Engineering Papers⌕ Search

Engineering topics

Cynn, H

Publications and source records attributed to Cynn, H.

Melting curve and phase diagram of vanadium under high-pressure and high-temperature conditions

We discuss melting curve and phase diagram of vanadium under high-pressure and high-temperature conditions We report a combined experimental and theoretical study of the melting curve and the structural behavior of vanadium under extreme pressure and temperature. We performed powder x-ray-diffraction experiments up to 120 GPa and 4000 K, determining the phase boundary of the body-centered cubic-to-rhombohedral transition and melting temperatures at different pressures. Melting temperatures have also been established from the observation of temperature plateaus during laser heating, and the results from the density-functional theory calculations. Results obtained from our experiments and calculations are fully consistent and lead to an accurate determination of the melting curve of vanadium. These results are discussed in comparison with previous studies. The melting temperatures determined in this study are higher than those previously obtained using the speckle method, but also considerably lower than those obtained from shockwave experiments and linear muffin-tin orbital calculations. Finally, a high-pressure, high-temperature equation of state up to 120 GPa and 2800 K has also been determined.

36 MATERIALS SCIENCE↗

Plasma etching of cavities into diamond anvils for experiments at high pressures and high temperatures

We describe a method for precisely etching small cavities into the culets of diamond anvils for the purpose of providing thermal insulation for samples in experiments at high pressures and high temperatures. The cavities were fabricated using highly directional oxygen plasma to reactively etch into the diamond surface. The lateral extent of the etch was precisely controlled to micron accuracy by etching the diamond through a lithographically fabricated tungsten mask. The performance of the etched cavities in high-temperature experiments in which the samples were either laser heated or electrically heated is discussed.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Experimental and theoretical study of Ti-6Al-4V to 220 GPa

We report results from an experimental and theoretical study of the ternary alloy Ti-6Al-4V to 221 GPa. We observe a phase transition to the hexagonal {omega} phase at approximately 30 GPa, and then a further transition to the cubic {beta} phase starting at 94-99 GPa. We do not observe the orthorhombic {gamma} and {delta} phases reported previously in pure Ti. Computational studies show that this sequence is possible only if there is significant local atomic ordering during the compression process, yet insufficient atomic diffusion to reach the phase-separated thermodynamic equilibrium state.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

An Experimental and Theoretical Study of Ti-6Al-4V to Multi-mbar Pressures

We report results from an experimental and theoretical study of the ternary alloy Ti-6Al-4V to 221 GPa. We observe a phase transition to the hexagonal {omega}-phase at approximately 30 GPa, and then a further transition to the cubic {beta}-phase starting at 94-99 GPa. We do not observe the orthorhombic {gamma} and {delta} phases reported previously in pure Ti. Computational studies show that this sequence is possible only if there is significant local atomic ordering during the compression process, yet insufficient atomic diffusion to reach the phase separated thermodynamic equilibrium state.

36 MATERIALS SCIENCE↗

The interplay between magnetism, structure, and strong electron-phonon coupling in binary FeAs under pressure

Unlike the ferropnictide superconductors, which crystallize in a tetragonal crystal structure, binary FeAs forms in an orthorhombic crystal structure, where the local atomic environment resembles a highly distorted variant of the FeAs{sub 4} tetrahedral building block of the ferropnictide superconductors. However, like the parent compounds of the ferropnictide superconductors, FeAs undergoes magnetic ordering at low temperatures, with no evidence favoring a superconducting ground state at ambient pressure. We employ pressure-dependent electrical transport and x-ray diffraction measurements using diamond anvil cells to characterize the magnetic state and the structure as a function of pressure. While the structure persists up to 25 GPa, compressing continuously with pressure, magnetotransport measurements suggests that the magnetic state is destroyed near 11 GPa. The magnetic transition temperature is found to be remarkably robust under pressure, and transport measurements suggest that a dynamical structural instability coupled to the Fermi surface via a strong electron-phonon interaction may play an important role in enabling magnetism in FeAs.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Probing the isothermal (delta)->(alpha)' martensitic transformation in Pu-Ga with in situ x-ray diffraction

The time-temperature-transformation (TTT) curve for the {delta} {yields} {alpha}{prime} isothermal martensitic transformation in a Pu-1.9 at. % Ga alloy is peculiar because it is reported to have a double-C curve. Recent work suggests that an ambient temperature conditioning treatment enables the lower-C curve. However, the mechanisms responsible for the double-C are still not fully understood. When the {delta} {yields} {alpha}{prime} transformation is induced by pressure, an intermediate {gamma}{prime} phase is observed in some alloys. It has been suggested that transformation at upper-C temperatures may proceed via this intermediate phase, while lower-C transformation progresses directly from {delta} to {alpha}{prime}. To investigate the possibility of thermally induced transformation via the intermediate {gamma}{prime} phase, in situ x-ray diffraction at the Advanced Photon Source was performed. Using transmission x-ray diffraction, the {delta} {yields} {alpha}{prime} transformation was observed in samples as thin at 30 {micro}m as a function of time and temperature. The intermediate {gamma}{prime} phase was not observed at -120 C (upper-C curve) or -155 C (lower-C curve). Results indicate that the bulk of the {alpha}{prime} phase forms relatively rapidly at -120 C and -155 C.

36 MATERIALS SCIENCE↗

Spin state of ferric iron in MgSiO{sub 3} perovskite and its effect on elastic properties.

Recent studies have indicated that a significant amount of iron in MgSiO{sub 3} perovskite (Pv) is Fe{sup 3+} (Fe{sup 3+}/{Sigma}Fe = 10-60%) due to crystal chemistry effects at high pressure (P) and that Fe{sup 3+} is more likely than Fe{sup 2+} to undergo a high-spin (HS) to low-spin (LS) transition in Pv in the mantle. We have measured synchrotron Moessbauer spectroscopy (SMS), X-ray emission spectroscopy (XES), and X-ray diffraction (XRD) of Pv with all iron in Fe{sup 3+} in the laser-heated diamond-anvil cell to over 100 GPa. Fe{sup 3+} increases the anisotropy of the Pv unit cell, whereas Fe{sup 2+} decreases it. In Pv synthesized above 50 GPa, Fe{sup 3+} enters into both the dodecahedral (A) and octahedral (B) sites approximately equally, suggesting charge coupled substitution. Combining SMS and XES, we found that the LS population in the B site gradually increases with pressure up to 50-60 GPa where all Fe{sup 3+} in the B site becomes LS, while Fe{sup 3+} in the A site remains HS to at least 136 GPa. Fe{sup 3+} makes Pv more compressible than Mg-endmember below 50 GPa because of the gradual spin transition in the B site together with lattice compression. The completion of the spin transition at 50-60 GPa increases bulk modulus with no associated change in density. This elasticity change can be a useful seismic probe for investigating compositional heterogeneities associated with Fe{sup 3+}.

43 PARTICLE ACCELERATORS↗

DAC Measurement of High-Pressure Yield Strength of Vanadium using In-Situ Thickness Determination

The pressure-dependence of the quasi-static yield strength of vanadium in polycrystalline foils and powders has been measured up to 80 GPa at room temperature using an implementation of a non-hydrostatic diamond anvil cell technique [C. Meade and R. Jeanloz, J. Geophys. Res. 93, 3261 (1988)]. A new feature of this work is the use of an in-situ determination of the sample thickness. Following an initial increase in the strength with pressure, a decrease in the strength of vanadium was observed beginning at 40-50 GPa. We have measured the yield strength of vanadium up to 80 GPa under nonhydrostatic conditions. In this study, we used x-ray diffraction and absorption techniques to make in-situ measurements of the pressure gradient and the sample thickness. These measurements were used to evaluate the pressure-dependence of the material strength. We observed a decease in the yield strength of vanadium over the pressure range of 40-50 GPa. We propose that this change in the yieldstrength pressure-dependence is an indicator of the phase transition from bcc to rhombohedral.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

New Experimental Method for In Situ Determination of Material Textures at Simultaneous High-Pressure and -Temperature by Means of Radial Diffraction in the Diamond Anvil Cell.

We introduce the design and capabilities of a new resistive heated diamond anvil cell that can be used for side diffraction at simultaneous high-pressure and -temperature. The device can be used to study lattice-preferred orientations in polycrystalline samples up to temperatures of 1100 K and pressures of 36 GPa. Capabilities of the instrument are demonstrated with preliminary results on the development of textures in the BCC, FCC and HCP polymorphs of iron during a non-hydrostatic compression experiment at simultaneous high-pressure and -temperature.

36 MATERIALS SCIENCE↗

Static Material Strength Determined Using a DAC

By measuring sample thickness and pressure gradient using x-ray absorption and x-ray diffraction, respectively, the accurate static yield strengths of Ta and Fe were determined at high pressure. This improved method has several advantages over other similar methods to quantitatively determine static material strength.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗