Engineering Papers⌕ Search

Engineering topics

Czaplewski, David A

Publications and source records attributed to Czaplewski, David A.

Nanoeletromechanical switch and logic circuits formed therefrom

A nanoelectromechanical (NEM) switch is formed on a substrate with a source electrode containing a suspended electrically-conductive beam which is anchored to the substrate at each end. This beam, which can be formed of ruthenium, bows laterally in response to a voltage applied between a pair of gate electrodes and the source electrode to form an electrical connection between the source electrode and a drain electrode located near a midpoint of the beam. Another pair of gate electrodes and another drain electrode can be located on an opposite side of the beam to allow for switching in an opposite direction. The NEM switch can be used to form digital logic circuits including NAND gates, NOR gates, programmable logic gates, and SRAM and DRAM memory cells which can be used in place of conventional CMOS circuits, or in combination therewith.

47 OTHER INSTRUMENTATION↗

Nanomechanical switch for integration with CMOS logic.

We designed, fabricated and measured the performance of nanoelectromechanical (NEMS) switches. Initial data are reported with one of the switch designs having a measured switching time of 400 ns and an operating voltage of 5 V. The switches operated laterally with unmeasurable leakage current in the 'off' state. Surface micromachining techniques were used to fabricate the switches. All processing was CMOS compatible. A single metal layer, defined by a single mask step, was used as the mechanical switch layer. The details of the modeling, fabrication and testing of the NEMS switches are reported.

42 ENGINEERING↗

Improved etch resistance of ZEP 520A in reactive ion etching through heat and ultraviolet light treatment.

The authors have developed a treatment process to improve the etch resistance of an electron beam lithography resist (ZEP 520A) to allow direct pattern transfer from the resist into a hard mask using plasma etching without a metal lift-off process. When heated to 90 C and exposed for 17 min to a dose of approximately 8 mW/cm{sup 2} at 248 nm, changes occur in the resist that are observable using infrared spectroscopy. These changes increase the etch resistance of ZEP 520A to a CF{sub 4}/O{sub 2} plasma. This article will document the observed changes in the improved etch resistance of the ZEP 520A electron beam resist.

42 ENGINEERING↗