and evaluators knowledge and understanding of the material being studied. Finally on Critical benchmarks, while extremely useful for validation of nuclear data at all energies, critical benchmarks are not the best tool to provide a definitive answer on conflicting TSLs. The presentation concludes that INS and transmission measurements need to be the basis of validation of TSLs.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Applying Methodology for Evaluating and Validating TSLs to Materials of Interest to NCSP [Slides]

This presentation covers the topic of applying methodology for evaluation validation of TSLs to material of interest to the Nuclear Criticality Safety Program (NCSP). The talk covers recent efforts in validating thermal neutron scattering cross sections. The presentation also proposes a methodology for not only validating thermal scattering files that utilizes all available experimental data, but also for evaluating new libraries as demonstrated on Polystyrene and Lucite

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Fast Neutron Evaluations for Advanced Lead Systems [Slides]

This presentation touches on fast neutron evaluations for advanced lead systems. This lecture covers project goals to evaluate lead (Pb) isotopes with a focus on improving predictive capabilities of fast systems. Additionally, the project sets out to benchmark available critical and shielding experiments with sensitivity to Pb and utilize RPI Quasi-Differential Scattering experiment for scattering reactions. This project will perform Resolved Resonance Region (RRR) and fast region evaluations for natural Pb isotopes with differential data on EXchange FORmat for experimental numerical nuclear reaction data (EXFOR) and ultimately will submit evaluations to the ENDF/B-VIII.1 library.

07 ISOTOPE AND RADIATION SOURCES↗

Status of ORNL TSL evaluations [Slides]

This lecture provides details on the status of ORNL TSL evaluations. Main sections include modeling of concrete, updates of polyethylene evaluation, and initial transmission measurements at Oak Ridge National Labatory (ORNL). The presentation Conclusions show that literature review and initial modeling of concrete components have been performed. INS and transmission measurements of concrete and hydrated cement have been also planned. Additionally, A new TSL library for Polyethylene was created and submitted to NNDC and development for a new transmission capability at ORNL is underway.

36 MATERIALS SCIENCE↗

NCSP Related Nuclear Data Research at RPI [Slides]

This lecture is on NCSP related nuclear data research at the Rensselaer Polytechnic Institute (RPI). This presentation includes an overview of fiscal year 2022 activity. Additionally, it has a talk on the RPI Nuclear Data (ND) Group Research, an update on Linear Accelerators (LINAC) refurbishment, and the Enhanced Thermal Target & Cold Moderator (ETTC) Target System.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Overview of Nuclear Data Measurement and Analysis at RPI [Slides]

This presentation discusses the experimental, simulation, and nuclear data methods that were validated for the RPI γ-Multiplicity Detector. When the neutron capture γ-cascade data is well-known, the γ-emission spectra can be accurately calculated using the modified simulation tools. The RPI γ-Multiplicity Detector system is now ready for analysis and recommendations for isotopes with deficiencies in γ-ray data. The presentation also discusses future work which includes developing a method for analyzing and adjusting nuclear data for 59 Co, 55 Mn and other measured isotopes including 181 Ta. Additionally, future work includes comparing experimental γ-emission spectra with MCNP-6.2/DICEBOX simulations for 238 U and 235 U. In summation, new capture and transmission measurements for 54 Fe will help improve resonance parameter evaluation. Neutron capture gamma cascade spectra and yields were measured in the resolved resonance region and compared to evaluations. In addition, the pulsed neutron die-away method was developed as a tool to provide data for validation of TSLs.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Proposed Methodology for Evaluating and Validating TSLs [Slides]

This presentation begins by providing an overview of the research and discusses recent efforts in validating thermal neutron scattering cross sections, including differential cross section measurements at ORNL for evaluation and validation, total cross section measurements at RPI, pulsed-neutron die-away experiments at LLNL, and integral criticality experiments by LLNL. The presentation also proposes a methodology not only for validating thermal scattering files that utilizes all available experimental data, but also for evaluating new libraries as demonstrated on polystyrene. In conclusion, polystyrene evaluation was conducted using multiple experiments, including differential and integral. The proposed methodology has been shown to improve neutron transport and files have been submitted to NNDC for inclusion in ENDF/B-VIII.1 release. MCT-012 & PCM-002 has been relatively insensitive to changes in $\mathcal{S}(α,β)$. The research found that differences in differential results don’t always propagate to differences in integral results, hence why evaluation of differential data important. Future work on the project is also discussed.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Status of ORNL TSL evaluations [Slides]

This presentation is on the status of Oak Ridge National Laboratory (ORNL) Thermal Scattering Evaluation (TSL) evaluations. A focus of this presentation centers on the preliminary work on Teflon and Polyethylene evaluation validation.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Total thermal neutron cross section measurements of yttrium hydride from 0.0005 - 3 eV

Yttrium hydride serves as a neutron moderator material that enables compact, high temperature nuclear reactors. However, in order to accurately design and simulate a nuclear system relying upon yttrium hydride, the fundamental nuclear data of yttrium hydride must be well understood. Thermal neutron scattering law (TSL) evaluations represent an important aspect of nuclear data as thermal scattering can drastically alter the neutron multiplication factor of a system. Therefore, to support evaluation and validation of thermal neutron scattering for yttrium hydride, researchers at Rensselaer Polytechnic Institute (RPI) performed total thermal neutron cross section measurements for YH 1.68 and YH 1.85 over the energy range of 0.0005 - 3 eV. Further, these measurements represent the first total cross section measurements for yttrium hydride that encompass the entire thermal region. Comparisons were made against the ENDF-B/VIII.0, Zerkle & Holmes and Oak Ridge National Laboratory TSL evaluations, where generally good agreement was found.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

Phenomenological R-Matrix parameterization of direct, doorway, and compound nuclear reactions [Slides]

The presented R-matrix formalism could improve evaluations of resolved resonance nuclear cross section data by parameterizing direct reaction processes via an orthonormal channel mixing matrix and doorway state processes. Together, they can parameterize direct-semidirect capture. A formal similarity among the R-, K-, T- matrix formalisms was leveraged to parameterize direct and doorway processes. The advantage of this R-matrix parameterization is that it is easily extensible due to its application of projection operators directly upon the (H-E) on p. 6.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Experiments for validation of TSL evaluations [Slides]

There is a recent revival of thermal scattering evaluation capabilities and there are many new evaluations available in ENDF-8.0 and elsewhere. This creates a need for experimental validation other than criticality benchmarks. Thermal scattering libraries (TSL) provide information to describe the double differential thermal scattering at different moderator temperatures. For moderators, the biggest effect of TSL is the thermal scattering cross section.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Phenomenological R -Matrix parameterization of direct, doorway, and compound nuclear reactions [Abstract]

Although formal expressions for scattering matrix accounting for direct, doorway, and compound nuclear (CN) resonant reactions have been derived several decades ago in both the transition ( T -)matrix formalism and the reactance ( K -)matrix formalism, the absence of corresponding expressions in phenomenological R -matrix formalism has limited the application of the latter to CN resonant reactions only. We remove this limitation by parameterizing direct, doorway, and CN resonant reactions in a phenomenological R -matrix scattering matrix, and provide a parameterization for a corresponding Reich-Moore approximation of eliminated capture channels. Direct reactions induce (previously neglected) mixing among the incoming or outgoing R -matrix channel wave functions, parameterized by real and orthonormal channel-rotation matrix, M , whereby the original scattering matrix U is transformed into M T UM . Any real and orthonormal matrix, M , can be equivalently expressed as e η , where η is a real and skew-symmetric 2 rotation-generating matrix that subsequently yields a more intuitive parameterization of eliminated direct capture reactions in Reich-Moore approximation. A phenomenological R -matrix parameterization of doorway reactions is inferred by equating the expression for reactance ( K -)matrix, given in terms of Brune’s alternative R -matrix parameterization, to a corresponding expression derived using Feshbach’s projection operator formalism. Assuming that all doorway states, just like CN states, are confined within spheres defined by R -matrix channel radii, a new R -matrix-like term induced by doorway states is gleaned, wherein each doorway state is parameterized by its energy, width, and the strength of its coupling to each CN state. Since a Reich-Moore approximation for retained-channel scattering matrix ought to approximate the effect of eliminated capture channels taking place via direct, doorway, or CN reactions, each of the three kinds of reactions contributing to the capture entails a corresponding Reich-Moore parameterization in a first-order approximation: direct contribution is parameterized by introducing finite diagonal elements of a retained-channel rotation-generating matrix, doorway contribution is parameterized by doorway capture widths, while CN contribution is parameterized by conventional Reich-Moore capture widths. We will present evidence of direct and doorway reactions observed in recent measurements of resolved resonance cross sections at the Gaerttner LINAC Center at Rensselaer Polytechnic Institute, and will outline a path for implementing this new R -matrix parameterization into the SAMMY nuclear data evaluation code.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Thermal cross section measurements at the RPI LINAC [Abstract]

Recently, a cold moderator was designed and developed for use at the RPI LINAC. This cold moderator proved to easily and safely couple to an existing neutron producing target, while enhancing neutron flux below 0.02 eV by cooling polyethylene down to 29 K. This cold moderator capability allowed for significantly improved counting statistics below 0.02 eV not previously possible due to a poor signal to background ratio. Additionally, testing was performed to characterize the energy resolution of the new cold moderator system and found the system easily capable of resolving resonances in Ta-181 at 4 and 10 eV, while also clearly resolving the Bragg edges found in Be metal below 0.01 eV. Following the design and development of a cold polyethylene moderator, a series of thermal total cross section measurements were performed for polyethylene, polystyrene, Plexiglas and yttrium hydride in the thermal region. These measurements serve to help validate thermal scattering law (TSL) evaluations in the 0.0006 – 20 eV energy range. For polyethylene and polystyrene, two sets of experiments were performed – one with the Enhanced Thermal Target (ETT) and another with the ETT plus the new cold moderator capability (ETTC). The yttrium hydride and Plexiglas measurements were only performed with the ETTC. The measurements for polyethylene help to validate the data processing methodology when using the ETTC, while extending the measured range of polyethylene down to 0.0007 eV. Two different Plexiglas, Plexiglas G and Plexiglas G-UVT, and two different concentrations of yttrium hydride, H/Y = 1.85 and 1.68, were measured. Overall, all materials had generally good agreement with their ENDF/B-VIII.0 TSL evaluations, though some discrepancies were noticed. In the case of the yttrium hydride, the high energy oscillations in the hydrogen cross section and the low energy Bragg edges in the yttrium cross section were clearly seen. These measurements represent the first total cross section measurements that encompass the entire thermal region from 0.0006 – 3 eV for polystyrene and yttrium hydride.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

The importance of phonon spectrum measurements for accurate prediction of thermal scattering laws [Slides]

Although approximate phonon spectra (e.g. Debye model) are sufficient to reproduce integral quantities (e.g. total INS cross section) in reasonable agreement with the measured data, more accurate phonon spectra are needed to achieve agreement with the differential data. SANS component is essential for reproducing the total scattering cross section; this is the case for nanodiamonds and other materials where SANS components are present (such as porous materials like nuclear graphite). A format proposal for SANS data in ENDF or GNDS is needed. Therefore, differential (e.g. phonon spectrum) and integral (e.g. total cross section) measurements are necessary in the process of creating an ENDF evaluation. We have successfully developed a method by which ENDF evaluations can be directly compared to the relevant experimentally measured quantities. INS experiments at SNS, ILL, ISIS, and, in the future, ESS, as well as total cross section measurements at the VESUVIO instrument at ISIS, are accessible through user programs.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗