Engineering Papers⌕ Search

Engineering topics

Dalins, I.

Publications and source records attributed to Dalins, I..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1992

Angularly resolved X-ray photoelectron spectroscopy investigation of PTFE after prolonged space exposure

Monochromatized angularly resolved X-ray photoelectron spectroscopy (ARXPS) was used to study PTFE (Teflon) that had been exposed to an earth orbital environment for approximately six years. The primary interest of the research is on a very reactive component of this environment (atomic oxygen) which, because of the typical orbital velocities of a spacecraft, impinge on exposed surfaces with 5 eV energy. This presentation deals with the method of analysis, the findings as they pertain to a rather complex carbon, oxygen, and fluorine XPS peak analysis, and the character of the valence bands. An improved bias referencing method, based on ARXPS, is also demonstrated for evaluating specimen charging effects. It was found that the polymer molecule tends to resist the atomic oxygen attack by reorienting itself, so that the most electronegative CF3 groups are facing the incoming hyperthermal oxygen atoms. The implications of these findings to ground-based laboratory studies are discussed.

Dalins, I.↗
NASA NTRS1991

Surface disordering of Pb(110)

A molecular dynamics simulation of Pb(110), using embedded atom method energy functional and two-body potential derived for the purpose, shows that near 400 K the three surface layers begin to disorder well before the bulk (interior) layers. Transfer of atoms from the first subsurface layer to the surface layer occurs. Disordering propagates beyond the top three layers above 550 K, accompanied by formation of an adlayer and vacancies in the top three layers. Behavior of the two-dimensional layer structure factors indicates that disordering is anisotropic. Simulation results are consistent with experimental observations of surface roughening near 400 K and more extensive surface ordering above 525 K. Results are consistent with simulations for Ni and Al.

Tibbits, P.↗
NASA NTRS1991

Molecular Dynamics study of Pb overlayer on Cu(100)

Isothermal-isobaric Molecular Dynamics (MD) simulation of a submonolayer Pb film in c(2x2) ordered structure adsorbed on a Cu(100) substrate showed retention of order to high T. The Embedded Atom Method (EAM) calculated the energy of atoms of overlayer and substrate. The time-averaged squared modulus of the two dimensional structure factor for the Pb overlayer measured the order of the overlayer. The results are for increasing T only, and require verification by simulated cooling.

Karimi, M.↗
NASA NTRS1990

Structural and electronic changes in the growth of mercury overlayers on Cu(001) - A helium beam scattering, LEED and ARPES study

We used ABS, LEED and angle-resolved photo-electron spectroscopy (ARPES) to study bilayer films of Hg on Cu(001). In the surface temperature range of 180 to 330 K, the first Hg layer forms two ordered phases, a c(2x2) (with coverage-0.5 of Cu(001)) and a high density (partially commensurate) c(4x4) (coverage-0.62). ARPES data show that there is little or no dispersion of the 5d band of Hg. ABS data show that this layer is not flat, with in-registry Hg atoms lying about 0.15 below the not-in-registry Hg atoms. From ABS we find that the second layer forms a completely registered c(4x4) phase. From ARPES we obtain that the second layer has an electronic structure, particularly the 5d levels, characteristic of bulk mercury. Preliminary results of calculations of the structure of the bilayer are given.

Vidali, G.↗
NASA NTRS1990

Order/disorder and phase diagram of H on Pd(100)

A phase boundary for H-Pd(100) was calculated using the Metropolis (1953) algorithm and the embedded atom method (EAM) described by Daw and Foiles (1987). The calculated phase boundary agreed with an experimentally determined phase boundary in its curvature and the coverage at which maximum Tc appeared, but was about 125 K lower than the experimental phase boundary.

Tibbits, P.↗
NASA NTRS1990

Application of the embedded atom method to Pb and Be

We have derived the embedding energy functional and two-body potential of the embedded atom method using decreasing exponentials for both the electron density and the two body potential. The embedding function was obtained from the equation of state given by Rose et al. (1984). Because of the form of the embedding function, the equilibrium lattice constant, cohesive energy, and bulk modulus are automatically satisfied. The two parameters phi(e) and gamma of the two-body potential were determined by fitting to shear modulus and the single vacancy formation energy. Contributions of up to the third nearest neighbors were included in the evaluation of the charge density rho and the two-body potential phi. The stability and anisotropy of each structure were estimated and compared with the available experimental data.

Karimi, M.↗
NASA NTRS1990

Interaction of H2 with simple metal surfaces - A model based on the anisotropic effective medium theory

Calculations are presented for the interaction of H2 with surfaces of Cu, Ag, Au and Al. The repulsive part of the potential is evaluated using the results of anisotropic effective medium theory (AEMT) while the attractive part is calculated from anisotropic damped dipole-dipole and damped dipole-quadrupole interactions. The model does not have any fitting parameters and its predictions are in excellent agreement with the available experimental data. The anisotropy of H2 is included in the model but our results show that this effect is very small.

Karimi, M.↗
NASA NTRS1985

Protective coatings for atomic oxygen susceptible spacecraft materials - STS-41G results

Sixteen materials consisting of metallizations, silicones, and FEP Teflon were applied as protective coatings to selected spacecraft material surfaces and exposed on STS-41G to the LEO atomic oxygen environment. Evaluations of their protective effectiveness were made through assessing their mass loss/gain characteristics, maintenance of base material optical properties, and imperviousness to atomic oxygen attack. Generally, all coatings provided some degree of protection for the underlying material. In some cases the overcoat appeared to be too thin thereby providing inadequate protection.

Whitaker, A. F.↗
NASA NTRS1974

Investigations of acoustic-seismic effects at long range - Early-arriving seismic waves from Apollo 16

A reasonably comprehensive technical effort is described dealing with the investigations of acoustically generated seismic waves of Apollo 16 and Apollo 17 origin along the eastern seabord of the United States. This expanded effort is a continuation of earlier, rather successful detections of rocket-generated seismic disturbances on Skidaway Island, Georgia. The more recent effort has yielded few positive results other than a recording of an early-arriving seismic wave from Apollo 16 that was detected in Jacksonville. Evaluation of the negative results obtained in the Fort Monmouth area, with earlier studies of infrasound, local weather conditions, and geology, could be advantageous in the process of trying to gain a better insight into the acoustic-seismic resonance mechanism requiring phase-velocity matching at the atmosphere-ground interface.

Dalins, I.↗
NASA NTRS1974

Sticking probabilities for the adsorption of hydrogen on clean Ni/111/, Ni/100/, Ni sheet and evaporated Ni films

Determination of the sticking probability for hydrogen adsorption on clean Ni(111), Ni(100), polycrystalline nickel sheet, and polycrystalline evaporated nickel films, using a modification of the reflection detector technique of Horgan and King (1970) for metal films. The initial sticking probability for hydrogen adsorption on a nickel film at 300 K by the proposed method is found to be 0.25 in comparison to 0.35 for hydrogen adsorption on a nickel film using the reflection detector technique. Also, the sticking probabilities on smooth single-crystal (111) and (100) planes and polycrystalline sheets are found to be lower than those on the rougher polycrystalline nickel films.

Horgan, A. M.↗
NASA NTRS1971

Air-coupled seismic waves at long range from Apollo launchings.

Microphones and seismographs were co-located in arrays on Skidaway Island, Georgia, for the launchings of Apollo 13 and 14, 374 km to the south. Simultaneous acoustic and seismic waves were recorded for both events at times appropriate to the arrival of the acoustic waves from the source. The acoustic signal is relatively broadband compared to the nearly monochromatic seismic signal; the seismic signal is much more continuous than the more pulse-like acoustic signal; ground loading from the pressure variations of the acoustic waves is shown to be too small to account for the seismic waves; and the measured phase velocities of both acoustic and seismic waves across the local instrument arrays differ by less than 6 per cent and possibly 3 per cent if experimental error is included. It is concluded that the seismic waves are generated by resonant coupling to the acoustic waves along some 10 km of path on Skidaway Island.

Donn, W. L.↗
NASA NTRS1969

Seismographic recording of large rocket engine operation

Recording equipment for rocket engine vibration is adaptable to determining the structural strength of building materials. This seismographic system is portable and is capable of measuring displacements in the direction of three mutually perpendicular axes.

Dalins, I.↗