Non-Deterministic, Non-Traditional Methods (NDNTM)
The review effort identified research opportunities related to the use of nondeterministic, nontraditional methods to support aerospace design. The scope of the study was restricted to structural design rather than other areas such as control system design. Thus, the observations and conclusions are limited by that scope. The review identified a number of key results. The results include the potential for NASA/AF collaboration in the area of a design environment for advanced space access vehicles. The following key points set the context and delineate the key results. The Principal Investigator's (PI's) context for this study derived from participation as a Panel Member in the Air Force Scientific Advisory Board (AF/SAB) Summer Study Panel on 'Whither Hypersonics?' A key message from the Summer Study effort was a perceived need for a national program for a space access vehicle whose operating characteristics of cost, availability, deployability, and reliability most closely match the NASA 3rd Generation Reusable Launch Vehicle (RLV). The Panel urged the AF to make a significant joint commitment to such a program just as soon as the AF defined specific requirements for space access consistent with the AF Aerospace Vision 2020. The review brought home a concurrent need for a national vehicle design environment. Engineering design system technology is at a time point from which a revolution as significant as that brought about by the finite element method is possible, this one focusing on information integration on a scale that far surpasses current design environments. The study therefore fully supported the concept, if not some of the details of the Intelligent Synthesis Environment (ISE). It became abundantly clear during this study that the government (AF, NASA) and industry are not moving in the same direction in this regard, in fact each is moving in its own direction. NASA/ISE is not yet in an effective leadership position in this regard. However, NASA does have complementary software interoperability efforts that should be a part of any major ISE program. Software standards that assure interoperability of data systems and modeling representations are enabling for the proposed research advocated herein and should be a major element in the ISE initiative. The international standard for data interchange is known by the acronym 'STEP.' The NASA participation and lead for that effort is at the Goddard Space Flight Center. NASA/GRC is leading an effort to define CAD geometry standards through the Object Management Group (OMG). To enable the design environment so necessary to the above national vision for a unique space vehicle will require an integrating software environment with interoperability standards that allow the development and widespread deployment of tools and toolsets, rather than traditional "shrink-wrapped" software used by engineers today.