Engineering topics

Cunningham, A. M., Jr.

Publications and source records attributed to Cunningham, A. M., Jr..

At least 19 records

NASA NTRS1986

Vortex flow hysteresis

An experimental study was conducted to quantify the hysteresis associated with various vortex flow transition points and to determine the effect of planform geometry. The transition points observed consisted of the appearance (or disappearance) of trailing edge vortex burst and the transition to (or from) flat plate or totally separated flows. Flow visualization with smoke injected into the vortices was used to identify the transitions on a series of semi-span models tested in a low speed tunnel. The planforms tested included simple deltas (55 deg to 80 deg sweep), cranked wings with varying tip panel sweep and dihedral, and a straked wing. High speed movies at 1000 frames per second were made of the vortex flow visualization in order to better understand the dynamics of vortex flow, burst and transition.

Cunningham, A. M., Jr.↗

NASA NTRS1980

Interfering surfaces in subsonic, transonic, and supersonic flow

Computer program provides analysis method based on kernel-function technique that uses assumed pressure functions with unknown coefficients. With technique, generalized forces are calculated in unsteady flow, and pressure distributions are obtained in steady and unsteady flow.

Cunningham, A. M., Jr.↗

NASA NTRS1978

A method for predicting full scale buffet response with rigid wind tunnel model fluctuating pressure data. Volume 1: Prediction method development and assessment

The method requires unsteady aerodynamic forces, natural airplane modes, and the measured pressure data as input. A gust response computer program is used to calculate buffet response due to the forcing function posed by the measured pressure data. By calculating both symmetric and antisymmetric solutions, upper and lower bounds on full-scale buffet response are formed. Comparisons of predictions with flight test results are made and the effects of horizontal tail loads and static aeroelasticity are shown. Discussions are also presented on the effects of primary wing torsion modes, chordwise and spanwise phase angles, and altitude.

Cunningham, A. M., Jr.↗

NASA NTRS1978

A method for predicting full scale buffet response with rigid wind tunnel model fluctuating pressure data. Volume 2: Power spectral densities for method assessment

The predicted upper and lower bounds power spectra for all of the cases and response items given in Volume 1 are plotted. The flight test power spectra are shown on each prediction plot for the nominal value of angle of attack that most closely agrees with the flexible angle for the prediction. The flight test and prediction conditions are given in tabular form for all cases considered.

Cunningham, A. M., Jr.↗

NASA NTRS1978

An investigation of wing buffeting response at subsonic and transonic speeds: Phase 1: F-111A flight data analysis. Volume 1: Summary of technical approach, results and conclusions

The structural response to aerodynamic buffet during moderate to high-g maneuvers at subsonic and transonic speeds was investigated. The investigation is reported in three volumes. This volume presents a summary of the investigation with a complete description of the technical approach, description of the aircraft, its instrumentation, the data reduction procedures, results and conclusion.

Benepe, D. B.↗

NASA NTRS1978

An investigation of wing buffeting response at subsonic and transonic speeds. Phase 1: F-111A flight data analysis. Volume 2: Plotted power spectra

Volume 2 of this three volume report is presented. This volume presents plotted variations of power spectral density data with frequency for each structural response item for each data sampled and analyzed during the course of the investigation. Some of the information contained in Volume 1 are repeated to allow the reader to identify the specific conditions appropriate to each plot presented and to interpret the data.

Benepe, D. B.↗

NASA NTRS1978

An investigation of wing buffeting response at subsonic and transonic speeds. Phase 1: F-111A flight data analysis. Volume 3: Tabulated power spectra

Volume 3 of this three volume report is presented. This volume presents power spectral density in tabular form for the convenience of those who might wish to perform additional analysis. Some of the information contained in Volume 1 is again repeated (as in volume 2) in this volume to allow the reader to identify the specific conditions appropriate to each tabular listing and for further analysis.

Benepe, D. B.↗

NASA NTRS1978

An investigation of wing buffeting response at subsonic and transonic speeds. Phase 2: F-111A flight data analysis. Volume 1: Summary of technical approach, results and conclusions

A detailed investigation of the flight buffeting response of the F-111A was performed in two phases. In Phase 1 stochastic analysis techniques were applied to wing and fuselage responses for maneuvers flown at subsonic speeds and wing leading edge sweep of 26 degrees. Power spectra and rms values were obtained. This report gives results of Phase 2 where the analyses were extended to include maneuvers flown at wing leading edge sweep values of 50 and 75.5 degrees at subsonic and supersonic speeds and the responses examined were expanded to include vertical shear, bending moment, and hingeline torque of the left and right horizontal tails. Power spectra, response time histories, variations of rms response with angle of attack and effects of wing sweep and Mach number are presented and discussed. Some Phase 1 results are given for comparison purposes.

Benepe, D. B.↗

NASA NTRS1978

An investigation of wing buffeting response at subsonic and transonic speeds. Phase 2: F-111A flight data analysis. Volume 2: Plotted power spectra

Plotted power spectra for all of the flight points examined during the Phase 2 flight data analysis are presented. Detailed descriptions of the aircraft, the flight instrumentation and the analysis techniques are given. Measured and calculated vibration mode frequencies are also presented to assist in further interpretation of the PSD data.

Benepe, D. B.↗

NASA NTRS1978

An investigation of wing buffeting response at subsonic and transonic speeds. Phase 2: F-111A flight data analysis. Volume 3: Tabulated power spectra

Power spectral density (PSD) data for all of the flight points examined during the Phase 2 flight data analysis are presented in tabular form. Detailed descriptions of the aircraft, the flight instrumentation and the analysis techniques are given. Measured and calculated vibration mode frequencies are also presented to assist in further interpretation of the PSD data.

Benepe, D. B.↗

NASA NTRS1976

A steady and oscillatory kernel function method for interfering surfaces in subsonic, transonic and supersonic flow

The theory, results and user instructions for an aerodynamic computer program are presented. The theory is based on linear lifting surface theory, and the method is the kernel function. The program is applicable to multiple interfering surfaces which may be coplanar or noncoplanar. Local linearization was used to treat nonuniform flow problems without shocks. For cases with imbedded shocks, the appropriate boundary conditions were added to account for the flow discontinuities. The data describing nonuniform flow fields must be input from some other source such as an experiment or a finite difference solution. The results are in the form of small linear perturbations about nonlinear flow fields. The method was applied to a wide variety of problems for which it is demonstrated to be significantly superior to the uniform flow method. Program user instructions are given for easy access.

Cunningham, A. M., Jr.↗

NASA NTRS1976

The calculation of steady non-linear transonic flow over finite wings with linear theory aerodynamics

The feasibility of calculating steady mean flow solutions for nonlinear transonic flow over finite wings with a linear theory aerodynamic computer program is studied. The methodology is based on independent solutions for upper and lower surface pressures that are coupled through the external flow fields. Two approaches for coupling the solutions are investigated which include the diaphragm and the edge singularity method. The final method is a combination of both where a line source along the wing leading edge is used to account for blunt nose airfoil effects; and the upper and lower surface flow fields are coupled through a diaphragm in the plane of the wing. An iterative solution is used to arrive at the nonuniform flow solution for both nonlifting and lifting cases. Final results for a swept tapered wing in subcritical flow show that the method converges in three iterations and gives excellent agreement with experiment at alpha = 0 deg and 2 deg. Recommendations are made for development of a procedure for routine application.

Cunningham, A. M., Jr.↗

NASA NTRS1975

Development and evaluation of a new method for predicting aircraft buffet response

The buffet prediction method uses rigid wind tunnel model fluctuating pressure data to form a buffet forcing function. The response is then calculated with a mathematical dynamic model of the airplane developed for gust response analysis. By including the extremes of phasing and contribution of symmetric and antisymmetric airplane responses, the upper and lower bounds are established for buffet response. F-111A flight test data show good agreement with predicted bounds for a variety of flight conditions.

Cunningham, A. M., Jr.↗

NASA NTRS1975

Further developments in the prediction of oscillatory aerodynamics in mixed transonic flow

This paper presents improvements made to the oscillatory transonic aerodynamic kernel function method given in AIAA Paper No. 74-359. The improved method is fully developed for flows with continuously varying local Mach number and oscillating normal shocks. The boundary conditions developed for oscillating shocks require that a line doublet be added at the foot of the shock which represents the loads induced by shock movement. Numerical results show good agreement with experiment and significant deviation from linear aerodynamic theory. The method is also used to predict wind-tunnel wall interference effects.-

Cunningham, A. M., Jr.↗

NASA NTRS1975

Update on an investigation of flight buffeting of a variable-sweep aircraft

A detailed investigation of flight buffeting response of an F-111A aircraft was performed. AIAA Paper No. 74-358 presented results of an initial study of wing and fuselage responses measured at subsonic speeds and wing leading-edge sweep of 26 degrees. The present paper gives additional results for wing sweeps of 26, 50 and 72.5 degrees at Mach numbers up to 1.2 including horizontal tail responses. Power spectra, response time histories, variations of rms response with angle of attack, and effects of Mach number and wing sweep angle are discussed.

Benepe, D. B.↗

NASA NTRS1974

Oscillatory supersonic kernel function method for interfering surfaces

In the method presented in this paper, a collocation technique is used with the nonplanar supersonic kernel function to solve multiple lifting surface problems with interference in steady or oscillatory flow. The pressure functions used are based on conical flow theory solutions and provide faster solution convergence than is possible with conventional functions. In the application of the nonplanar supersonic kernel function, an improper integral of a 3/2 power singularity along the Mach hyperbola is described and treated. The method is compared with other theories and experiment for two wing-tail configurations in steady and oscillatory flow.

Cunningham, A. M., Jr.↗

NASA NTRS1974

A detailed investigation of flight buffeting response at subsonic and transonic speeds

The structural response to aerodynamic buffeting during moderate-to-high-g maneuvers was investigated. Dynamic response data measured during a flight loads program were analyzed to obtain power spectra and rms values of response for 19 sensors mounted on the test aircraft. In this paper, peaks in the power spectra of accelerations measured at the wing tips, center of gravity and pilot's seat, and wing vertical shear, bending moment and torsional moments are correlated with natural vibration modes. The amplitudes of response are compared to show effects of angle of attack, sensor type and location, Mach number, and altitude.

Benepe, D. B.↗

NASA NTRS1974

An oscillatory kernel function method for lifting surfaces in mixed transonic flow

A study was conducted on the use of combined subsonic and supersonic linear theory to obtain economical and yet realistic solutions to unsteady transonic flow problems. With some modification, existing linear theory methods were combined into a single computer program. The method was applied to problems for which measured steady Mach number distributions and unsteady pressure distributions were available. By comparing theory and experiment, the transonic method showed a significant improvement over uniform flow methods. The results also indicated that more exact local Mach number effects and normal shock boundary conditions on the perturbation potential were needed. The validity of these improvements was demonstrated by application to steady flow.

Cunningham, A. M., Jr.↗